提高润滑油基础油氧化安定性的组合工艺

以生产润滑油基础油的老三套工艺为基础，开发了改善油品氧化安定性的组合工艺。该工艺的主要特点是包括一步络合脱氮过程。实验证明，该组合工艺既可以有效地提高基础油的氧化安定性，又能降低溶剂精制深度，提高基础油收率。     

粒界缓冲型展宽效应对PTC材料温度系数的影响

本文利用相变扩张理论分析了粒界缓冲型展宽效应对BaTiO_3系PTC陶瓷的介电系数及温度系数a_r的影响,指出了晶粒尺寸和温度系数的关系。     

我国炼油技术开发的若干思考与建议

分析了我国炼油工业面临的挑战，世界炼油工业的发展趋势，提出了我国炼油技术开发要围绕符合国情的清洁燃料生产技术，炼油与化工结合的炼油技术，适合现有炼油装置技术改造、提高技术水平，降低加工成本的技术，渣油转化技术，煤制油，天然气制油技术，炼油厂智能化的技术，减少炼油厂烟尘排放的技术等7个方面开展工作的具体建议。     

Drying of Prone to Twist Boards in a Pre-Twisted Position

A method to minimize twist has been investigated; i.e., drying the boards in a pre-twisted position. It has been found that Norway spruce boards can be deformed toward straightness by this method. The force exerted by a board on its holders during drying in a pre-twisted position has been measured. When the variation in torsional stiffness as a function of temperature and moisture content is accounted for, it is found that a creep deformation of the board occurs both during the drying phase and the cooling phase. In addition to mechano-sorptive creep, a deformation released by a change in temperature also seems to occur.     

高能超声处理Al-1Si合金凝固组织分析

采用高能超声处理Al-1Si合金熔体,借助金相显微镜和电子探针进行组织分析,并测定合金的熔化潜热,分析了熔体中超声空化效应和声流效应影响凝固过程的机理。结果表明,试样晶粒平均尺寸由超声处理前的94μm减小到超声处理后的34μm;合金试样的熔化吸热量由263.90J/g降低为159.81J/g,在熔体中施加高能超声显著改善了合金成分的均匀性并细化了晶粒。     

Strengths and ductility of Mo–TiC alloys after secondary recrystallization

A series of Mo–TiC alloys were heated in vacuum at 2473 K for 36 ks. First grain growth behavior was observed using a scanning electron microscope. Then effects of TiC addition on the strengths and ductility at low temperature were discussed from the viewpoints of chemical composition and grain structure.

Materials with TiC additions of not larger than 0.1% demonstrated a single-crystalline grain structure. Both yield and maximum strengths increased by TiC addition and consequently ductility was improved.     

水稻强化栽培下不同氮肥管理对产量与氮素利用的影响

以籼型单季超级杂交稻中浙优1号为材料,研究水稻强化栽培氮肥管理对产量与氮素利用率的影响。结果表明:水稻强化栽培与常规栽培对照比较,增产达11.1%-15.2%,氮肥回收率比对照高5.3%~26.9%,农学利用率比对照高67.2%~92.2%,生理利用率比对照高6.0%~80.5%。因此,在水稻生产上应用水稻强化栽培可以提高氮肥的利用,降低氮肥在环境中积累及对环境造成污染。此外,本文对水稻强化栽培下氮肥管理的高产机理进行了探讨。     

中国石油润滑油基础油生产技术现状及发展

介绍中国石油润滑油基础油生产能力、原油资源及工艺特点，酮苯脱蜡、糠醛精制、白土补充精制、高压加氢基础油生产技术现状。针对加氢法生产的Ⅱ/Ⅲ类润滑油基础油将取代传统工艺生产的I类润滑油基础油的发展趋势，提出利用加氢裂化尾油采用加氢异构脱蜡工艺生产Ⅱ/Ⅲ类润滑油基础油的全加氢工艺，加氢裂化尾油与老三套结合生产HVI高粘度指数基础油，是中国石油润滑油基础油升级换代发展方向。     

AN EXPERIMENTAL INVESTIGATION OF THE GROWTH OF SMALL CORNER FATIGUE CRACKS IN ALUMINIUM 6061-T651

Results of an experimental investigation of the fatigue growth of small corner cracks emanating from small flaws are presented. Growth-arrest behaviour was observed, and increases in crack length during growth periods were of the order of the transverse grain size. For the test material, the corner crack front intersects, on average, only three–six grains in the small crack regime monitored, so only a small number of constrained, interior grains is encountered. It is suggested that the presence of partially constrained surface grains may contribute to the 'anomalous' growth behaviour which has been observed by a number of investigators.
The crack growth histories of the test data presented exhibit considerable scatter. It is shown that a Student's t -test can be used to estimate confidence intervals in order to provide a measure of the observed scatter. The variation in confidence intervals in the transition from small to long fatigue crack growth is discussed.     

莱钢焦化厂精苯生产加热改造方案

莱钢焦化厂以导热油代替蒸汽用于精苯生产及导热油炉工艺，经合理设定各项操作参数，提高了精苯加工能力，解决了蒸汽压力不足影响精苯生产的难题．