Catalytic properties and electronic structure of copper ions in Cu-ZSM-5

The effect of ion exchange conditions, such as Si/Al ratio, precursor copper salt, pH and concentration of the solution, on the catalytic activity in SCR of NO by propane and on the electronic state of copper ions in Cu-ZSM-5 has been studied. The NO conversion in NO SCR by C₃H₈ has been found to reach a maximum value at Cu/Al ratio about 0.37–0.4 and remain constant at higher Cu/Al.

ESR and UV–vis DR spectroscopy have been used to elucidate stabilization conditions of copper ions in Cu-ZSM-5 zeolites as isolated Cu²⁺ ions, chain copper oxide structures and square-plain oxide clusters. The ability of copper ions for reduction and reoxidation in the chain structures may be responsible for the catalytic activity of Cu-ZSM-5. These transformations of copper ions are accompanied by the observation of intervalence transitions Cu²⁺–Cu⁺ and CTLM of the chain structures in the UV–vis spectra.     

国有公路运输企业改革创效的现实选择

通过对公路运输企业经营实践的考察 ,介绍了国有公路运输企业改革创效的一些现实选择 ,以供运输公司经营借鉴 ,从而摆脱困境 ,取得良好业绩     

Impact of the addition of an enzyme pool on an activated sludge system treating dairy wastewater under fat shock loads

BACKGROUND: The application of lipase‐rich enzyme pools (such as the crude solid enzymatic preparation (SEP) obtained from Penicillium restrictum solid‐state fermentation of agro‐industrial wastes) to activated sludge systems may be an effective strategy for preventing various operational problems. The continuous addition of SEP to the treatment system can become cost‐prohibitive when in situ production and/or storage are factored in. The application of SEP to high‐fat wastewater treatment would only be justified as an emergency measure, such as a sudden increase in the fat content of the bioreactor influent. Therefore, the primary objective of this work was to investigate the efficiency of a crude SEP during fat shock loads, simulated through the periodic addition of dairy industry waste containing high fat concentrations to the feed stock of an activated sludge system, operated in continuous mode. RESULTS: The test bioreactor exhibited a higher average chemical oxygen demand (COD) removal efficiency than the control bioreactor (83% for control and 90% for test) and the fat accumulation in the biological flocs of the test bioreactor was 3.2 times lower than that in the control bioreactor. Turbidity was also lower in the effluent of the test bioreactor (123 and 66 FTU in control and test, respectively) and it had a shorter recovery time between shock loads, especially when the interval between loads was shorter than one month (biweekly and weekly shock loads). CONCLUSION: The addition of SEP during fat overloads in the reactor feed maintained efficient COD removal in the test bioreactor for 270 days without any operational problems. Copyright © 2008 Society of Chemical Industry     

欠驱动系统Pendubot的模糊控制策略

本文针对欠驱动Pendubot机器人系统，提出一种简单可靠的摇起及平衡控制策略。通过利用模糊控制及全状态反馈控制技术来分别设计摇起控制器及平衡控制器，其中模糊摇起控制器的设计使得系统的摇起可靠性得到大大的加强，并缩短了响应时间，两个控制器的转换通过转换装置实现。最后的仿真结果验证了算法的有效性。     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

Different insights for improving part and system reliability obtained from exactly same DFOM “failure numbers”

Techniques for improving the reliability and maintainability of both nonrepairable and repairable items can be suggested by failure data analysis. It is shown that a given set of failure numbers leads to very different improvement strategies when the numbers are the times-between-successive-failures of one or more repairable items, rather than the times-to-failure of nonrepairable items. Since this should have been obvious more than 50 years ago, at the onset of formal reliability engineering activities, several reasons are proffered for the widespread and protracted misinterpretation of even the most basic—and simple!—conceptual and practical differences between nonrepairable and repairable items.     

金的分离富集

综述了金的分离和富集方法，主要包括各种吸附和萃取方法。采用活性炭和泡沫塑料(简称泡塑)吸附分离金是传统的分离富集法，有负载活性炭和有负载泡塑可以提高富集金的能力。近些年，离子交换树脂和离子交换纤维素在分离富集金的应用中，占有相当大的比例。萃取法除了使用传统的MIBK作为萃取剂，又见报道硫醚、亚砜、醇类等作为萃取剂的各种萃取体系。中引用参考献107篇。     

矿石中金的快速测定

研究了活性炭纤维滤布富集分离的条件和解脱方法,并利用微波溶样、液珠萃取比色法测定矿石中的金。该方法的测定范围为(0.5~xx)×10-6,相对标准偏差RSD为3.2%,可用于矿石中金的野外快速测定。     

难处理金矿石加石灰焙烧焙砂中CaS的消除

介绍了用空气氧化预浸加石灰焙烧焙砂中的CaS，以消除其对金氰化的影响。预浸后金的氰化浸出率可从58％提高到80％以上。     

多台并行随机CIMS可靠性的扩散估计界

ＣＩＭＳ可靠性模型随机研究的突出特点是工作站的并行结构使系统的状态个数呈现指数级增大，同时，并行结构与有限的缓冲库相互交织在一起，这使系统状态呈爆炸趋势，显然，对系统作精确的分析与系统呈现的状态爆炸趋势构成了难以解决的矛盾，如何解决这一矛盾正是ＣＩＭＳ随机理论有待开发的重要课题。我们把扩散近似方法引入到多台并行的ＣＩＭＳ可靠性模型中，以简单的连续过程描述了具有状态爆炸趋势的复杂离散过程，给出了ＣＩ