QUANTITATIVE MEASUREMENT OF CHROMIUM'S ABILITY TO PROMOTE ADHESION

Using atomic force spectroscopy, we investigated the adhesion-promoting ability of chromium. An intermediate layer of chromium can overcome the low adhesion between metal films and silicon dioxide. For the first time, we quantitatively studied this experimentally well known fact. We compared the adhesion between chromium and different substrates such as gold, silver, mica, and silicon dioxide and, beyond that, the adhesion between silicon dioxide and the same substrates. To avoid additional effects due to water, we chose ethanol as a nonpolar solvent. Taking the interfacial energies of the surfaces with the liquid into account eliminates the direct influence of the fluid medium on the adhesion of the solid material. The results we obtained corroborate the experimental fact of higher adhesion of chromium with the chosen substrates, as well as substantiate the value of chromium as an adhesion promoter. The adhesion of chromium-coated probes on gold, silicon dioxide, and mica is higher than the adhesion of silicon dioxide probes on the same substrates.     

MICROSCOPIC SPREADING CHARACTERISTICS OF NONPOLAR PERFLUOROPOLYETHER FILMS

The surface diffusion characteristics of nonpolar perfluoropolyether (PFPE) Z on carbon surfaces are investigated in two regimes, submonolayer and multilayer, for nano-thin films. For the submonolayer regime, the two-dimensional, cubic van der Waals equation of state is applied to determine the dependence of the surface diffusion coefficient on the film thickness, as experimental surface diffusion coefficients increase with increasing film thickness. For the multilayer regime, a conventional fluid mechanics analysis with position dependent viscosity and a van der Waals disjoining pressure gradient is applied to investigate the surface diffusion characteristics. The present theoretical analysis qualitatively agrees with the experimental results.     

Molecular simulation of hydrogen adsorption in organic zeolite

The adsorption of molecular hydrogen on model zeolites has been simulated employing Grand Canonical Monte Carlo (GCMC) procedure. The effects of cation type, available volume, surface area, temperature, pressure and pre-adsorbed organics such as benzene on the hydrogen uptake are analyzed. The hydrogen adsorption can be affected mainly by the available volume and surface area per g-zeolite at the same temperature and pressure. Increase of temperature results in the decrease of sorption intensity and capacity. The adsorption capacity correlates well with the pressure with high linearity at room temperature. Adsorption is lowered by the pre-adsorbed benzene molecule. The orientation and the number of benzene molecule in zeolite affect the adsorption capacity. The organic zeolite with larger available volume shows larger adsorption capacity.     

塑料啤酒瓶开发现状

介绍了塑料啤酒瓶的优点,详细介绍了各种以PET为基础的改性啤酒瓶材料,并列举了大量的开发实例。     

PROBING HIDDEN POLYMERIC INTERFACES USINGIR-VISIBLE SUM-FREQUENCY GENERATION SPECTROSCOPY

Understanding the molecular-level processes underlying interfacial phenomena is important in the area of adhesion. We briefly introduce IR-visible sum-frequency generation spectroscopy (SFG) using a total-internal-reflection geometry for the study of polymer-air, polymer-solid, and polymer-polymer interfaces. The following examples, predominantly of work done in our lab, illustrating differences in molecular structure and dynamic properties at interfaces are presented: the air- and solid-interface structure of an amorphous polystyrene (PS) and a semicrystalline polymer with side-chain crystallinity, poly(octadecyl acrylate) (PA-18); structure of a polymer-polymer interface between thin films of a semicrystalline polymer with side-chain crystallinity, poly(vinyl-N-octadecylcarbamate- co-vinyl acetate), and an amorphous PS; thermal order-to-disorder transitions of the air and solid interface of PA-18, and the interface of this polymer with PS; and dynamic surface-relaxation studies of a rubbed PS film.     

Studies of surface and gas reactions in a catalytically stabilized combustor

A numerical investigation of a catalytically stabilized thermal (CST) combustor was conducted for a multichannel catalyst bed, and both the catalyst bed and thermal combustor were simultaneously modeled. The numerical model handled the coupling of the surface and gas reaction in the catalyst bed as well as the gas reaction in the thermal combustor. The behavior of the catalyst bed was investigated at a variety of operating conditions, and location of the flame in the CST combustor was investigated via an analysis of the distribution of CO concentration. Through parametric analyses of the flame position, it was possible to derive a criterion to determine whether the flame is present in the catalyst bed or the thermal combustor for a given inlet condition. The results showed that the maximum inlet temperature at which the flame is located in the thermal combustor increased with increasing inlet velocity.     

