潜油电泵易损零部件失效分析方法

通过对大庆油田近5 a潜油电泵易损零部件的数据统计,应用可靠性分析理论和方法研究了易损零部件的失效规律,得出4大部件的故障率占整个机组系统的91.7%,其可靠度由小到大的次序为电机、保护器、电泵和分离器。在这4大部件中,可靠度较低的零件主要有泵轴、叶导轮、扶正轴承、胶囊和保护器轴,其中泵轴、叶导轮、扶正轴承的主要失效模式是磨损,连接螺栓的主要失效模式是断裂失效。     

达县广电城域网运行状况及故障分析

对达县广电城域网运行状况进行了检测，认为不能满足用户上网需要的原因除了网内病毒感染之外，设备与设备之间链路层协商及连接线出现故障。改进措施主要有两点：解决NE08E与S8505的连接问题，解决S8505上的DHCP服务器不能分配IP地址问题。     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

油田采出水的高温水解-好氧处理工艺研究

根据油田采出水的水质特征，采用厌氧(水解)-好氧(接触氧化)处理工艺。实验表明，虽然油田采出水的BOD5／CODCr，较低，属于难生物降解废水，但是当温度为50～60℃时，选择厌氧停留时间为6h，好氧停留时间为3．5h，气水比为10～20，可使其出水的CODCr稳定在120mg／L左右。如果排除Cl^-产生的影响，CODCr，约为60～70mg／L，达到GB8978-1996一级排放标准。     

Uncertainty of Predictions of Embankment Dam Breach Parameters

Risk assessment studies considering the failure of embankment dams often require the prediction of basic geometric and temporal parameters of a breach, or the estimation of peak breach outflows. Many of the relations most commonly used to make these predictions were developed from statistical analyses of data collected from historic dam failures. The prediction uncertainties of these methods are widely recognized to be very large, but have never been specifically quantified. This paper presents an analysis of the uncertainty of many of these breach parameter and peak flow prediction methods. Application of the methods and the uncertainty analysis are illustrated through a case study of a risk assessment recently performed by the Bureau of Reclamation for a large embankment dam in North Dakota.     

强度储备法在飞来峡土坝稳定性分析中的应用

强度储备法抓住影响坝体稳定因素中最关键的强度指标，通过研究不同强度参数所对应的破坏区域的演变关系，分析坝体的稳定性和潜存的破坏机理，在混凝土坝和岩体结构的稳定分析中得到了普遍应用。但将强度储备法应用于土坝稳定性分析中属首次，以飞来峡水利枢纽土坝为例，采用二维有限元强度储备法对其稳定安全系数进行了计算分析，研究了边坡的失稳破坏机理，对安全性进行了评价，为运行管理提出了一些有益的参考意见。     

Prediction of spectral reflectance factor distribution of automotive paint finishes

It is necessary to determine the accurate reflectance of painted surfaces for the review of paint finishes by computer graphics (CG) before actual painting of the exterior color of automobiles, and for quality control during production and inspection processes. We have optimized a method for measuring reflectance by using a statistical technique. We have found that the reflectance of a painted surface is best measured at an incident angle of 60° and at five aspecular angles of 10°, 18°, 28°, 40°, and 90°. Our method makes it possible to accurately reproduce reflection characteristics of paint finishes containing special flake pigments, such as pearl mica. Also it was proved that our method can apply not only to solid and metallic coatings but to all painted surfaces. © 2005 Wiley Periodicals, Inc. Col Res Appl, 30, 275–282, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/col.20125     

通用的自然语言词法分析机制

本文提出了一种通用的自然语言词法分析技术,其处理机构不仅可以独立于具体自然语言,而且又具有适合于未来智能计算机直接处理的规则形式和实现过程.文中还详细讨论了独立于自然语言的词法分析技术,以及我们在IMT/EC系统中实现的词法分析机制的工作原理.     

聚氨酯/聚(甲基丙烯酸甲酯-甲基丙烯酸丁酯)互穿聚合物网络聚合物的阻尼性能

采用本体聚合法合成出一系列阻尼性能良好的聚氨酯/聚(甲基丙烯酸甲酯-甲基丙烯酸丁酯)(PU/P(MMA-BMA))互穿聚合物网络(IPN)聚合物,通过动态力学分析方法表征了PU/P(MMA-BMA)IPN聚合物的阻尼性能。探讨了加入催化剂、高温后处理、交联剂用量及PU与P(MMA-BMA)的质量比对PU/P(MMA-BMA)IPN聚合物阻尼性能的影响。实验结果表明,经高温后处理后,以二月桂酸二丁基锡为催化剂、交联剂二乙烯基苯用量(占MMA和BMA的摩尔分数)为1.5%、PU与P(MMA-BMA)的质量比接近1或小于1时,PU/P(MMA-BMA)IPN聚合物具有良好的阻尼性能。     

控制CCL产量的几点分析

研究了如何在不进行设备改造的情况下,提高CCL产量的方法,指出了从四大工序入手是解决问题的关键。