P_2O_5填充的PVDF复合聚合物导电膜的研制与性能研究

以聚偏氟乙烯为基质,加入适量的P2O5,制备了P2O5填充的PVDF复合聚合物质子导电膜,采用交流阻抗谱的方法研究了P2O5的质量分数不同的复合膜的导电性能及相对湿度对电导率的影响.结果表明,该电解质的室温电导率达到10-2 S·cm-1,相对湿度在20%～90%范围内,对电解质的导电性影响不大.     

碳纤维镀镍

碳纤维是一种新型的高强度、高模量材料,具有良好的导电能力.以镀镍碳纤维增强的复合材料具有高的比强度、比模量、比刚度和良好的高温性能及尺寸稳定性.本文介绍了碳纤维表面化学镀镍及电镀镍的原理和工艺流程,其中镀前预处理对整个施镀过程至关重要.化学镀镍除Ni-P体系外还有Ni-B体系.     

SHS结合热压制备TiC-Al2O3/Fe-Al复合材料

以天然钛铁矿、铝粉和石墨为主要原料,采用自蔓延高温合成技术、铝热还原法并结合热压烧结技术,制备出TiC—Al2O3／Fe—Al复合材料．研究表明：预热时间少于120s时,预热时间越长,反应燃烧波速度越大,当预热时间继续增大,对反应燃烧波速度的影响不再显著;加入添加剂Y2O3为0．2％时,金属相较均匀地弥散分布在陶瓷颗粒周围．晶粒尺寸约为2～3μm,复合材料的相对密度达到94％,抗弯强度和硬度分别为599．29MPa、83．7HRA．     

C/Cu(Fe)复合材料制备工艺及性能研究

利用三步电沉积法制备C／Cu（Fe）复合材料预制丝，将预制丝缠绕成毛坯，采用真空热压法制备C／Cu（Fe）复合材料．研究表明，真空热压工艺对复合材料力学性能有很大影响，通过力学性能试验和对拉伸断口形貌的分析，得出了制备C／Cu（Fe）复合材料的最佳工艺．     

The growth of γ-LiAlO2 layer with a highly-preferred orientation on (0001) sapphire

Using vapor transport equilibration (VTE) technique we succeeded in the fabrication of single-phase γ-LiAlO2 layer on (0001) sapphire substrate. X-ray diffraction indicated that the as-fabricated layer was highly textured with [100] orientation at proper VTE treatment temperature range from 1050℃ to 1100℃. The main factors affecting the quality of the γ-LiAlO2 layer were investigated by SEM and transmission spectra. These results reveal the possibility of fabricating γ-LiAlO2 (100)// sapphire (0001) composite substrate for GaN-based epitaxial film by VTE.     

陶瓷基复合材料伪半固态触变成形及其在卫星角框件中的应用

提出了陶瓷基复合材料伪半固态成形工艺,并应用该工艺制备了30%(体积分数)Alp/SiCp复合材料卫星角框件.通过金相分析、拉伸等实验方法验证该工艺的可行性.结果表明,该工艺成形的零件微观组织比较均匀;硬度较高,HV可达到6.43GPa;应变(ε)约为0.5%;抗拉强度(σt)约为300MPa.     

Micromechanical Modeling of the Effective Viscoelastic Properties of Inhomogeneous Materials Using Fraction-exponential Operators

A new analytical approach for’ micromechanical modeling of the effective viscoelastic behavior of a’ composite material is presented. Fractionexponential operators are. used to describe the viscoelastic properties of the constituents. To construct the corresponding elastic solution, effective field method is used. Effective viscoelastic operators are obtained from the Volter ra’s elasticity-viscoelasticity correspondence principle. Incompatible deformation that often occurs during the manufacturiig process is taken intp account. All the formulas are obtained in explicit ready-to-use form.     

Starting solutions for some unsteady unidirectional flows of a second grade fluid

Exact solutions corresponding to the motions of a second grade fluid, due to the cosine and sine oscillations of an infinite flat plate as well as those induced by an oscillating pressure gradient are determined by means of the Fourier sine transforms. These solutions, presented as sum of the steady-state and transient solutions, satisfy both the governing equations and all associate initial and boundary conditions. In the special case when α₁ → 0, they reduce to those for a Navier-Stokes fluid.     

SiO2对金属锂盐聚合物电解质导电作用的影响

采用溶液浇注法制备了PEO基聚合物电解质,测定了该类电解质的电导率,并研究了温度、SiO2的颗粒度及表面性能对聚环氧乙烯/高氯酸锂(PEO/LiClO4)聚合物电解质体系电导率的影响.结果表明PEO-LiClO4-10%SiO2复合型聚合物电解质的室温电导率达到了1.033×10-4S/cm,同时对该电解质进行了差热分析,发现加入SiO2后,PEO/LiClO4体系熔融温度降低,非晶相含量增加,有利于提高离子电导率.     

飞轮贮能电池的发展与应用

介绍了飞轮贮能电池作为一种新概念电池所具有的优点：比能量、比功率大，寿命长，无二次污染；概括了飞轮储能电池所涉及的相关技术领域；对国内外飞轮储能技术的发展现状、主要应用领域和发展趋向进行了详细的论述。