解吸塔换热器706C结堵的原因分析及其对环保装置正常运行的影响

本文详细分析了解吸塔换热器结堵的原因和对环保装置正常运行的影响,并针对性地提出了防范和处理措施。     

The effect of nitrogen oxides in air on the performance of proton exchange membrane fuel cell

The effects of NO_x on the performance of proton exchange membrane (PEM) fuel cell were investigated through the introduction of a mixture containing NO and NO₂, in a ratio of 9:1, into the cathode stream of a single PEM fuel cell. The NO_x concentrations used in the experiments were 1480 ppm, 140 ppm and 10 ppm, which cover a range of three orders. The experimental results obtained from the tests of durability, polarization, reversibility and electrochemical impedance spectroscopy (EIS) showed a detrimental effect of NO_x on the cell performance. The electrochemical measurements results suggested that the impacts of NO_x are mainly resulted from the superposition of the oxygen reduction reaction (ORR), NO and HNO₂ oxidation reactions, and the increased cathodic impedance. Complete recovery of the cell performance was reached after operating the cell with clean air and then purging with N₂ for hours.     

Halo effects in grading student projects.

Halo effects in rating specific pieces of work, as in educational grading, have received little attention. Grades awarded by 2 independent graders to undergraduate projects were analyzed with a correlated uniqueness model. Grades showed substantial halo despite being awarded by expert assessors at the time of reading the work. There was greater halo between different grades applying to the same section of the project than between grades applying to different sections. Supervisors who had regular contact with the student whose work they were grading showed no more halo than other graders. More reliable graders showed less within-section halo than graders of lower reliability but equal between-sections halo. The halo effects observed cannot be entirely attributable to a unitary general impression. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Fracture toughness of thermoset composites reinforced by perfectly bonded impenetrable short fibers

The fracture toughness of brittle thermoset resins could be improved significantly by perfectly bonded tough, short fibers through both crack trapping and bridging effects. In this paper, the crack trapping effect was studied through the analysis of the change of strain energy associated with the crack propagation across a regular array of fibers, and the bridging effect was discussed based on the Andersson–Bergkvist model. The fracture resistance increases with the fiber volume fraction, and is independent of the elastic properties of the matrix, the crack length, and the cross-sectional diameter of the fibers.     

Effect of Mineral on Metallurgical Coke Solution Loss Reaction in Blast Furnace

Thecokesolutionlossreactionisoneofthemostimportanteffectsresultingincokepulverizinginblastfurnace .Thefactorswhichaffectreactionincludecokeporestructure ,micro crystalstructureonporewall ,thecontentandconstituentofminer als ,etc .Amongthesefactors ,theconstituentofmineralsisemphasizedallovertheworldinrecentyears .Buttheemphasisofmoststudieswasputontheeffectofalkalimetals (K ,Na)oncokesolutionlossreactionandtheeffectofotherelementswassel domreported[1-5] .Theeffectofthirteenmineralsoncokesolut…     

Effect of strain waveform on creep-fatigue life for Sn–8Zn–3Bi solder

This paper describes the creep‐fatigue life of Sn–8Zn–3Bi under push–pull loading. Creep‐fatigue tests were carried out using Sn–8Zn–3Bi specimens in fast–fast, fast–slow, slow–fast, slow–slow and hold–time strain waveforms. Creep‐fatigue lives in the slow–slow and hold‐time waveforms showed a small reduction from the fast–fast lives but those in the slow–fast and fast–slow waveforms showed a significant reduction from the fast–fast lives. Conventional creep‐fatigue life prediction methods were applied to the experimental data and the applicability of the methods was discussed. Creep‐fatigue characteristics of Sn–8Zn–3Bi were compared with those of Sn–3.5Ag and Sn–37Pb.     

Free-Edge and Ply Cracking Effect in Angle-Ply Laminated Composites Subjected to In-Plane Loads

This paper presents a semianalytical method for the prediction of interlaminar stresses and displacements near the free edges and ply cracks in general angle-ply laminates subjected to biaxial extensions and/or in plane shear deformation. The method is based on a state space representation of the three-dimensional equations of elasticity. Numerical solutions are obtained by using layer refinement in the through thickness direction and Fourier series expansion in the other directions. By this approach, an angle-ply laminate may be composed of an arbitrary number of monoclinic layers and each layer may have different material property and thickness. This method guarantees continuous fields of all interlaminar stresses across interfaces between material layers. Numerical results are compared with those obtained from other methods. It is found that the theory provides a satisfactory approximation to the stress singularities near the free edges and ply cracks. Numerical solutions for antisymmetric laminates under extension and general laminates under shearing are new in the literature and can be used as benchmarks for validating new models.     

利用试井资料评价压裂地质效果

依据裂缝井试井解释理论，利用实测试井资料对压裂地质效果进行了深入剖析。通过部分探井措施后增产效果实例研究，把压裂地质效果分为三种类别；并从地质角度出发，详细分析了优选压裂井层的依据。为油气井合理开发和制定增产措施提供参考依据。     

基于PSR模型的水电工程生态效应评价指标体系构想

从水电工程生态效应评价指标体系研究的意义出发,通过分析水电工程生态效应评价的内涵,确立了评价指标的选取原则,基于压力(Pressure)-状态(State)-响应(Response)概念模型,构建了以科学、实用和可操作为目标的评价指标体系的框架。