太原精神病院污水处理系统改建为中水处理系统的工程设计

太原精神病医院将现有生活污水处理系统改建为中水回用系统,平均日处理水量100 m3.工程设计充分考虑了对原有设施的利用,生物处理单元采用生物接触氧化法.为减少污水提升次数,调节池设在生物处理单元之后.通过延长水力停留时间缓解水量、水质波动对沉淀、生物处理单元的不利影响,投入运行后效果良好.     

Using a multicultural lens to understand illnesses among Haitians living in America.

Currently, ethnic and racial minority individuals represent a large proportion of the U.S. population, and researchers expect that they will represent the majority of the population by 2050. This shift in U.S. demographics calls for a greater awareness and integration of cultural issues into the assessment and treatment of ethnically and linguistically diverse clients. This article examines the unique beliefs and manifestations of illnesses among Haitians in connection with the American Psychological Association's (APA, 2002) Multicultural Guidelines. The authors use a common culture-bound syndrome, Séizisman, to illustrate the cultural beliefs, assessment, and treatment of illnesses among Haitians. In so doing, they demonstrate how to incorporate the APA Multicultural Guidelines into treatment with clients of diverse cultural and racial backgrounds. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

轻质滤料滤池的试验与研究

轻质滤料滤池是以比水密度略小的滤料为滤床的滤池，通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象，所取得的结果表明：下向流轻质滤料滤池对浊度和悬浮固体（SS）的去除率分别可以达到80％和45％，而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。     

Al2O3陶瓷激光铣削试验研究

采用Nd∶YAG脉冲激光器对Al2 O3陶瓷进行铣削加工试验。系统研究了工艺参数对铣削量和铣削面质量的影响规律 ,并利用优化的铣削工艺对Al2 O3陶瓷进行多种形状的铣削加工。     

简化形式的系统EMC预测分析技术概述

本文探讨了系统级简化形式的电磁兼容性预测分析方法，该方法对于只有几对发-收干扰对的系统EMI的预测分析简洁有效，它避免了大系统间繁复的建模与大量的数据采集及其计算工作，从而对于只考虑其结果的系统间的EMC预测分析提高了效率。     

炼油达标污水回用处理试验研究

采用曝气生物滤池、多介质过滤、超滤、反渗透工艺,对炼油达标外排污水进行回用处理中试试验。结果表明,曝气生物滤池对油、COD和浊度去除效果良好,超滤、反渗透膜化学清洗周期达到 2个月以上,脱盐率稳定在98％以上,产水品质达到回用要求。     

Study on Hydrocracking of VGO Derived from Kazakhstan-Russian Mixed Crude

1 Introduction With the successful completion of the construction of the China-Kazakhstan oil pipeline the refinery at Dushanzi Pet- rochemical Company will process the Kazakhstan-Russian mixed crude at full steam starting 2007. The high sulfur, nitro- gen and heavy metals contents in the Kazakhstan-Russian mixed crude would have a serious impact on the secondary processing units of the Dushanzi refinery, in particular on the distillate hydrocracking unit, which mainly operates on vacuum g…     

Fast handoff with reducing waste rate approach for wireless resources management in UMTS mobile networks

3G Wideband CDMA systems adopt the Orthogonal Variable Spreading Factor code tree as the channelization codes management for achieving high data rate transmission in personal multimedia communications. It assigns a single channelization code for each accepted connection. Nevertheless, it wastes the system capacity when the required rate is not powers of two of the basic rate. One good solution is to assign multiple codes for each accepted connection but it causes two inevitable drawbacks: long handoff delay and new call setup delay due to high complexity of processing with multiple channelization codes, and high cost of using more number of rake combiners. Especially, long handoff delay may result in more call dropping probability and higher Grade of Service, which will degrade significantly the utilization and revenue of the 3G cellular systems. Therefore, we propose herein an adaptive efficient codes determination algorithm based on the Markov Decision Process analysis approach to reduce the waste rate and reassignments significantly while providing fast handoff. Numerical results demonstrate that the proposed approach yields several advantages, including the lowest GOS, the least waste rate, and the least number of reassignments. Meanwhile, the optimal number of rake combiners is also analyzed in this paper. This research was supported in part by the National Science Council of Taiwan, ROC, under contract NSC-93-2213-E-324-018.     

渣油胶质和沥青质在分散型催化剂作用下的临氢热反应行为

采用四组分法从辽河减压渣油中分离出胶质、沥青质，分别考察了它们在分散型催化剂作用下的临氢热反应行为。结果表明，胶质、沥青质一方面要裂化生成较轻的产物；另一方面也要发生缩合反应生成较重的反应产物以及甲苯不溶物。渣油在临氢热反应过程中，沥青质是生焦的主要来源，其次才是胶质。比较了热反应生成的沥青质与原生沥青质之间以及热反应生成的胶质与原生胶质之间化学组成的区别，结果表明，反应生成的沥青质和胶质较原生的沥青质和胶质分子结构缩合程度高，并且反应苛刻度越高，缩合程度也越高。     

基于中压加氢改质方案的炼油流程协同优化

中国石化北京燕山分公司(简称燕山分公司）为增产高附加值产品、提升效益，对炼油系统进行了流程协同优化。中压加氢裂化装置掺炼催化裂化柴油，由加氢裂化方案改为加氢改质方案运行，将改质柴油送入三号催化裂化装置（简称三催化装置）的提升管进行回炼；同时，将焦化蜡油改入加氢裂化装置进行加工，而蜡油加氢装置不再加工焦化蜡油以改善催化裂化原料。协同优化后，中压加氢改质装置的柴油产品十六烷值提高7个单位；三催化装置的液化气收率提高1.96百分点，汽油收率增加0.88百分点，总液体收率增加2.28百分点；高压加氢裂化装置喷气燃料产品的密度（20 ℃）降低至806 kg/m3，烟点为23.8 mm，尾油BMCI由11.8降低至10.8；蜡油加氢装置精制蜡油的饱和分质量分数提高4.68百分点，芳香分质量分数降低5.96百分点，氮质量分数降低0.06百分点，使催化裂化原料性质得以改善。通过将中压加氢改质装置的喷气燃料馏分抽出送催化裂化装置回炼，与回炼改质柴油相比，催化裂化汽油的研究法辛烷值（RON）增加1.0个单位，改质柴油十六烷值提高4.8个单位。通过全炼油板块系统性优化，燕山分公司车用柴油产品的十六烷值由53.5降低至51.5，解决了质量过剩问题。