对HIC试验中两种不同腐蚀介质酸碱度的探讨

HIC是腐蚀试验中常用的检测方法,用来测评材料在含硫化氢环境中对氢离子敏感性大小.其包含两种不同的腐蚀介质,不同的腐蚀介质中酸碱度是不一样的,腐蚀介质的酸碱度对试验结果有较大的影响,为此,运用电离平衡理论,计算并分析两种不同腐蚀介质电离平衡前后的氢离子浓度变化,得出动态反应平衡时氢离子浓度的关系式,从而获得介质中精确的氢离子浓度,并对腐蚀介质中相关离子进行了探讨,为进一步探究相关环境中的腐蚀机理提供了依据.     

吐哈盆地雁木西油田天然气成因分析

雁木西油田所产天然气在吐哈盆地有一定的特殊性，主要表现为含有一定量的硫化氢气体，部分样品的氮气含量高、甲烷含量低、烃类碳同位素值较重，并且重烃碳同位素值发生了倒转。探讨这些特殊性有助于全面认识吐哈盆地的天然气来源、成因与分布规律等，为此在天然气地球化学特征分析的基础上，结合具体的地质条件对天然气的来源、成因进行了系统地分析并取得了如下认识：①雁木西油田的原油溶解气分布在鄯善群和白垩系油藏中，成因上为腐殖型天然气，由烃类和非烃类组成；②烃类气体由甲烷和重烃组成，不同组分的含量与干燥系数均在较宽的范围内变化，但都表现为湿气特征；③非烃类气体主要由N₂、H₂S、CO₂等组成，其中CO₂含量普遍较低；④烃类气体、部分非烃气体及其伴生的原油主要来自侏罗系烃源岩，部分高含量的氮气为大气来源，硫化氢与深部石炭系海相碳酸盐岩有关；⑤部分天然气遭受了次生变化，烃类碳同位素值偏重、重烃碳同位素值倒转均与细菌的生物降解作用有关。     

光纤氢气敏传感器的实验研究

本文介绍一种运用光纤干涉仪及其准外差检测系统对氢气分压强的检测方法。在光纤Mach-Zehnder干涉仪的传感臂上粘接一段长为3cm、厚为100μm的钯片,形成传感元。实验可检测到5×10~2Pa的氢气分压强。     

气相色谱在线分析变压吸附法制纯氢中的总碳

利用带镍加氢转化炉的气相色谱仪 ,在线分析变压吸附法制纯氢中的总碳。该法用变压吸附法制的纯氢作燃气 ,在检测器前端将氢气中的CO和CO2 转化为CH4,然后用氢火焰离子化检测器检测 ,直接以检测器的信号 (mV)进行定量。当氢气中总碳体积分数在 1 9～ 5 0 0 μl/L时 ,FID信号值与总碳体积分数有良好的线性关系。方法回收率为 99 90 %～ 10 1 9%,相对标准偏差 <1%。     

非化学计量LaNi5型储氢合金的性能

采用富La混合稀土与Ni、Co、Mg等元素组合，获得了一种非化学计量LaNi5型储氢合金、用金相、XRD和SEM-EDX等方法分析了该合金的组织结构，研究了合金的气相储氢特性以及电化学性能，结果表明：在1.6MPa氢压和温度29℃下，该合金的储氢量达到1.58%（质量分数），该合金的放电容量为380mAh/g。经300次循环后容量保持率为55%，该合金的基体是CaCu5型结构的LaNi5相，但有第二相（LaMg)Ni3析出，这种第二相的形成是导致该合金大容量的关键。     

Metallurgical failure analysis of cold cracking in a structural steel weldment: Revisiting a classic failure mechanism

Cold cracking of structural steel weldments is a well-characterized, well-documented, and well-understood failure mechanism. Extensive effort has been put forth to recognize the welding and materials selection parameters that are conducive to cold cracking; however, these engineering efforts have not fully eliminated the occurrence of such failures. This article describes cold cracking failure specifically related to the construction industry. This particular failure was successfully identified prior to final erection of the structural member, and the weld was successfully reworked. These actions potentially prevented a serious catastrophic event that could have occurred have occurred either later in the construction process or possibly during the use of the building. Individual welding parameters, such as electrode/wire selection, joint design, and pre/postheating, played a role in the failure, and a number of human factors relating to the actual fabrication practices also contributed to the failure process.     

注入氮离子的SiC涂层阻氢性能研究

利用离子束混合－离子注入（Ar^ ）和磁控溅射相结合的实验技术在HR－1不锈钢基体上制备了注入N^ 的SiC涂层，并用表面分析手段对所制备涂层的表面形貌，剖面形貌、相结构，表面成分，表面元素的化学态进行了分析，结果表明：制备的涂层结构致密，表面平整、膜层成分均匀；涂层与基体之间形成了一明显的过渡层，增强了涂层和基体之间的结合力，用二次离子质谱（SIMS）对充氘涂层的阻氢性能进行了定性分析，结果表明，涂层元素与氢形成稳定的化学键，抑制了氢的扩散和迁移，使得涂层具有一定的阻氢能力。     

An IR study on ion-specific and solvent-specific swelling of poly(N-vinyl-2-pyrrolidone) gel

Swelling degrees of poly(N-vinyl-2-pyrrolidone) (PVP) gel were measured in aqueous salt solutions and in water/organic solvent mixtures to find marked ion- and solvent-specificities. In order to investigate any correlation of those specificities with hydration or solvation of PVP, IR spectra band of the CO group was monitored by means of ATR method both for PVP gel and the relevant solution systems. Dependence of the peak frequency on the swelling ratio suggested that hydration of PVP carbonyl group in deswollen gel systems is different from that in the corresponding solution systems. In the solution systems, PVP carbonyl band showed a high-wavenumber shift for deswollen systems, which can be well correlated with changes in water proton charge through ionic hydration and with Gutmann's acceptor number of organic solvents. In the deswollen gel systems, the CO band showed a low-wavenumber shift, suggesting a strong hydration or doubly hydrated state. This unexpected behavior was interpreted by assuming an intermolecular hydrogen bond of two carbonyl groups intermediated by water molecules.     

Formation and investigation of epoxy intumescent compositions modified by active additives

Results are reported of research on intumescent composites based on epoxy resin cross‐linked with polyethylene polyamine and containing ammonium polyphosphate and such modifying additives as calcium borate, manganese dioxide, nickel, and chromium, containing tubulenes as gas‐formers and carbonization stimulators. The changes in composition and physicochemical properties of modified compositions under conditions of heat and fire were investigated by X‐ray photo‐electron spectroscopy, atomic force microscopy, and local force spectroscopy. Ammonium polyphosphate mainly stimulates carbonization processes on the inner surface of a bubble being formed during foam coke formation. The introduction of metal‐containing tubulenes leads to the formation of fire‐retardant and low flammability‐compositions with high coke and carbon structures content. The use of calcium borate in the compositions considerably increases the strength of foam coke being formed. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 1477–1483, 2002     

重油催化裂化干气氢提纯技术的开发

石家庄炼油厂和西南化工研究设计院合作开发的中国石化系统第一套利用变压吸附技术进行RFCC干气氢提纯工业试生产装置一年的平稳运行说明：提纯后产品氢纯度达99．9％，回收率大于85％；操作简便灵活；装置负荷弹性裕度大；经济效益显著。实践证明它是一项富有吸引力的新工艺，为重油催化裂化装置的挖潜增效展示了美好的前景。