Low cost coal-based carbons for combined SO2 and NO removal from exhaust gas

The aim of this paper is to show how a cheap carbonaceous material such as low rank coal-based carbon (or char) can be used in the combined SO₂/NO removal from exhaust gas at the linear gas velocity used in commercial systems (0.12 m s⁻¹). Char is produced from carbonization and optionally activated with steam. This char is used in a first step to abate the SO₂ concentration at the following conditions: 100 °C, space velocity of 3600 h⁻¹, 6% O₂, 10% H₂O, 1000 ppmv SO₂, 1000 ppmv NO and N₂ as remainder. In a second step, when the SO₂ concentration in the flue gas is low, NO is reduced to N₂ and steam at the following experimental conditions: 150 °C, space velocity of 900 h⁻¹, 6% O₂, 10% H₂O, 0-500 ppmv SO₂, 1000 ppmv NO, 1000 ppmv NH₃ and N₂ as remainder.It has been shown that the presence of NO has no effect on SO₂ abatement during the first step of combined SO₂/NO removal system and that low SO₂ inlet concentration has a negligible effect on NO reduction in the second step. Moreover, this char can be thermally regenerated after use for various cycles without loss of activity. On the other hand, this regenerated char shows the highest NO removal activity (compared to parent chars, either carbonized or steam activated) which can be attributed to the activating effect of the sulfuric acid formed during the first step of the combined SO₂/NO removal system.     

降低循环流化床锅炉飞灰含碳量的因素分析

循环流化床锅炉的飞灰含碳量是锅炉燃烧工况好坏的直接反映 ,其对锅炉的热效率的影响是很大的 ,它还直接影响着粉煤灰的综合开发和利用 .在对云天化循环流化床锅炉的生产实验研究中 ,分析了影响循环流化床锅炉飞灰含碳量的各种因素 (床温、煤质煤粒、一次风、二次风、床压和旋风分离器效率等 ) ,通过实验研究找到了降低循环流化床锅炉飞灰含碳量的具体而又行之有效的操作方法 ,以指导实际生产 .     

火焰原子吸收光谱法测定硅粉中的铜

介绍了用火焰原子吸收法测定工业硅粉中微量铜的具体方法和过程，同时也给出了最佳实验条件。实验中采用新的样品处理方法，得到了令人满意的结果。其中样品回收率为99．8％—104．0%，相对标准偏差为0．31％—0.38％。本方法在实际应用过程中，简单、快速、     

Influence of Zn ion implantation on structures and field emission properties of multi-walled carbon nanotube arrays

The structures and field emission properties of multi-walled carbon nanotube arrays implanted with Zn+ by MEVVA ion implanter have been investigated.The results revealed that Zn+implantation induced structural damage and that the top of carbon nanotubes with multi-layered graphite structure were transformed into carbon nanowires with amorphous structure.Meanwhile,C:Zn solid solution was synthesized after Zn+ implantation.The turn-on field and threshold field were 0.80 and 1.31 V/μm,respectively for original...     

Relationship of hydrocarbon and source-rock in Nos.3-5 tectonic belts of the Lenghu area, northern Qaidam Basin

Based on analyses of the components of crude oil hydrocarbons and carbon isotopes, the content of normal alkane de-creased from 49.00% to 20.10% when moving from the No.3 to No.5 tectonic belt of the Lenghu area of the Qaidam Basin, while cycloalkanes increased from 30.00% to 52.20% and aromatic and branch chain alkanes increased gradually as well. The maturity of sterane in crude oil is higher than that of its source-rock, which shows that the hydrocarbons were generated from a deep source-rock of high maturity around the tectonic belts of the Lenghu area. The analysis of the characteristics of carbon isotopes also shows that these isotopes of hydrocarbon compounds in the No.4 and No.5 tectonic belt are apparently heavier than those in the No.3 belt. The results of our research show that the hydrocarbons in the No.3 tectonic belt are mainly from a relatively rich sapropelic substance, while the hydrocarbons in the No.4 and No.5 tectonic belt originated mainly from organic matter of a rela-tively rich humic type substance.     

混合炭黑TST-103在轮胎内层帘布胶中的应用

研究了混合炭黑TST-103在轮胎内层帘布胶中的应用。小配合和车间大料及成品轮胎试验表明，使用8份混合炭黑TST-103，内层帘布胶的工艺性能、物理性能及实际使用性能均与原内层帘布胶相近，而每千克胶料成本降低了0．33元。     

红外吸收法测硅铁中的超低硫

应用高频红外碳硫仪,建立了硅铁合金中超低硫测定方法,对选择适当的测定条件如助熔剂、分析时间等进行了探讨,最佳测定条件:最大工作电流为400～480 mA;载气纯度为99.99%;陶瓷坩埚需经1 100℃灼烧2 h后,可使空白降至最小;硫元素最短分析时间为40 s,比较水平为5.00.     

Calculation of single adsorption isotherms from gravimetrically measured binary gas mixture adsorption isotherms on activated carbon at high pressures

A method is developed for the calculation of single-component adsorption isotherms from gravimetrically measured binary gas mixture adsorption isotherms at high pressures, at two temperatures and for different mole fractions of the gas phase. The adsorption of nitrogen/methane on active carbon Norit R1 is taken as an experimental example.     

不同线密度粘胶原丝及其碳纤维的结构性能对比

用Weibull分析处理 10mm长的 4种不同线密度粘胶原丝和相应碳纤维的单丝断裂强度 ,得到原丝线密度、强度分布和碳纤维强度的对应关系。采用透射电镜 (TEM )和小角X散射 (SAXS)分析粗旦原丝 ,发现孔洞较多 ,并存在大于 70nm的大孔洞。截面和表面照片也揭示出细旦原丝截面相对规整 ,表面较光滑 ,粗旦原丝则反之。结果表明 ,原丝线密度小 ,截面形状圆整 ,缺陷少 ,所制得的碳纤维强度高。     

Intergranular oxidation of silicon in 20Cr-25Ni niobium-stabilized stainless steel at 1140–1230 K

The kinetics of intergranular oxidation of silicon in a 20Cr-25Ni Nb-stabilized stainless steel are reported, at temperatures in the range 1140–1230 K, in CO₂ at 40 bar pressure. The depth of attack increased parabolically with respect to time, with an activation energy of 335±30 kJ/mol. The mechanism of growth is discussed in terms of classical internal-oxidation theories, and an alternative explanation based on an available-space theory is developed. The internal oxidation rates in a number of different alloys are compared with diffusivities of metals in the base alloy. It is proposed that intergranular oxidation in the 20–25 Nb steel is controlled by the rate of outward diffusion of iron or chromium in the alloy.