Heat Transfer Analysis for Gas-to-Liquids Transportation Through Trans Alaska Pipeline

Gas-to-liquids (GTL) technology involves the conversion of natural gas to liquid hydrocarbons. In this article, theoretical studies have been presented to determine the feasibility of transporting GTL products through the Trans-Alaska Pipeline System (TAPS). To successfully transport GTL through TAPS, heat loss along the route must be carefully determined. This study presents heat transfer and fluid dynamic calculations to evaluate this feasibility. Because of heat loss, the fluid temperature decreases in the direction of flow and this affects the fluid properties, which in turn influence convection coefficient and pumping power requirements. The temperature and heat loss distribution along the pipeline at different locations have been calculated. Fairly good agreement with measured oil temperatures is observed. The powers required to pump crude oil and GTL individually, against various losses have been calculated. Two GTL transportation modes have been considered; one as a pure stream of GTL and the second as a commingled mixture with crude oil. These results show that the pumping power and heat loss for GTL are less than that of the crude oil for the same volumetric flow rate. Therefore, GTL can be transported through TAPS using existing equipment at pump stations.     

Ennoblement of stainless steel in natural seawater – A new explanation

The ennoblement of corrosion potential (E_corr) of passive metal immersed in seawater was investigated with electrochemical technology and epifluorescence microscopy. The in situ observation showed that the bacteria number increased on the metal surface according to an exponential law which was in the same way with the ennoblement of E_corr. At the same time, the anodic polarization current of high‐Mo stainless steel decreased in the initial days. According to the mix‐potential theory and the characteristics of polarization curves of high‐Mo steel in natural seawater, the ennoblement of corrosion potential may be induced by the decrease of the passive current density.     

长距离温泉输水管道设计

福州市首次把城市外围的温泉水引入市区,本文简要介绍长距离温泉输水管道设计中一些做法。     

天然气管网输配气量优化研究

天然气管网系统管理部门为了明确天然气管网的输气能力和提高天然气管网的利用率，需要对天然气管网系统的输配气量进行优化。为此，以天然气管网系统的最大流量为目标函数，同时考虑了管道强度、节点压力和流量限制等约束条件，建立了天然气管网输配气量优化的数学模型。在研究遗传算法和模拟退火算法的基础上，提出了一种由二者结合构成的具有全域搜索、快速收敛和鲁棒性强等特点的混合遗传算法。结合实例，采用这一新算法求解了天然气管网输配气量优化的数学模型。实例优化结果表明，所建立的数学模型和采用的混合遗传算法是可行和有效的，能够对天然气管网系统输配气量的调度运行起到指导作用。     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

输气管道天然气连续取样器的研制及应用

文章针对国内管输天然气气质分析工作中取样环节所存在的问题，结合国外技术发展趋势，全面地介绍了输气管道天然气连续取样器的研制过程。实践证明，该装置较好地解决了天然气密度值偏差问题，满足管输天然气全分析的要求，同时，该装置的推广应用将会提高天然气的计量准确度。     

粘钢技术在输水管竖井加固中的应用

１９７６年汛前发现响水潭水库输水管竖井圆筒底部与闸室连接处的下游出现环形水平裂缝，对此当年曾加固处理。１９８６年复查时，发现竖井原处又出现了类似的环形裂缝，并有新的发展，为确保工程安全，于１９９４年３月再次加固。此次加固采用先止水，后粘钢板的加固方法，收到很好的效果。     

海水介质中高活性镁合金负极的电化学性能

研制了一种新型镁合金负极材料；用电化学方法测定了镁合金负极在人造海水介质中的电化学性能，用浸泡法测定了材料在人造海水介质中的自腐蚀速度，用扫描电子显微镜观察了镁合金腐蚀后的表面形貌，并与AP65合金和纯镁进行了比较。结果表明，新研制的镁合金在人造海水介质中的开路电位增加，自腐蚀速度降低，稳定工作电位提高，电极表面腐蚀均匀，可开发用于高电性能电池的负极材料。