Machinability of Metal Matrix Composites Reinforced by 3-D Network Structure

Metal matrix composites reinforced by three-dimensional (3-D) continuous network structure reinforcement (3DCNRMMC) are difficult to machine due to serious tool wear and poor surface roughness caused by the brittle and hard reinforcement which interpenetrate into ductile matrix. In order to achieve the approach of low cost of 3DCNRMMC, the machinability of it needs to be understood. The influences of three cutting parameters and volume fraction of reinforcement on cutting force were analyzed in detail. The results indicate that: (1) Due to the brittle phase(s) introduced into ductile matrix of composites, there is a large fluctuation of cutting force causing deterioration of machinability. The fluctuation ranges of cutting forces, initially increase rapidly with the increase of volume fraction of reinforcement and then decrease finally, are largest at the range of the volume fraction of 55–65%; (2) The influence of cutting parameters on cutting force is obvious. With the increases of cutting speed, cutting force decreases gradually unless cutting speed exceeds the value of 209 m/min. Cutting forces increase with increasing feed rate and depth of cut; (3) Owing to the large fluctuation of cutting force, there were some cratered surfaces caused by Si₃N₄ reinforcement pulling-out and flaking-off. Some brittle phase protruding from the machined surface caused the deterioration of machined surface.     

一种环保化学储能电池——钒氧化还原液流电池

可再生能源需要性能优良的储能电池与之配套，因此，研究和开发价廉、高效率的储能系统是十分必要的。本文通过介绍钒氧化还原液流电池的原理和特点，指出钒电池是一种潜力巨大的新型环保储能电池。同时介绍钒电池制备和应用时的三大技术关键及一定的解决方法。     

基于单片机的家用电器远程电话控制系统的实现

通过对“家用电器远程电话控制系统”的介绍,系统阐述一种基于AT89C51单片机的远程控制系统的设计、应用思路,将它推荐给各位同行、学生参考。同时,将芯片MT8870和ISD1400的关键功能以及应用做一些简明扼要的介绍。     

双馈发电系统中电网侧高频整流器的研制

基于三相PWM高频整流器的数学模型,详细分析了双馈发电系统中电网侧整流器的双闭环控制原理和单位功率因数的实现方法。在此基础上设计了一套整流装置,可以单位功率因数运行在整流和逆变状态下,能够实现能量的双向流动,实验结果表明该整流装置具有良好的动、静态特性。     

New Application of Stainless Steel

Several rigid substrates such as stainless steel, titanium alloy, aluminum alloy, nickel foil, silicon, and sodium lime glass have been employed for manufacturing high quality TiO2 films by metal organic chemical vapor deposition （MOCVD）. The as-deposited TiO2 films have been characterized with SEM/EDX and XRD. The photocatalytic properties were investigated by decomposition of aqueous orange Ