对硝基氯苯结晶工艺的改进

分析了对硝基氯苯结晶的规律，总结出了测准进料凝固点及进料凝固点配水降温的操作经验，取得了较好效果。     

用参数泵分步结晶制取精萘的新工艺及放大

采用参数泵分步结晶工艺，开发了直立弹状流气泡管结晶器，由工业萘提纯制取精萘。实验室研究和放大试验的研究表明，产品纯度大于９９％，收率大于９２．５％。弹状气泡强化了传热和传质过程，流体的均布是放大过程的关键。     

New strategies for separations through reactions

Separations through reactions can provide reliable and economically viable alternatives to established methods of separation, particularly for close boiling substances. New strategies in ‘Dissociation Extraction’ and ‘Dissociation Extractive Crystallization’ for separation of close boiling acidic/basic mixtures have been highlighted. Separations with aqueous solutions of hydrotrope and aqueous micellar solutions have been brought out. Separations by membranes with facilitated transport is potentially attractive. This paper is dedicated to Dr L K Doraiswamy on his sixtieth birthday.     

热镀锌渣真空蒸馏回收锌

在钢件热镀锌过程中，产出约占锌总量１０％的热镀锌渣，渣中含锌和少量铁，铅，铜，铝等杂质。用直空蒸馏方法从热镀锌渣中提取锌；具空度１．３３×１０＾２－１．３３×１０＾３Ｐａ，温度９００℃，作业时间１１ｈ／炉，电耗约２０００度／ｔ锌，试验表明，锌的直收离可达８４％，为热镀锌渣中锌的回收提供了一英经济而合理的方法。     

K_2O－B_2O_3－SiO_2玻璃成分对析晶性能的影响

本文利用ＤＴＡ、ＸＲＤ、ＴＥＭ、ＳＥＭ等技术研究了三种Ｋ２Ｏ－Ｂ２Ｏ３－ＳｉＯ２玻璃的析晶性能。结果表明，Ｋ２Ｏ－Ｂ２Ｏ３－ＳｉＯ２玻璃的析晶由分相引起，分相和析晶能力受成分影响较大。随Ｂ２Ｏ３和Ｋ２Ｏ含量增多及Ｋ２Ｏ／Ｂ２Ｏ３比值的降低，析晶加强。析晶中主晶相类别尚未查清，次晶相确定为α－方石英。     

High concentration erbium doping of silicon-rich SiO2 thin films on silicon

In this work, high concentration erbium doping in silicon-rich SiO₂ thin films is demonstrated. Si plus Er dual-implanted thermal SiO₂ thin films on Si substrates have been fabricated by using a new method, the metal vapor vacuum arc ion source implantation with relatively low ion energy, strong flux and very high dose. X-Ray photoelectron spectroscopy measurement shows that very high Er concentrations on the surfaces of the samples, corresponding to 10 at.% or the doping level of 10²¹ atoms cm⁻³, are achieved. This value is much higher than that obtained by using other fabrication methods such as the high-energy ion implantation and molecular beam epitaxy. Reflective high-energy electron diffraction, atomic force microscopy and cross-section high-resolution transmission electron microscopy observations show that the excess Si atoms in SiO₂ matrix accumulate to form Si clusters and then crystallize gradually into Si nanoparticles embedded in SiO₂ films during dual-ion implantation followed by rapid thermal annealing. Er segregation and precipitates are not formed. Photoluminescence at the wavelength of 1.54 μm exhibits very weak temperature dependence due to the introduction of Si nanocrystals into the SiO₂ matrix. The 1.54-μm light emission signals from annealed samples decrease by less than a factor of 2 when the measuring temperature increases from 77 K to room temperature.     

第二套常减压装置低温热回收技术的应用

常减压装置低温余热较多.利用较少,造成热量损失。利用初顶油气、稳定石脑油等低温余热加热除盐水建立热水站,在节汽、节电等方面取得了较好的效果。     

诱导结晶条件下硅酸盐水泥熟料形成动力学的研究

根据诱导结晶的原理，我们提出了用已烧好的同类优质熟料作为晶种，诱导水泥烧成过程中的矿物形成。用掺与不掺对比的方法，利用现代物理、化学手段进行了研究。结果表明：明显提高了生料的易烧性；使ｆ－ＣａＯ明显下降；水泥熟料形成的活化能降低；刚分解的ＣａＯ在晶种表面富集；加快了各个阶段的固相反应；加快了熟料矿物形民；熟料矿物质量有所提高；并使ｆ－ＣａＯ的结构特征上发生了易于消解的变化。     

机械合金化Fe─B非晶合金及纳米合金的形成

在适当条件下机械合金化可以形成急冷法难以得到的单一Ｆｅ６０Ｂ４０非晶合金，而在其他成分内形成亚稳纳米合金。在众多的球磨条件中，球磨机的转速是控制合金化的重要因素，空气中的氧对小颗粒界面产生了强烈的污染作用，从而抑制了原子的相互扩散，难以形成单一的非晶产物。不同球磨条件下的产物含有的非晶相的晶化温度比单一非晶相合金的晶化温度稍高，并且与球磨条件以及成分的关系不大。