底水油藏射孔优化设计

为了优化底水油藏的生产参数，研究了不同产量时射孔长度的优化方法。采用球面流和径向流相结合的模型推导了临界产量和无水采油量的计算公式，分别以临界产量和无水采油量为标准，对胜利油田桩西区块底水油藏上6口油井的射孔长度进行了优化设计，优化结果表明，对于底水油藏应首先按照临界产量对射孔长度进行优化设计，如果得到的最大临界产量不符合实际生产的要求，就应按照无水采油量进行射孔优化设计。研究表明，当油井产量超过临界产量后，以临界产量为标准得到的优化射孔长度会减小油井的无水采油量。     

带纵向槽筒形件拉深方法的研究

针对传境拉深带纵向槽筒形件的方法的缺点,采用一次拉深成形的方法,并通过试验和计算获得毛坯的形状和尺寸。     

Split and collectorless flotation to medium coking coal fines for multi-product zero waste concept

The medium coking coal fines of − 0.5 mm from Jharia coal field were taken for this investigation. The release analysis of the composite coal reveals that yield is very low at 10.0% ash, about 25% at 14% ash and 50% at 17% ash level. The low yield is caused by the presence of high ash finer fraction. The size-wise ash analysis of − 0.5 mm coal indicated that − 0.5 + 0.15 mm fraction contains less ash than − 0.15 mm fraction. Thus, the composite feed was split into − 0.5 + 0.15 mm and − 0.15 mm fractions and subjected to flotation separately. The low ash bearing fraction (− 0.5 + 0.15 mm) was subjected to two stages collectorless flotation to achieve the concentrate with 10% ash. The cleaner concentrate (18.9%) with 10% ash was recovered which has an application in metallurgical industries. The concentrate of 30.2% yield with 12.5% ash could be achieved in one stage collectorless flotation which is suitable for use in coke making as sweetener. As the − 0.15 mm fraction contains relatively high ash, collector aided flotation using sodium silicate was performed to get a concentrate of 23.6% yield with about 17% ash. The blending of this product with cleaner tail obtained from − 0.5 + 0.15 mm produces about 35.0% yield with 17% ash and that can be utilized for coke making. The reject from the two fractions can be used for conventional thermal power plant or cement industries using a 23.5% ash after one stage collector aided flotation and the final tailings produced content ash of 61.6% can be used for fluidization combustion bed (FBC). This eventually leads to complete utilization of coal.     

Egg white powder in extruded fish crackers

Four levels of egg white powder (EWP), 0, 1.5, 3.0 and 4.5%, were added to fisfc cracker formulation consisting of tapioca starch, fish paste, and water. the mixture was extruded through a single screw extruder, and the extrudate was cut, dried, heated in a microwave, and the degrees of expansion, bulk density, colour and protein content were measured.
The addition of 1.5 and 3.0% EWP had no significant effect ( P < 0.01) on diametral and longitudinal expansion, however, 4.5% EWP significantly ( P < 0.01) reduced them. Bulk density and protein content of the final product increased as the percentage of EWP increased in the formulation. the total colour difference measurement showed a significant increase ( P < 0.01) in brown colouration at 4.5% EWP.     

运用韦柏函数分析发动机燃烧过程时若干问题的探讨

探讨了韦柏函数的内涵及其在实际应用中的若干问题；应用双韦柏函数对涡流室式柴油机的燃烧过程进行分析，加深了对分隔室式发动机燃烧过程的认识．     

磨机大齿轮对缝处产生张口的初探

针对大中型磨机大齿轮对缝处在使用中会产生张口现象而降低其使用寿命的问题,从分析产生张口的原因入手,通过理论计算,提出设计的配合间隙,并指出在安装与使用中应注意的问题.     

非正态随机变量的可靠性评价方法研究

不确定性及可靠性分析技术已广泛应用到水利及土木系统工程分析中，可靠性计算的核心之一是对随机变量进行正态转换。文中旨在对土木工程系统不确定性及可靠性分析中有着潜在应用前景的非正态随机变量的多项式正态转换方法进行研究。通过在各种条件下非正态随机变量的正态多项式转换成果之评价，发现在水利及土木工程系统可靠性分析中常用的许多分布可以保留其自身的比较好的特征。     

硝酸铵的膨化机理研究

膨化硝酸铵是一种自敏化改性硝酸铵,由硝酸铵溶液在专用表面活性剂作用下,经真空强制析晶工艺制得.文中研究了膨化硝酸铵制备的膨化过程和专用表面活性剂的作用,结果表明:在真空和表面活性剂作用下,硝酸铵溶液由不饱和状态至饱和状态,进而达到过饱和状态,最终导致硝酸铵的快速结晶和体系的膨胀.在真空干燥过程中,形成中心空穴、微细孔道和裂缝,它们使膨化硝酸铵的起爆感度提高;专用表面活性剂具有降低硝酸铵溶液表面张力、发泡剂和加快结晶成核的作用.     

并购是手段,效益是目的,整合是保障--对中国啤酒工业规模扩张潮的思考

近年来啤酒工业掀起并购扩张高潮，虽然规模扩张，但是却没有带来经济效益的同步增长。其主要原因是：扩张后生产能力未能充分发挥；价格战的扼制；没有充分的资金、人力对并购企业进行内部整合。而内部整合重于规模扩张建设，扩张的目的不是简单做大，而是要做强。有效的整合应做到：（1）具备充足的整合能力。（2）被并购企业积极支持内部整合。（3）加强企业文化整合，使两种企业文化完美融合，并形成一种新的文化。（君健）     

关于CEA混凝土膨胀剂的若干技术问题--与游宝坤同志讨论

作者阐述了CEA膨胀剂混凝土的膨胀量较大，干缩小，抗裂性能良好的特性，CEA与粉煤灰掺用提高强度，改善界面过渡层的性质，提高耐久性；CEA混凝土无Ca（OH）2溶出问题。文中列出GBJ119应用技术规范，说明CEA可用于防水工程。