锅炉过热器/再热器管道热流密度的评估方法

通过建立数值模型进行编程计算,分析了锅炉过热器/再热器管道在不同的管道几何尺寸、烟气温度、蒸汽流量和温度下,各个界面热流密度的变化情况。通过回归分析得到了热流密度与管道内壁侧氧化层厚度和运行时间的关系表达式,即热流密度的评估关系式。     

金属化合物在分子筛上自发分散的研究进展

金属盐和氧化物在分子筛孔穴中及内外表面自发形成原子水平的分散,这种自发分散现象已被多种现代仪器分析所证实，并在国内外得到广泛认同。总结相关文献，结合部分研究工作，对金属化合物在分子筛上自发分散的研究作了综述。     

氧化亚铜微米晶的水热合成与生长机理

氧化亚铜是一种重要的P型半导体材料，目前因其独特的可见光催化性能在科研领域引起了广泛的重视。以CuSO4·5H2O为铜源，以α—D-葡萄糖为还原剂，并利用水热还原反应合成出了不同形貌的Cu2O微米晶。利用X射线粉末衍射分析（XRD）、透射电子显微镜（TEM）对合成的样品进行了形貌与结构的表征与分析。结果表明所合成的晶粒尺寸均匀且分散性好。讨论了不同条件下的晶粒生长机理，运用扩散机制与聚集机制解释了不同形貌的成因。     

基于Internet的空分设备远程监视与故障诊断专家系统的研究

简介了远程监视与故障诊断专家系统在国内空分设备中应用的实际意义，着重分析了大型空分设备远程监视与故障诊断专家系统中远程监视模块和故障诊断模块的开发。     

Comparison of structural and photoluminescence properties of ZnO thin films grown by pulsed laser deposition and ultrasonic spray pyrolysis

ZnO thin films have been deposited by pulsed laser deposition (PLD) and ultrasonic spray pyrolysis (USP) method, respectively. X-ray diffraction and transmission electron microscopy characterizations indicate that ZnO film grown by PLD exhibits better crystallinity than that grown by USP. Photoluminescence spectra show that the near-band edge ultraviolet emission of film grown by PLD is narrower and shifts to higher energy, compared with that of film grown by USP. In the visible range, ZnO film grown by PLD exhibits four local level emission centered at 470 nm, 486 nm, 544 nm, and 613 nm, respectively, while the film grown by USP only presents a weak broad band emission centered at 502 nm. Hall measurement shows higher carrier density and lower hall mobility in ZnO film grown by PLD than that in film grown by USP. The higher density of intrinsic defects as well as higher crystallintiy is considered to account for the difference of photoluminescence in ZnO film grown by PLD with that in film grown by USP.     

大量程步进式垂线坐标仪的研制

步进式变形监测仪器具有长期测量、测值稳定、可靠性高、测试原理简单、适用范围广等优点，在中国的大坝安全监测领域得到了广泛应用，但大量程步进式变形监测仪器的研制很难。文中介绍了一种新型步进式垂线坐标仪，该垂线坐标仪在引入独特的结构设计、先进的电子测量技术和优化的电机驱动控制策略的基础上，很好地解决了大量程工况下的高精度测量问题。     

Characteristics of Metal Droplets in Slag Tapped from the Blast Furnace

Slag samples, hot‐metal samples and hot‐metal temperatures were obtained during tapping of two blast furnaces. Sampling was carried out at different time points during tapping of three separate heats. The size distribution and composition of metal droplets found in the slag were determined using scanning electron microscopy. Only metal droplets above 0.75 μm could be counted and analysed. All droplets were below 8 μm in diameter and the great majority of these droplets were found to be between 0.75 and 2 μm. The size distribution did not differ significantly for different slag samples. Iron was the main droplet component. Electron probe microanalysis showed that the droplets contained small amounts of carbon. The percentage of the area in a studied cross‐section that was covered with metal droplets varied between 0.01 and 0.07%. Calculations based on Stoke's law showed that the distance droplets travel in the slag is in the micron range. Slag samples taken in the beginning of slag tapping contained more droplets than those taken in the middle of slag tapping, an indication that most droplets can be found in the area near the furnace wall. Some droplets were determined to have magnesium enrichment at the external surface.     

闽江口湿地遥感影像最佳景观观察尺度的选择

应用遥感和地理信息系统技术,对景观最佳观察尺度选择的方法进行了探讨;构建了“定量化景观指数粒度敏感区间,定性化尺度大小,定性与定量相结合决定最佳观察尺度值“的最佳景观观察尺度选择模式,并以ASTER遥感影像为数据源,应用该模式对闽江口湿地景观最佳观察尺度进行了研究,指出闽江口湿地的景观观察尺度应以50m和100m为主,最大尺度不应超过200m.