A new catalyst based on a nickel(II) complex of diiminodiphosphine for hydrogen evolution and oxidation

Based on that hydrogen energy is widely used in fuel cells, we focus our interests on the design and research of new complexes that catalyze the reaction in both directions, such as hydrogen evolution reactions (HERs) and hydrogen oxidation reactions (HORs). A highly efficient catalyst for both hydrogen evolution and oxidation, based on a nickel(II) complex, [Ni-en-P₂](ClO₄)₂, has been designed and provided by the reaction of Ni(ClO₄)₂ with N,N′-bis[o-(diphenylphosphino)benzylidene]ethylenediamine (en-P₂) in our group. Its structure has been determined by X-ray diffraction. [Ni-en-P₂](ClO₄)₂ can electro-catalyze hydrogen evolution both from acetic acid and a neutral buffer (pH 7.0) with a turnover frequency (TOF) of 204 and 1327 mol of hydrogen per mole of catalyst per hour (H₂/mol catalyst/h) under an overpotential (OP) of 914.6 mV and 836.6 mV, respectively. [Ni-en-P₂](ClO₄)₂ also can electro-catalyze hydrogen oxidation with a TOF of 111.7 s⁻¹ under an OP of 330 mV. The results can be attributed to that [Ni^II-en-P₂](ClO₄)₂ has three good reversible redox waves at 1.01 (Ni^III/II), −0.79 (Ni^II/I) and −1.38 V (Ni^I/0) versus Fc^+/0, respectively. We hope these findings can afford a new method for the design of electrocatalysts for both H₂ evolution and H₂ oxidation.     

CuInS2/SiNWs/Si composite material for application as potential photoelectrode for photoelectrochemical hydrogen generation

This work aims at developing a new composite material based on nanosized semiconducting CuInS₂ (CIS) particles combined with silicon nanowires grown on a silicon substrate (SiNWs/Si) for photoelectrochemical (PEC)-splitting of water. The CIS particles were prepared via a colloidal method using N-methylimidazole (NMI) as the solvent and an annealing treatment. The SiNWs were obtained by chemical etching of silicon (100) substrates assisted by a metal. The CIS/SiNWs/Si composite material was obtained by deposition of an aliquot of a suspension of CIS particles onto the SiNWs/Si substrate, using spin coating followed by a drying step. The XRD pattern demonstrated that CuInS₂ grows in the tetragonal/chalcopyrite phase, while SiNWs/Si presents a cubic structure. The SEM images show semi-spherical particles (～10 nm) distributed on the surface of silicon nanowires (～10 μm). The EIS measurements reveal n-type conductivity for CIS, SiNWs/Si and CIS/SiNWs/Si materials, which could favour the oxidation reaction of water molecules.     

氢化物原子荧光光谱法测定酱油中微量铅的方法研究

建立了一种快速、高效的QuEChERS-高效液相色谱-质谱联用法（QuEChERS-HPLC-MS/MS）测定谷类杂粮制品中脱氧雪腐镰刀菌烯醇（DON）、3-乙酰脱氧雪腐镰刀菌烯醇（3-ADON）、15-乙酰脱氧雪腐镰刀菌烯醇（15-ADON）和玉米赤霉烯酮（ZON）共4种真菌毒素。样品前处理采用乙腈-水溶剂提取，经Florisil+C18+无水硫酸镁净化后检测。以0.10%甲酸-乙腈作为流动相，在质谱检测器的多反应监测模式下进行分析。结果表明，4种真菌毒素在各自的线性范围内线性关系良好，相关系数R2均大于0.999，回收率在85.1%～102.0%，相对标准偏差（RSD）为2.11%～6.22%。该方法具有前处理简单、净化效果好、灵敏度高和检测速度快的优点，适用于谷类杂粮制品中DON、3-ADON、15-ADON 和ZON的分析和定量检测。     

Monolithically-integrated BiVO4/p+-n GaAs1-xPx tandem photoanodes capable of unassisted solar water splitting

