SiO_2对低温液相法制备锐钛型TiO_2/SiO_2纳米复合膜性能的影响

采用浸渍提拉法在玻璃表面制得SiO2/TiO2纳米复合膜,筛选出SiO2∶TiO2优化摩尔比为0.1∶1。结果表明,加入SiO2可有效提高TiO2膜层均匀性,降低晶粒直径,纳米复合膜对甲基橙溶液光催化降解率为38.58%,光照30min后膜接触角为5(°),纳米膜与玻璃之间附着力达到1级,且对各类介质均具有良好的耐蚀性。     

纳米TiO_2改性苯丙乳液内墙涂料的研究

采用物理掺和法,在苯丙乳液中加入锐钛型纳米TiO2,制成内墙涂料,进行抑菌试验和甲醛降解实验研究,分析了纳米TiO2的光催化原理和抗菌机理。结果表明,随着TiO2含量增加,甲醛降解能力和抗菌性能增强,当TiO2含量为4%时效果最好。     

氮掺杂纳米TiO_2改性涂料及其抗菌性能

将自制的氮掺杂锐钛矿型纳米二氧化钛光催化剂作为功能性组分,加入耐光催化氧化的硅丙乳胶涂料中,制备出一种新型光催化功能性建筑涂料,实现了可见光光催化效应。使用紫外-可见光吸收光谱研究该功能性涂料对紫外线的吸收能力;采用菌落计数法研究该涂料在可见光照射下对金黄色葡萄球菌的杀灭性能。同时分析了纳米粉体种类、引入量及方式对涂料紫外线的吸收性能和抗菌性能的影响。     

2,6-二乙酰基吡啶合成方法的改进

优化了2，6—二乙酰基吡啶的合成工艺。以2，6—吡啶二羧酸为原料，经过醇化及克莱森酯缩合反应，合成了2，6—二乙酰基吡啶，2，6—吡啶二羧酸二乙醇和2，6—二乙酰基吡啶的分离收率分别为94．1％和88．9％，2，6—二乙酰基毗啶的质量分数大于99％。     

Effect of Addition of Oxides on Low-Temperature Oxidation of Molybdenum Disilicide

A type of aluminosilicate that has a good wetting property for molybdenum disilicide (MoSi₂) was added to a MoSi₂ matrix to study the effects on the microstructure and low-temperature oxidation. It was found that the composites had not only good low-temperature oxidation resistance but also high thermal shock resistance when the added oxides formed a network microstructure in the matrix. There was no appreciable oxidation gain for MoSi₂/oxide composites with a network microstructure at 773 K for 2500 h. The results indicate that microstructure design is a simple and effective solution to preventing the low-temperature oxidation of MoSi₂.     

从假性紫罗兰酮合成β-紫罗兰酮中主要副产物(I)的分离鉴定

假性紫罗兰酮在浓硫酸及 - 2 0°C低温条件下反应 ,主要生成 β-紫罗兰酮 ,少量的 α-及 γ-紫罗兰酮 ,同时生成副产物 ( I)及 ( II)。用 IR、1H NMR及 MS光谱分析方法 ,对副产物 ( I)进行了结构鉴定 ,结构为 3,4,4a,5 ,8,8a-六氢 - 2 ,5 ,5 ,8a-四甲基 - 2 H - 1 -苯并吡喃     

B_2O_3和CaF_2对C_3S-C_(2.75)B_(1.25)A_3-C_2S-C_3A水泥熟料矿物体系力学性能影响

研究了B2O3和CaF2对C3S-C2.75B1.25A3S珚-C2S-C3A熟料矿物体系的组成、结构与力学性能的影响。研究结果表明:在该熟料体系中C3S,C2.75B1.25A3S珔,C2S和C3A的适宜含量分别为50%,10%,25%和15%,B2O3和CaF2的适宜掺量为2%和1.5%。在最佳组成和制备工艺条件下,合成的阿利特-硫铝酸钡钙水泥的1d,3d和28d抗压强度分别达到18MPa,48MPa和95MPa以上,展现了良好的早期力学性能。同时,掺加CaF2能有效降低熟料中游离氧化钙的含量,促进阿利特在低温条件下形成。利用SEM-EDS,XRD等测试手段对熟料的组成、结构及性能进行了分析。     

Isobutane/2-butene alkylation on MCM-22 catalyst. Influence of zeolite structure and acidity on activity and selectivity

The catalytic behavior of the novel MCM-22 zeolite for the continuous alkylation of isobutane with 2-butene has been investigated at a temperature of 50°C, 2.5 MPa total pressure, and a variety of olefin space velocities. At high olefin conversions the MCM-22 zeolite showed a very high initial cracking activity attributable to strong Brønsted acid sites, as well as to the existence of strong diffusional restrictions of the TMP's (formed inside the zeolite) to exit through the channels. At short times on stream (TOS), TMP's account for ca. 40% of the C₈ fraction. The olefin conversion and the cracking activity rapidly decline with TOS, while the alkylate product became richer in dimethylhexenes, indicating a predominance of 2-butene dimerization and a loss of hydrogen transfer activity as the catalyst aged. Moreover, MCM-22 gives less TMP's than large-pore zeolites (USY, beta, mordenite), but more than the mediumpore ZSM-5 at similar 2-butene conversion. The latter catalyst was much more selective for olefin dimerization than for isobutane alkylation, presumably because formation of the bulkier TMP's was strongly impeded in its smaller pores.     

用D_2EHPA-煤油溶剂萃取分离L-异亮氨酸

本文研究了从发酵液中用D2EHPA－煤油溶剂萃取分离L－异亮氨酸工艺．考察了萃取时pH值、萃取剂浓度和异亮氨酸浓度对于异亮氨酸和缬氨酸的萃取分配比的影响．在计算机上进行回归，得到以下分配模型：当1≤pH≤3．5时lgDIle＝0．09906pH2＋0．8625pH＋2．2696lgCHR－0．09188lg2CIle＋0．1766lgCIle－1．366lgDrmVal＝－0．0293pH2＋0．550pH＋1．2659lgCHR－0．2420lg2CIle＋0．4549lgCIle－1．696用此模型，应用分馏萃取理论，进行逐级计算，求取了萃取工艺的主要参数，并在φ20mm的多级离心萃取器上对上述结果进行了验证．结果表明：当CHR浓度为1．5mol／L，相比V：L：L’＝2：1：2，N’＝3，N＝6时，异亮氨酸的收率达到90％以上，纯度＞99％．实验取得了较为满意的结果．     

强酸性阳离子交换树脂催化合成氯乙酸异辛酯的研究

对采用７３２强酸性苯乙烯系阳离子交换树脂作催化剂合成氯乙酸异辛酯进行了实验研究，提出了适宜的反应条件。实验结果表明，该法酯化率高、过程简便、产物颜色浅，优于浓硫酸作催化剂。