Synergistic Influence of Poly(4-Vinylpyridine) and Potassium Iodide on Inhibition of Corrosion of Mild Steel in 1M HCl

The corrosion and inhibition behavior of mild steel in 1 M HCl in the presence of poly(4-vinylpyridine)(P4VP) and potassium iodide (KI) was investigated using weight loss measurements, potentiodynamic polarization studies and impedance measurements. The inhibition efficiency increased with increasing P4VP concentration. The inhibiting action of P4VP is considerably enhanced by the addition of potassium iodide. The adsorption of this compound either alone or in combination with iodide ions on the metal surface is found to obey Lamgmir's adsorption isotherm. The experimental results suggest that the presence of iodide ions in the solution increases the surface coverage and, therefore, indicate the joint adsorption of P4VP and iodide ions. On the other hand, it was found that the inhibiting effect of P4VP and (P4VP + KI) increased with increasing temperature of the corrosion medium. The presence of these species in the solution decreases the double layer capacitance and increases the charge transfer resistance, both derived from Nyquist plots obtained from a.c. impedance studies. The variation of charge transfer resistance with time suggests that the inhibitive action of (P4VP + KI) depends mainly on the protective inhibitor film formed on the steel surface.     

流动床离子交换工艺在己二酸催化剂回收中的应用

介绍流动床离子交换装置回收催化剂的生产工艺，从交换装置的选择到运行，分析了流动床的优点、影响因素以及生产中应注意的问题和要求。     

甲氧胺盐酸盐的含量测定方法

提出了以酚酞为指示剂，氢氧化钠为滴定剂测定甲氧胺盐酸盐含量的方法。测定了甲氧胺盐酸盐的离解常数Ka，考察了干扰因素对测定的影响。结果表明，干扰物质NH4Cl在样品中的含量小于5％不影响测定。该方法具有简便、快速，准确等特点,测定了数批样品结果较满意。     

Vinyl‐containing silicone resin as the crosslinking agent of heat‐curable silicone rubber

Heat‐curable silicone rubber (HCSR) was prepared by using vinyl‐containing silicone resin (VSR) as the crosslinking agent instead of polyvinylsilicone oil (C gum). Mechanical properties and crosslink density of the vulcanizates were measured. The results indicate that VSR is a good crosslinking agent for HCSR. The tensile strength, tearing strength, elongation at break, and hardness of the vulcanizate can reach 10.2 MPa, 29.1 kN/m, 720%, and 58 SHA, respectively. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 3123–3127, 2002; DOI 10.1002/app.10054     

集成电路密封用高纯邻甲酚醛环氧树脂的制备

ECN树脂中的可水解氯含量是决定树脂质量的—个重要指标。本文研究了反应温度、ECH/OCN配比、反应时间和碱用量等因素的影响,取得了规律性的认识,并获得最佳配方,制备出高纯度的ECN树脂系列产品。     

稀磷酸澄清槽泥浆泵改用单螺杆泵的实践

磷酸生产中输送稀磷酸澄清槽淤渣的泥浆泵，各厂的运行情况都不够理想。介绍了三种类型泥浆泵的运行情况，针对淤渣中会出现块结垢物影响泥浆泵长期运行，在单螺杆泵进料腔内设置破碎送料器后，取得了较理想的效果，从而提高了磷酸装置的运转率和磷得率。     

固体酸催化合成草酸二乙酯的应用研究

以粉煤灰、活化剂、硫酸为主要原料经活化、陈化、浸泡、焙烧等处理制得的固体酸催化剂，应用于草酸二乙酯的合成中取得了良好的催化效果。实验发现，当醇酸摩尔比为3．5、催化剂用量为草酸的5％、反应时间在4h时，酯产率可达81.8％，该催化剂具有贮存稳定性高、可重复使用、制备工艺简单、原料成本低廉等特点，是一种易于工业化应用的环境友好固体酸催化剂。     

聚乙烯醇存在下耐尔蓝－铈钼、钪钼杂多酸体系连续光度测定铈和钪

在聚乙烯醇（ＰＶＡ）存在下，耐尔蓝（ＮＢ）与铈钼、钪钼杂多酸络阴离子形成离子缔合物，其最大吸收均位于５８５ｎｍ，表观摩尔吸光度分别为εｃｗ＝３．５２×１０６和εＳｃ＝３．５９×１０＿５Ｌ·ｍｏｌˉ１·ｃｍˉ１，铈和钪服从比耳定律的浓度范围分别为０～０．８μｇ／２５ｍｌ和０～２．０μｇ／２５ｍｌ，测定极限分别为１．３ｎｇＣｅ／ｍｌ（ｎ＝１０）和３．０ｎｇＳｃ／ｍｌ（ｎ＝７），对于０．０２μｇＣｅ／ｍｌ或０．０４μｇＳｃ／ｍｌ测定的相对标准偏差分别为２．７％（ｎ＝９）和２．８％（ｎ＝１０），离子缔合物的摩尔比分别为Ｃｅ：Ｍｏ：ＮＢ＝１：６：４和Ｓｃ：Ｍｏ：ＮＢ＝１：１２：３。本法用于地质标样分析，结果满意。     

Continual conversion of free fatty acid in rice bran oil to triacylglycerol by immobilized lipase

Rice bran oil containing 30–50% free fatty acid was continually converted to an oil containing more than 75% of triacylglycerol (TG) by means of immobilized lipase. The reaction was carried out at 60°C for 24 h with dehydration and reactant mixing by dry nitrogen flow under a positive nitrogen atmosphere. Enzymatic TG synthesis with evaporation by heating was not suitable because of the increasing peroxide value of the oil. Part of this article was presented at the annual meeting of the Japan Oil Chemists' Society at Sendai, Japan, October, 16, 1990.     

A new class of corrosion inhibitors for waterborne coatings: 4-methyl-γ-oxo-benzene-butanoic acid complexes

Amine and transition metal based complexes with 4-methyl-γ-oxo-benzene-butanoic acid represent a new class of corrosion inhibitors specifically designed for long-term corrosion protection in waterborne coatings. Today, corrosion protection in waterborne technology is typically achieved using traditional anticorrosive pigments initially developed for use in solventborne coatings. Regulations concerning heavy metals and limitations regarding the compatibility and performance of such materials in waterborne coatings have created a need for novel approaches. Mechanistic aspects are discussed for the 4-methyl-γ-oxo-benzene-butanoic complexes based on electrochemical solution experiments (electrochemical impedance spectroscopy (EIS), linear sweep voltammetry (LSV)) and investigations performed on coated substrates. Exposure results underline the high efficiency of such complexes for both long-term corrosion protection and weld seam rust control in waterborne coatings.