赣西浒坑钨矿床成矿岩体的磷灰石和锆石微量元素特征及其对成岩成矿的指示

赣西地区浒坑钨矿是我国华南钨、锡、铜多金属成矿区与中生代岩浆活动密切相关的典型矿床之一。对浒坑钨矿床中与成矿有关的白云母花岗岩开展了锆石U-Pb定年、磷灰石和锆石原位微量元素研究,结果表明：赋矿白云母花岗岩的成岩时代为（152.3±1.73）Ma;磷灰石具有特殊的“M”型REE球粒陨石标准化配分模式,富F和Mn,贫Cl和Mg;锆石具有高Th/U比值,REE球粒陨石标准化配分模式亏损LREE、富集HREE。锆石微量元素（Ce、U和Ti）温度计和氧逸度计结果表明,锆石形成于岩浆早期高温（800 ℃）和低氧逸度条件下。研究认为,浒坑赋矿花岗岩在演化初期经历了强烈的矿物结晶分异,矿床的形成可能与还原性高分异岩浆演化相关。     

季胺萃取锌的动力学研究

以恒界面池法研究了氯化物介质中季胺萃锌的动力学。考查了搅拌转速、传质界面积和温度对萃取速率的影响，判定季爱萃锌为界面化学反应的动力学模式。进一步研究了季胺萃取剂浓度和水相Ｚｎ＾２＋浓度对萃取速率的影响，得到了与理论推断相吻合的速率方程。     

Initial stages of tin electrodeposition from sulfate baths in the presence of gluconate

Tin electrodeposition in its initial stages in acid sulfate/gluconate baths was studied with varying tin and gluconate concentrations using potential-controlled electrochemical techniques. The deposit morphology was observed by scanning electron microscopy (SEM). A comparison with tin electrodeposition from acid sulfate baths in the absence of gluconate was also carried out. Use of a highly acidic bath leads to nonuniform deposits, even in the presence of gluconate; at pH 4 deposits are uniform, brilliant and suitable for finishing applications. Tin crystallites have a well defined morphology which depends on bath agitation conditions. In the absence of agitation, the crystallites have the same tetragonal shape as in a sulfate bath without gluconate.     

Ni-ZrO2纳米复合电铸层抗高温氧化性能的研究

通过间歇式抗高温氧化实验,建立了纯镍电铸层和N i-ZrO2纳米复合电铸层高温氧化动力学模型,分析了电铸层表面和横截面的形貌,测定了电铸层的组织结构。结果表明,N i-ZrO2纳米复合电铸层抗高温氧化性能明显优于纯镍铸层,复合电铸层表面生成的氧化膜晶粒细小且致密,并且该氧化膜较薄,产生的内应力较小,与复合电铸层的黏附性较好。     

脉冲电流对锌酸盐镀锌层的影响

研究了在锌酸盐镀锌体系中采用脉冲电流时，脉冲频率，脉冲的占空比、反向电流对镀层外观，耐蚀性的影响，发现在最佳脉冲条件下得到的镀锌层比直流电镀得到的镀层光亮，结晶细致，耐蚀性能有很大的提高。     

Crystallization and dissolution behavior of l(+) calcium and zinc lactate in ethanol-water solvent

Crystallization and dissolution behavior of L(+) calcium and zinc lactate in 50% ethanol-water solution was studied. The effects of stirring, standing, ultrasonic wave, and temperature on the crystallization of L(+) calcium and zinc lactate were evaluated. It was found that standing had a positive effect on crystallization of L(+) calcium and zinc lactate, while stirring promoted dissolution of crystallized particles and resulted in high residual concentration in mother liquor. The application of ultrasonic wave did not influence much on crystallization process. L(+) calcium and zinc lactate crystallized easily at 5 ‡C; however, complete crystallization took more than 72 hours. These two salts dissolved rapidly and reached equilibrium within 1 hour.     

适用于摩托车零件的多层镍电镀工艺

概括目前我国摩托车零件电镀所用镀层组合，对照有关金属覆盖层的国家标准，认为摩托车零件应用多层镍组合，并提供了工艺配方。     

Reforming of methane with carbon dioxide over supported bimetallic catalysts containing Ni and noble metal: I. Characterization and activity of SiO2 supported Ni–Rh catalysts

Cobalt catalysts supported on silica aerogel have been prepared using sol–gel chemistry followed by drying under supercritical ethanol conditions. Three different loadings of cobalt were synthesized: 2, 6, and 10% by weight. Transmission electron micrographs indicate that the metallic cobalt exists as discrete particles 50–70 nm in diameter for the 2 and 6% loadings. The 10% catalyst shows long needles of cobalt. BET and BJH measurements indicate that the catalysts retain the silica aerogel properties of high surface area (∼800 m²/g), large pore volume (∼5 cm³/g), and an average pore diameter in the mesoporous regime (∼25 nm). The catalysts were evaluated for Fischer–Tropsch activity in a laboratory-scale packed bed reactor. All three catalysts were active with the 10% Co catalyst achieving more than 20% CO conversion which corresponds to a rate of 1.53 g CO per g-cat per hour. The catalysts were selective for the C₁₀₊ hydrocarbons with more than 50% of the carbon contained within this fraction. A significant portion of the C₉–C₁₅ hydrocarbon product was observed as 1-olefins which reflects the enhanced mass transport within the very porous aerogel support.     

碱金属和锌对高炉用SiAlON结合刚玉砖的复合侵蚀

将高炉用SiAlON结合刚玉砖制成外部尺寸为50mm×50mm,内孔尺寸为25mm×25mm的坩埚,分别加入由Na2CO3、K2CO3、ZnO和宝钢高炉现场高炉灰配制的炉渣(其w(Na2O+K2O)=2.75%,w(ZnO)=5.1%)和用K2CO3、ZnO、石墨配制的炉渣(其w(Na2O+K2O)=25%,w(ZnO)=25%),然后分别在还原气氛下于1350℃16h和1100℃40h进行侵蚀试验。将侵蚀后的试样纵向对称剖开,观察渣对试样的侵蚀和渗透情况,进行SEM和EDAX分析。结果表明:碱金属和锌含量不同的两种炉渣对SiAlON结合刚玉砖的侵蚀速度都很小;碱金属侵蚀机理主要是SiAlON与碱蒸气反应生成钾霞石,与渣反应生成铁橄榄石,并参与硅酸盐玻璃相的生成;刚玉颗粒与渣中的FeO、Na2O和K2O反应生成铁铝尖晶石和少量针状β-Al2O3;锌对该砖没有产生明显的化学侵蚀。     

Comparative electrochemical studies of zinc chromate and zinc phosphate as corrosion inhibitors for zinc

The anticorrosive performance of two inhibitive pigments, zinc chromate and zinc phosphate, was compared using electrochemical impedance spectroscopy (EIS) and the scanning vibrating electrode technique (SVET) in pigment extracts in 0.1 M NaCl. It was observed that zinc was protected from corrosion in both extracts. In tests using hot dip galvanised steel painted with an epoxy primer incorporating the pigments, the SVET detected the anodic and cathodic distribution along the scribes, although no significant differences were observed among the various primers. On the contrary, EIS was able to distinguish processes occurring on the metal surface exposed by the scribe in different samples. For primers with anticorrosive pigment, a time constant at high frequencies was attributed to a layer of protective nature, probably formed by metal ions from the substrate and inhibitive ions leached from the anticorrosive pigments.