New liquid membrane technology for simultaneous extraction and stripping of copper(II) from wastewater

In this paper, a new liquid membrane technique, hollow fiber renewal liquid membrane (HFRLM), is presented, which is based on the surface renewal theory, and integrates the advantages of fiber membrane extraction, liquid film permeation and other liquid membrane processes. The results from the system of CuSO₄+D2EHPA in kerosene+HCl show that the HFRLM process is very stable. The liquid membrane is renewed constantly during the process, the direct contact of organic droplets and aqueous phase provides large mass transfer area. These effects can significantly reduce the mass transfer resistance in the lumen side. Then the mixture of feed phase and organic phase flowing through the lumen side gives a higher mass transfer rate than that of stripping phase and organic phase, because the aqueous layer diffusion of feed phase is the rate-controlling step. The overall mass transfer coefficient increases with increasing flow rates and D2EHPA concentration in the organic phase, and with decreasing initial copper concentration in the feed phase. The overall mass transfer coefficient also increases with increasing pH in the feed phase, and reaches a maximum value at pH of 4.44, then decreases. Also, there is a favorable w/o volume ratio of 20:1 to 30:1 for this process. Compared with hollow fiber supported liquid membrane and hollow fiber membrane extraction processes, HFRLM process has a high mass transfer rate. Mathematical model for the HFRLM process based on the surface renewal theory is developed. The calculated results are in good agreement with experimental results under the conditions studied.     

From surface science to catalysis: Surface “explosions” observed on Rh crystals and supported catalysts

Phenomena called surface explosions have been reported for decomposition reactions on single crystals, and have been identified by the use of desorption methods. In particular, in TPD, they are manifested by extremely narrow peaks (as little as 3 K in width) and a desorption rate which increases with time in isothermal experiments. In this paper we report such observations for acetate species on Rh single crystals, but extend this to show for the first time that such effects are not restricted to single crystal/UHV experiments, but can also be found on a Rh/Al₂O₃ catalyst under ambient pressure conditions. These reactions can be classified as second order autocatalytic surface processes, where free surface Rh sites are an essential component of the reaction. It is shown that coadsorbed adatoms are also essential for such explosions to be seen and their role is proposed to be that of a template layer acting to order the acetate in self-poisoning configurations.     

HOW LIQUIDS SPREAD ON SOLIDS

A theory of the wetting of solids by liquids is put forward. The theory accounts for capillary pressure gradient, gravitational potential gradient, surface tension gradient, disjoining pressure gradient driving forces of flow in thick thin-films and of surface diffusion in thin thin-films. Disjoining pressure stems from the way intermolecular forces aggregate in submicroscopically thin films. For thick thin-films of slowly varying thickness the lubrication approximation to velocity distributions is appropriate. With this approximation the spontaneous, unsteady, two-dimensional spreading of liquid is shown to be governed by a nonlinear convective-diffusion equation for the evolution of the film thickness profile. The predictions of the theory agree with Marmur and Lelah's (1980, 1981) observations of water drops spreading on glass and with Bascom, Cottington and Singleterry's (1964) and Ludviksson and Lightfoot's (1971) observations of oils spreading on high energy surfaces. The theory is used to analyze Derjaguin and co-workers' (1944, 1957, 1970) blowing-off experiments designed to measure thin-film rheology. The theory is also used to buttress the proposition that much contact angle hysteresis is due simply to slow attainment of equilibrium.     

Variability of sedimentary phosphorus fractions in the western and Sandusky basins of Lake Erie

Surface sediments and three sediment cores from the western basin and one sediment core from the Sandusky basin were analyzed to document spatial and temporal changes in five phosphorus fractions and total phosphorus (TP). The areal distributions of the bioavailable fractions NaCl-Pi, NaBD-Pi, and NaOH-Pi and the refractory organic fraction Res-P were broadly consistent and contrasted with those of the detrital fraction HCl-Pi which showed that high concentrations occurred mostly in high-energy littoral zones and low concentrations largely in profundal depositional areas. The contrasting distributions were induced by interactions among tributary inputs, wave action, circulation, and biogeochemical cycling and transfer in the basin. As revealed by the Sandusky basin sediment record, the detrital fraction HCl-Pi was dominant (70% of TP) during European settlement and decreased rapidly by 28.0% in the early 1910s due largely to impoundments of the Maumee and Sandusky Rivers. While HCl-Pi has ever since remained relatively constant, NaCl-Pi, NaBD-Pi, and NaOH-Pi increased significantly between 1950 and 1970 in the two basins. However, the post-regulation sediment records differed considerably among these coring sites. There was a marked increase of TP in two cores, corresponding to recent return of eutrophication and massive harmful algal blooms but contrasting with a relatively constant, low loading into the lake. This signified the role of internal loading as derived partialy from legacy pollution. Furthermore, NaCl-Pi has increased progressively throughout all the records. We conclude that the increased levels of NaCl-Pi in surface sediments may have altered the internal loading and contributed to the resurgences of harmful algal blooms in Lake Erie.