Galvanic corrosion over a semi-infinite, planar surface

We derive the governing equations for the galvanic coupling of two dissimilar materials in a planar surface wherein the transport phenomena in the liquid phase are controlled by ionic migration or diffusion. The problem statement corresponds to two semi-infinite materials located in the same plane and coupled along a single boundary, resulting in a two-dimensional analysis. A single dimensionless group arises in the analyses of the corrosion problems, which greatly simplifies the presentation of numerical results and subsequent implementation. An example application of this work is presented that demonstrates how the results can be used to set requirements for protective films (e.g., paint) utilized for reducing corrosion rates.     

咪唑啉缓蚀剂工艺条件优化及效果

在减缓金属腐蚀的研究中,为了缓解在酸性溶液、碱性溶液以及大气、土壤等介质中金属腐蚀较为严重的问题,对咪唑啉类缓蚀剂进行了工艺条件优化.采用静态失重法研究了碳钢在加入了缓蚀剂的盐酸溶液中的缓蚀性能.在最佳合成条件下苯甲酸与二乙烯三胺最佳摩尔比为1∶1.3,催化剂质量分数为1.2%,环化时间为1 h,咪唑啉中间体与氯化苄的最佳摩尔比为1∶1.1,季铵化反应时间为1 h,季铵化反应温度为70 ℃,缓蚀剂的最佳质量分数为1%,最终缓蚀率可以达到99.37%.     

Corrosion resistance of electroplated Zn-Co alloy coating

By the NSS test and the test in SO2 gas atmosphere and detecting the φcorr-t curves, Rp-t curves and the cyclic voltammogram curves, the corrosion resistance of the electroplated Zn-Co alloy coating was studied. The corrosion resistance of the electroplated Zn-Co alloy coating is three times higher than that of the galvanized coating. Because the corrosion resistance of the Zn-Co alloy coating is especially remarkable in SO2 gas atmosphere, it is particularly fit to be used as a protective coating in industrial atmosphere. The reason why the Zn-Co alloy coating has such a high corrosion resistance is that its corrosive product has a comparatively great role in depressing the corrosive process.     

船舶腐蚀与防腐涂装的特点

本文论述了船舶腐蚀与防腐涂装的特点，工艺及配套。     

关于输气管线内衬聚乙烯管可防止其腐蚀的商榷

本文参照德国一实例，即利用多种类型PE衬层，在一定温差及有气体扩散阻挡层和无气体扩散阻挡层的条件下，详细地叙述了高压酸性气体对其进行长期渗透作用的试验。结果显示：水蒸气和腐蚀性气体（如H2S）的渗透作用是不能忽视的，甚至当PE层为5mm时亦有一定渗透性；此外，在衬层底部尚产生了化学腐蚀作用，从而促使人们必须考虑须正确选择PE下边的防腐底层。     

超临界CO2对钢材的腐蚀实验研究

采用静态高温高压釜及SEM现代分析测试手段,在分析超临界CO2存在形式及与原油、水交互作用的基础上,进行了超临界CO2对钢材的腐蚀实验研究。结果表明,在腐蚀系统SCF-CO2气相中,存在CO2腐蚀现象;液相中,腐蚀速率随压力增加而上升,12MPa达到峰值后下降。在纯水中12MPa时,液相和气相中的腐蚀速率趋于一致,腐蚀形貌表现为腐蚀瘤。30％的原油含量可在液相促进钢材腐蚀。腐蚀形貌表现为腐蚀瘤与腐蚀坑并存;但随含油量增加,会抑制钢材腐蚀。     

红柱石在烧结刚玉基窑口浇注料中的应用

以烧结刚玉、碳化硅等为主要原料,分别以红柱石0%、5%、10%、15%替换相同比例的烧结刚玉,同时外加少量的改性剂A制备四组浇注料,对比四种浇注料经1 400 ℃处理后的常温性能、线变化、抗热震性、抗碱侵蚀能力。结果表明,添加红柱石10%和改性剂1%的烧结刚玉基窑口浇注料表现出较好的使用性能。     

The generation of surface roughness during slurry erosion-corrosion and its effect on the pitting potential

Results of experiments performed to isolate the effect of surface roughness generated during slurry erosion-corrosion of 304L stainless steel are presented. Surfaces prepared by grinding to different finishes show that increasing the roughness lowers the pitting potential in chloride solution. Subsequent erosion by an aqueous sand slurry then alters this pitting potential (E_p), as measured in the solution phase alone, in a manner dependent on the initial surface roughness. Surfaces which were initially rougher show a pronounced rise in _p after erosion, while those with an initially smoother finish show a fall in E_p after erosion. Measurement of E_p during erosion-corrosion does not fit either process, with values of _Ep lower than those predicted from the surface roughness alone.     

Effect of ammonia concentrations on SCC of α-brass under mode III loading

Stress corrosion cracking (SCC) of α-brass in ammonia solution was studied under mode III loading. The results showed that SCC occurred on the principal stress planes where shear stresses are zero. No SCC occurred on the maximum shear stress plane. Ammonia concentration affected fracture behaviour. When the concentration was low, many cracks with spacing of 10–150 μm were found on 45 ° planes, i.e., the principal stress planes. When the concentration was high, the cracks on 45 ° planes were not clearly visible because of serious general corrosion.     

铝-锂合金腐蚀性能研究综述

综述了铝-锂合金孔蚀、晶间腐蚀、应力腐蚀断裂(SCC)及剥蚀的研究现状。阐述了加工状态、热处理、显徽组织及腐蚀介质对一些铝-锂合金孔蚀及晶间腐蚀行为与SCC敏感性的影响及其影响机制．同时报道了一些研究铝-锂合金剥蚀的新方法，并提出了进一步研究的方向．