Monolithically-integrated tandem photoanodes were fabricated on substrates consisting of epitaxial n-GaAs_1-xP_x (x ? 0.32) grown on n⁺-GaAs wafers. A p⁺-n junction photovoltaic (PV) cell was first formed by zinc diffusion into the n-GaAs_0.68P_0.32 from a deposited ZnO coating. After diffusion the ZnO serves as a transparent electrical contact to the resulting p⁺-GaAs_0.68P_0.32 surface layer. Transparent, conducting SnO₂:F provides chemical and mechanical protection for the ZnO and the underlying PV cell, and it electrically connects this cell to a top BiVO₄ photocatalyst layer. In some photoanodes, a WO₃ thin film was interposed between the SnO₂:F and BiVO₄. All oxide coatings were produced by ultrasonic spray pyrolysis except WO₃, which was spin coated. Unassisted (unbiased) solar water splitting was achieved, with a solar-to-hydrogen efficiency approaching 2%, without addition of any co-catalyst to the BiVO₄ surface. This work can provide insights to other researchers regarding scalable, low cost approaches for the planar monolithic integration of oxide photoanode materials with PV cells to create new tandem devices.     

硫化氢吸收液的电化学分解条件研究

理想的脱硫工艺应满足体积小、费用低、净化度高、无二次污染等要求。在碱性溶液吸收微量硫化氢时同步进行电解，可有效减小设备体积，并将硫化氢转变为氢气和硫磺，不产生恶性气味。为此，实验研究了温度、浓度、电流密度、pH值等因素对电解阳极过程的影响，确定了适宜的电解条件，并在该条件下进行了吸收实验。结果表明，在最佳电解条件下，硫化钠溶液能充分吸收天然气中经变压吸附提浓的硫化氢（800 mg/m³），吸收率大于99.9％。     

橡胶促进剂DM的合成工艺

M氧化生成DM是自由基反应机理，结合微反应器机理，采用分子氧化的反应方式，选用绿色溶剂异丙醇、环境友好型氧化剂H202，一步法制取高品质DM。对反应时间、反应温度、氧化剂用量等因素进行考察，确定最佳工艺条件为：反应时间90min，反应温度55℃，氧化剂不过量，碱过量5％，M—Na溶液M含量30％，加料时N60 min，溶剂用量为M—Na溶液质量的1．5倍，所得产品质量合格，熔点可达180℃。     

一种制氢预转化催化剂还原的新方法

对上海高桥分公司2×10~4m~3/h(标准状态)制氢装置原设计的预转化催化剂还原流程进行了改进。先跳开预转化反应器,利用转化炉制取氢气,再用自产的高纯氢气代替重整氢,对预转化催化剂进行单独升温还原,避免了催化剂在还原初期因发生甲烷化反应而超温失活的问题,使催化剂具有更好的活性和稳定性。     

Estimation and Optimization of the Principal H-Maser Parameters

The scale along the coordinate axes in the equations of motion hitherto used for an H-maser (in relative units) is shown to depend on Q as the quality factor for an H-maser. This hinders both analysis of the operation of the H-maser and optimization of its parameters. The modified equations of motion proposed here do not have that shortcoming. We determine the atomic flux into the bulb that gives the H-maser the best metrological characteristics.     

Biodegradation of monoaromatic hydrocarbons in aquifer columns amended with hydrogen peroxide and nitrate

The ability of indigenous microorganisms to degrade benzene, toluene, ethylbenzene and xylenes (BTEX) in laboratory scale flow-through aquifer columns was tested separately with hydrogen peroxide (110 mg/l) and nitrate (330 mg/l as NO₃⁻) amendments to air-saturated influent nutrient solution. The continuous removal of individual components from all columns relative to the sterile controls provided evidence for biodegradation. In the presence of hydrogen peroxide, the indigeneous microorganisms degraded benzene and toluene (> 95%), meta- plus para-xylene (80%) and ortho-xylene (70%). Nitrate addition resulted in 90% removal of toluene and 25% removal of ortho-xylene. However, benzene, ethylbenzene, meta- and para-xylene concentrations were not significantly reduced after 42 days of operation. Following this experiment, low dissolved oxygen (< 1 mg/l) conditions were initiated with the nitrate-amended column influent in order to mimic contaminated groundwater conditions distal from a nutrient injection well. Toluene continued to be effectively degraded (> 90%), and more than 25% of the benzene, 40% of the ethylbenzene, 50% of the meta- plus para-xylenes and 60% of the ortho-xylene were removed after several months of operation.     

氢电弧等离子体法制备的纳米镍铈粒子的催化特性

利用氢电弧等离子法制备具有储氢特性纳米镍铈粒子，并在气相苯加氢反应中研究了其催化特性，发现其催化活性与储氢特性及表面层中ＮｉＣｅ合金存在有关，且具有高的选择性和热稳定性，这与纳米粒子独特的结构及铈的加入有关。