CuMgAl类水滑石的制备和表征

用盐-碱制备法合成了CuMgAl三元类水滑石化合物。探讨了原料配比、合成方式、水热处理温度和时间对合成过程的影响,筛选出合成HTLcs的适宜条件,并对HTLcs结构的热稳定性进行初步研究。结果表明,制备HTLcs主要取决于pH值,同时由于Cu2+的姜-太勒效应,合成结构单一的CuMgAl类水滑石要求原料配比中n(Cu)∶n(Mg)不得超过1.0,CuMgAl-HTLcs热稳定性较差,300℃焙烧2h结构破坏,600℃开始烧结,在300~500℃之间,随焙烧温度提高所得复合氧化物比表面积增大,最高可达200 m2/g。     

Performance evaluation of a water/silicone oil two‐phase partitioning bioreactor using Rhodococcus erythropolis T902.1 to remove volatile organic compounds from gaseous effluents

BACKGROUND: In the framework of biological processes used for waste gas treatment, the impact of the inoculum size on the start‐up performance needs to be better evaluated. Moreover, only a few studies have investigated the behaviour of elimination capacity and biomass viability in a two‐phase partitioning bioreactor (TPPB) used for waste gas treatment. Lastly, the impact of ethanol as a co‐substrate remains misunderstood. RESULTS: Firstly, no benefit of inoculation with a high cellular density (>1.5 g L^?1) was observed in terms of start‐up performance. Secondly, the TPPB was monitored for 38 days to characterise its behaviour under several operational conditions. The removal efficiency remained above 63% for an inlet concentration of 7 g isopropylbenzene (IPB) m^?3 and at some time points reached 92% during an intermittent loading phase (10 h day^?1), corresponding to a mean elimination capacity of 4 × 10^?3 g L^?1 min^?1 (240 g m^?3 h^?1) for a mean IPB inlet load of 6.19 × 10^?3 g L^?1 min^?1 (390 g m^?3 h^?1). Under continuous IPB loading, the performance of the TPPB declined, but the period of biomass acclimatisation to this operational condition was shorter than 5 days. The biomass grew to approximately 10 g L^?1 but the cellular viability changed greatly during the experiment, suggesting an endorespiration phenomenon in the bioreactor. It was also shown that simultaneous degradation of IPB and ethanol occurred, suggesting that ethanol improves the biodegradation process without causing oxygen depletion. CONCLUSION: A water/silicone oil TPPB with ethanol as co‐substrate allowed the removal of a high inlet load of IPB during an experiment lasting 38 days. Copyright © 2008 Society of Chemical Industry     

镁钴铝类水滑石催化合成安息香甲醚

采用共沉淀法制备了镁钴铝类水滑石化合物(MgCoAl-HTLcs),并用 X 射线衍射、扫描电子显微镜、NH_3程序升温脱附等方法对 MgCoAl-HTLcs 进行了表征,并以 MgCoAl-HTLcs 为催化剂催化苯甲醛与甲醇反应合成安息香甲醚,研究了n(Mg):n(Co):n(Al)、催化剂用量、原料配比、反应温度、反应时间对合成反应的影响。表征结果显示,MgCoAl-HTLcs 的晶相完整,表面主要为弱酸、弱碱性。催化合成安息香甲醚的适宜条件为:MgCoAl-HTLcs 催化剂用量0.10 g(约为原料总质量的0.23%),n(Mg):n(Co):n(Al)=0.4:1.6:1.0,V(苯甲醛):V(甲醇)=3:50,反应温度50℃,反应时间150 min。在此条件下,苯甲醛的平衡转化率达77.49%,安息香甲醚选择性接近100%。为洁净合成安息香甲醚开辟了一条新的途径。     

Mg-Si基热电化合物的研究现状

重点综述了Mg-Si基热电化合物的基本特性，该体系热电材料的制备方法与掺杂改性的研究进展，并提出了要重点解决的问题。     

Xylose-lysine model systems: The effect of pH on the volatile reaction products

Aqueous molal solutions of xylose and lysine (initial pH 4–9) were refluxed either with control of the pH at 5–0 or without pH control (final pH 2–6). Analysis by gas chromatography (GC) and GC-mass spectrometry resulted in the identification of 58 and 28 compounds, respectively, from the two systems. Furans were the main reaction products in both systems and 2-furfural alone comprised 522 and 999 g kg^?1 of the volatiles, respectively, from the systems with final pH values of 5–0 and 2–6. Maintaining the pH at 5–0 resulted in a higher yield and greater numbers of nitrogen-containing compounds, and monocyclic pyrroles, pyridines and 2,3-dihydro-l H-pyrrolizines were identified only in that system. Aliphatic compounds, alicyclic compounds, benzene derivatives. l-(2–furfuryl)pyrroles and pyrazines were also identified. This investigation is the first report of the formation of 2.3-dihydro-l H-pyrrolizines in a model system containing lysine as the amino compound; a possible mechanism is proposed.     

Preparation and characterization of organic-inorganic poly(ethylene glycol)/WS2 nanocomposite

Layered nanocomposite PEG/WS₂, intercalating oligomeric poly(ethylene glycol) (PEG6000) into the tungsten disulfide host galleries, was synthesized using the exfoliation-adsorption technique. X-ray diffraction revealed that the intercalated oligomer within the host galleries is in a double-layer arrangement with an interlayer expansion of about 8.8 Å. The optimum conditions were explored to prepare the single-phase product with a composition of Li_0.12(PEG)_1.51WS₂. Thermal analyses suggested that the resulting material shows good thermal stability, with the decomposition of the interacted oligomeric chains within the disulfide galleries occurring at around 258 °C. Despite high conductivity of the host material, those of the PEG/WS₂ nanocomposite were found to be high in the order of 1 × 10⁻² S cm⁻¹ at ambient temperature, resulted from the host guest-host charge transfers.     

蒸发油气污染的生物控制技术探讨

生物降解气态有机污染物的研究是近年来发展起来的大气污染控制新领域。通过介绍生物降解气态有机污染物的基本原理，探讨石油储运过程中的蒸发油气污染运用生物控制技术的可行性，提出需要解决的问题和研究的重点。