高压玻璃钢管道的研制及在油田中的应用

本文介绍了高压玻璃钢管道的特性及在我国油田的应用情况。     

气体加速泵排水采气工艺技术应用与展望

介绍气体加速泵的结构、工艺原理及现场试验情况.通过室内实验和研究,并在蜀南气矿S1、S2井进行了先导性试验,对其在有水气田的应用作出了适应性评价.     

KZON-50/120空分设备的安装调试及设计改造

在KZON-50/120空分设备的安装调试和试运行过程中,对其机械和电器部分进行了多处改造,克服了原设计中存在的不足之处。改造后,机械和电器性能更加趋于合理,操作简单,便于维护,降低了制气费用,提高了制气纯度和经济效益,保证了空分设备更加安全可靠运行。     

磁场对泡沫钻井液电导率的影响研究

磁处理技术是利用磁场对非铁磁性流体作用．使被作用物的性质产生某些期望的变化，从而改善生产效果和使用效益。磁处理对常规钻井液流变性能的影响研究结果表明，磁化能明显改善钻井液性能。通过研究磁化后泡沫钻井液的性质．测定与控制钻井液的电导率，以便从电测曲线上取得更好的地层特性评价。泡沫钻井液的电导率与密度基本呈线性关系，电导率随密度的升高而变大；磁处理后泡沫钻井液的性质发生明显改变．泡沫钻井液的电导率有不同程度的下降，在磁场强度为100mT、蜂数为2的磁场条件下泡沫钻井液的电导率变化率降低最大，电导率平均下降16％左右。     

A continuum-based modeling of MEMS devices for estimating their resonant frequencies

A continuum-based modeling of coupled electrostatics-structure interactions is presented for the frequency computations of MEMS devices. The present general formulation of electrostatics accounting for free space is validated first by specializing it to one-dimensional uniform motion of conducting surfaces and comparing the resulting electrostatics to conventional lumped models. The general coupled electrostatics-structure interactions are then applied for the prediction of resonant frequencies of MEMS devices due to bias-voltage changes and temperature variations. Comparisons of predicted resonant frequencies obtained by the present coupled electrostatics-structure interaction models with experimental results available in the literature demonstrate that the proposed continuum-based interaction modeling yields high-confidence predictions of resonant frequencies of MEMS devices.     

Holographic polymer‐dispersed liquid crystal fabrication under electric field

The transmission mode of holographic polymer‐dispersed liquid crystals (HPDLCs) was developed an under electric field. It is reported that orientation of LC molecules under an electric field induces orientation of oligomer molecules giving rise to low off‐state diffraction and small grating shrinkage. Copyright © 2005 Society of Chemical Industry     

场激活加压燃烧合成WC-Ni复合材料的工艺参数研究

以钨、碳和镍为原料,在电场激活下,材料的燃烧合成和致密化同时进行,短时间内完成了碳化钨镍复合材料的制备。研究了场激活 加压燃烧合成中的工艺参数,如脉冲电流、能量控制模式、升温速率、最高温度和压力对反应的影响。测量了在反应合成和致密化前后的样品 收缩率。所制备的复合材料的相对密度,490N载荷下Vickers硬度和断裂韧性分别为99.2%,13.965GPa和5.9MP·m1/2。     

温度场有限元分析的接缝单元

目前混凝土坝的仿真分析正从单坝段仿真向全坝仿真发展,因而需要采用接缝单元,笔者给出三种温度场接缝单元的计算模型：有限厚度接缝单元、近零厚度接缝单元及简化接缝单元.     

Electrical conductivity of ferroelectric sodium vanadate,rubidium vanadate,cesium vanadate and their solid solutions

The d.c. electrical conductivity of sodium vanadate, rubidium vanadate, cesium vanadate and their solid solutions sodium-rubidium vanadate and sodium-cesium vanadate were studied by a two-probe method in the temperature range covering their transition points. The electrical conductivity shows sharp change at the phase transition temperature of these materials. In NaVO₃, RbVO₃ and CsVO₃, increase in d.c. conductivity is observed in the ferroelectric region while nonlinearities are observed above transition temperatures. In solid solutions, the activation energy in the paraelectric state is higher than that in the ferroelectric state and depends upon sodium concentration.     

The solution of the inverse problem of gravitational potential using a set of measurements of different field elements

A numerical solution of the inverse problem of the gravitational field at a single point is obtained using six field elements for a point, a spherical cap, a differential spherical sector and a vertical segment. In the system of six equations obtained, the unknowns are the mass of the body, the depth of its center, and the second, third, and fourth degree moments. The accuracy of the solution of this system is ten times higher than when using three field elements. __________ Translated from Izmeritel’naya Tekhnika, No. 5, pp. 3–8, May, 2007.