NdCl_3·nTBP/MgCl_2-AlR_3催化体系合成丁二烯橡胶

探讨了以NdCl_3的磷酸三丁酯(TBP)溶液为主催化剂、烷基铝为助催化剂、MgCl_2为载体组成的Ziegler-Natta型催化体系引发丁二烯(Bd)聚合的某些规律。用AlEt_3作助催化剂,聚合物的顺1,4-结构含量仅为57％,反1,4-结构含量为42％;而以Al(i-Bu)_3作助催化剂,聚合物的顺1,4-结构含量为88％,反1,4-结构含量为11％。各种陈化体系中,以NdCl_3·nTBP/MgCl_2-Al(i-Bu)_3-Ip三元体系的催化活性最高,当Nd/Bd(摩尔比)为7×10~(-5)时,单体转化率达80％。低温聚合可获得高顺式、高分子量聚合物。     

Ti-silicalite as catalyst for gas-phase ammoximation of cyclohexanone with molecular oxygen

The catalyst behaviour of titanium silicalite, which was found the most active and selective catalyst for liquid-phase ammoximation of cyclohexanone to the corresponding oxime with hydrogen peroxide, was investigated in the gas-phase ammoximation with molecular oxygen in and compared with those of pure silicalite and samples of vanadium and chromium silicalites. The results showed that Ti-silicalite is a selective catalyst not only in the reaction with hydrogen peroxide but also in the reaction with molecular oxygen. However, a big limitation was found in the poor activity of the silicalites which do not allow to reach high oxime yields.     

三叶状钒催化剂的研制

介绍了三叶状钒催化剂的研制。工业宏观活性评价和通气测试表明，三叶状催化剂性能优良，其床层压力降介于圆柱状和环状催化剂之间，为圆柱状催化剂的70％左右。在相同的转化条件下，相对于环状催化剂，三叶状催化剂的装填量可减少16．7％。     

V_2O_5催化剂上甲醇乙醇一步合成醛类化合物的研究

在固定床反应器上研究了V2O5催化剂上甲醇、乙醇一步催化合成异丁醛等醛类化合物的反应。当反应在常压、350℃、进料比n(甲醇)/n(乙醇)=2、空速2.0h-1条件下进行时,乙醇转化率为89.05%,总醛产率达87.3%,其中异丁醛、乙醛、丙醛产率分别为16.71%、52.03%、18.56%,其余为丙醇、甲醛等化合物。当空速降为为0.5h-1时,乙醇转化率达到97.04%,异丁醛产率达29.07%,但总醛收率降为69.6%。该反应系统的反应历程被探讨。     

Crystalline and viscoelastic properties of branched polyethylenes synthesized using bidentate nickel (II) catalyst

In this work, five branched polyethylenes with different branching units were synthesized using bidentate nickel (II) catalyst containing -diimine ligands. For comparison, one linear polyethylene was also prepared using tridentate iron (II) catalyst containing -diimine ligand. The crystalline structure of the polyethylenes was investigated using X-ray diffraction (XRD) and polarized optical microscope. The crystalline properties were also measured by differential scanning calorimeter (DSC). Viscoelastic properties of the polyethylenes were investigated using rheometric dynamic analyzer. The DSC and XRD results showed that highly branched polyethylenes exhibit no melting points and no predominating crystalline forms, while the linear polyethylene exhibits clear orthorhombic (110) and (200) reflections on XRD pattern and a clear melting point at 118 °C. The viscoelastic properties of the branched polyethylenes were very complicated due to the combined effect of the molecular weight difference and the degree of chain branching as well as the branching structure.     

裂解汽油加氢一段催化剂失活原因分析

介绍了中国石油辽阳石化分公司烯烃厂裂解汽油加氢装置一段全馏分镍系加氢催化剂失活情况及原因分析。通过对酸性硫来源的分析及酸性硫对催化剂影响的评价，总结了处理酸性硫的对策及方法。     

有机镍化合物催化烯烃聚合的研究进展

综述了有机镍化合物如烯丙基镍、乙酰丙酮镍、茂镍、二亚胺镍等催化烯烃聚合的研究进展。有机镍化合物可催化烯烃、α-烯烃(如乙烯、丙烯等)的齐聚及聚合、催化极性单体(如甲基丙烯酸甲酯、降冰片烯等)以及位阻较大的环烯烃、取代二烯烃、苯乙烯等的均聚和共聚。     

La-OMS-2催化剂催化甲苯氧化制苯甲醛

合成了氧化锰八面体(OMS-2)分子筛,采用离子交换法和浸渍法制备了稀土金属La改性的OMS-2分子筛(La-OMS-2)催化剂,并用于甲苯液相选择性氧化制苯甲醛,考察了催化剂用量、反应温度、反应时间、氧气流量及溶剂种类对甲苯转化率和苯甲醛选择性的影响,对La-OMS-2催化剂进行了X射线衍射表征和BET比表面积测定。实验结果表明,离子交换法制备的La-OMS-2-A催化剂的活性高于浸渍法制备的La-OMS-2-B催化剂,在甲苯0.1mol、溶剂冰乙酸10mL、氧气流量60mL/min、La-OMS-2-A催化剂用量0.10g、反应温度353K、反应时间1.0h的条件下,甲苯转化率达61%,苯甲醛收率为56%。加入La对OMS-2分子筛中的MnO晶格结构产生了影响,提高了苯甲醛的收率。     

悬浮床加氢裂化油溶性催化剂与沥青质的作用

在高压釜反应器中对添加了油溶性 Ni 催化剂(UPC-O)和水溶性 Ni 催化剂(UPC-W)的辽河稠油常压渣油(LHAR)进行了悬浮床加氢裂化实验。通过元素分析和傅里叶变换红外光谱(FTIR)分析对抑制反应生焦效果好的 UPC-O 与 LHAR 沥青质的作用进行了研究。元素分析结果显示,在 LHAR 中加入 UPC-O1000μg/g,沥青质和脱沥青质油中 Ni 含量分别出476μg/g和110μg/g 增加到7 559μg/g 和1 024μg/g,表明 UPC-O 在沥青质中有富集的趋势。FTIR 表征结果显示,UPC-O 和沥青质发生了相互作用。UPC-O 可在沥青质原位硫化为活性组分,对沥青质在悬浮床加氢裂化反应中的缩合起到好的抑制作用。     

降低汽油烯烃含量裂化催化剂LBO-12的研制与开发

探讨了催化裂化过程降低汽油烯烃的反应原理，研究了催化剂各组分对裂化汽油性质影响的规律性，围绕提高氢转移活性，提出制备降烯烃裂化催化剂的技术路线，并研制开发了新型LBO-12降烯烃催化剂，固定流化床反应器对中试样品的评价和工业应用结果表明，该催化剂在不损失汽油辛烷值的前提下，降低催化裂化汽油烯烃能力较强，并具有较高的水热活性稳定性和良好的抗重金属污染特性。