Windows 95/98环境下PC机并行打印端口控制步进电机的研究

介绍了在Windows95／98环境下利用IBM-PC机打印端口控制步进电机运动的实现方法，并给出了关键程序的实现代码。     

A new FMS architecture based upon networked DSP servo technology

This paper presents a critical evaluation of existing FMS architectures and the academic and industrial design and development strategies used during their formulation. The paper seeks to address the need for, and value of, existing architectures within the industrial arena. More importantly however, this paper puts forward a new two-tier distributed control architecture for FMS based upon new (real-time) networkable DSP servo control methodologies developed by one of the authors for Softronics in Australia. The ramifications of these methodologies are substantial, not only in terms of FMS control, but in the overall simplification of such systems and the development of flexible fixturing devices over the coming decade. This paper also postulates on how new FMS architectures can be developed from such technologies and details why such architectures could be more appropriate to industry needs than those that are currently in existence.     

空调器用盘式电机的计算机模拟

介绍线绕盘式永磁直流电流电动机的结构特点，设计原则和有关的主要设计公式，并进行电机的计算机模拟。模拟运行结果与样机实测数据基本相符。     

可编程控制器在包装机上的应用

本文介绍了可编程控制器（PLC）在包装机上的应用．介绍了系统的硬件设计与软件开发．     

红外遥感用低温制冷器的进展

低温制冷器与红外探测器配套，是军事现代化、高新技术等急需发展的关键产品。国内研制技术也已接近国际先进水平，基本掌握了小型化、低振动、长寿命、细方形漆包线制作、间隙密封、消除电磁干扰等相关关键技术。本文列出了已研制过的直线电机谐振压缩机的主要技术性能。希望主管、用户、研制、生产各方通力合作，应用－改进－再应用－再改进，实现我国低温制冷器的产业化。     

An automatic torque ripple compensation system for direct drive motors

A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments.     

我国车用汽油的发展概况及发展方向探讨

介绍了我国车用汽油的发展轨迹 ,通过与国外先进标准的对比分析了我国车用汽油存在的不足 .指出我国在加入WTO后 ,更应不断升级车用汽油质量标准 ,需要从标准制定、炼油技术等多方面追赶世界先进水平 ,积极研制生产清洁型无污染汽油 ,从根本上消除汽车尾气对环境的污染 .     

提高大直径井眼机械钻速的几项措施

随着我国西部地区石油勘探开发的进展，5000－7000m的深探井所钻数量不断增多，套管程序增加，特别是大尺寸井眼所钻深度明显加大。由于国产大尺寸钻头结构单一、型号少，破岩机械能量和水力能量不足，在易斜井段目前尚无可靠的防斜保直措施，以及钻井液性能不适宜等原因，大尺寸井眼的钻这远远低于215．9mm井眼的钻速。据此，提出了几项可以提高大尺寸井眼钻速的措施：增加大尺寸钻头的种类，采用阶梯式扩眼钻头，强化钻井参数和水力参数，选用中速动力钻具，改善钻井液性能以及采用冲击旋转钻具等。     

结构陶瓷的高温疲劳强度衰减理论

提出了陶瓷材料疲劳强度衰减理论并由此导出了各种疲劳关系式。建立了疲劳基本方程ｄσ＿ｒ／ｄ＿ｉ＝一Ａσ（ｔ）￣ｎｔ￣（－ｍ），得出了疲劳寿命公式Ｔ＝Ｍ（σ＿０－σ）／Ａσ￣ｎ（静疲劳时Ｍ＝１，连续增载疲劳时Ｍ＝ｎ＋１，循环疲劳时Ｍ＝（ｎ＋１）／（１＋Ｒ＋Ｒ￣２＋……＋Ｒ￣ｎ），逐级加载时，并导出不同疲劳方式下疲劳寿命间的关系。同时，用多种Ｓｉ＿３Ｎ＿４材料在高温中作了论证试验，结果与理论一致。     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.