Effects of chemical and plasma surface treatments on the O2-annealed Ni/Au contact to p-Gan

The effects of boiling Aqua Regia (AQ), N₂/Cl₂ plasma followed by AQ and O₂ plasma followed by AQ surface treatments prior to Ni/Au (20 nm/20 nm) metallization to p-GaN:Mg (∼ 3 × 10¹⁷ cm^− 3) have been investigated. N₂/Cl₂ plasma was employed in a bid to lower the Ga/N and O/Ga ratios of the GaN surface to improve the contact properties to p-GaN, while O₂ plasma was employed as an alternative to incorporate O into the Ni/Au system. Results show that a low Ga/N ratio does not necessarily correspond to a better contact. The positive effect of O₂ over N₂ anneal is observed only for the AQ-treated sample, although the mechanisms responsible for its positive effect: NiO formation and Ni/Au layer-reversal were observed for all O₂-annealed contacts. We conclude that the effect of O₂ anneal on the Ni/Au contact is dependant on the p-GaN surface prior to metallization.     

乙烯裂解炉辐射段炉顶密封结构优化设计

乙烯裂解炉的炉顶密封效果关系到装置的安全、稳定运行.针对现行的密封结构,进行了合理的技术改造和优化设计,并经实际投入使用,效果良好,也可进一步推广到类似的炉型上.     

工业炉节能监测分析

从监测工作的实际出发，对工业炉的4项节能监测指标，如排烟温度、过量空气系数、炉体外表面温度、热效率不合格的原因进行了详细分析，从而找出解决问题的方法，为企业提出切实可行的整改建议，通过整改提高了工业炉的热效率，降低了能耗。     

Al2O3对唐钢高炉炉渣性能的影响

针对唐钢近2年提高进口矿配比后，Al2O3含量升高对炉渣流动性带来的不利影响，对唐钢高炉的炉渣性能进行了试验研究。并结合国内同行业的生产实践经验，从理论上分析了炉渣中Al2O3及MgO的适宜含量范围，着重论述了唐钢所处冀东矿区条件下降低Al2O3的主要途径及适应高Al2O3炉渣的具体措施。     

炉顶红外摄像装置在新钢6号高炉上的安装及应用

阐述了高炉炉顶红外摄像装置的安装及应用。该装置对及时了解和掌握高炉炉喉的料面情况、煤气流的分布状况，对指导高炉操作、维护炉况顺行和稳定，改善各项技经指标，发挥了重要作用。     

板式换热器在中小高炉炉体冷却中的应用探讨

中小高炉炉体软水冷却采用的空冷器冷却效果随季节变化而波动，夏天时最高进高炉水温达到70℃以上，影响了高炉的安全高产和使用寿命。板式换热器以波纹板为传热面，传热系数高、体积小、拆装清洗方便，换热强度高，换热效果好，根据中小高炉炉体冷却软水系统流量大、温差小等特点，宜选用316或316L不锈钢材质、结构矮胖型、开二备一、3台并联的板式换热器。济钢2^#355m^3高炉采用BR1．IXC(1．0／100)200．2型水-水板式换热器，软化水进高炉温度全年稳定在34～39℃。     

Thermal and thermoelastic properties of fast extrusion furnace (FEF) carbon black loaded SBR vulcanizates

The effect of FEF carbon black as filler on the thermal capacity c, diffusivity a, and thermal conductivity λ, of styrene butadiene rubber (SBR) composites in the temperature range 300–420 K was studied. The filler strongly increases the thermal diffusivity, whilst strongly decreasing the thermal capacity and the thermal conductivity (except at high FEF content ≥80 phr). The influence of the filler on the thermoelastic behaviour of the same composites was also investigated. It was found that the thermoelastic temperature change (ΔT) increased with carbon black concentration as well as the entropy change per unit extension.     

用发生炉煤气进行快速热风烤窑的应用

用发生炉煤气进行快速热风烤窑的应用王善波，王志军（山东荣成市玻搪工程有限公司２６４３０９）ＰｒｏｄｕｃｅｒＧａｓＵｓｅｄｆｏｒＦａｓｔＨｅａｔｉｎｇｕｐＴａｎｋＦｕｒｎａｃｅ￥ＷａｎｇＳｈａｎｂｏ；ＷａｎｇＺｈｉｊｕｎ（ＳｈａｎｄｏｎｇＲｏｎｇｃｈｅ...     

掺杂WRe3、WRe25合金的高温电阻－温度特性

本文报导了采用一种新型高温陶瓷发热体高温管状炉，通以氩气保护，测量ＷＲｅ合金丝的电阻－温度（１６００℃）特性试验方法，该方法较真空炉简便、实用且试验费用低而准确，测量数据与美国研究报导一致。     

改造加热炉系统 提高加热炉热效率

分析了重整装置加热炉热效率低的原因，介绍了提高加热炉热效率采取的几项措施。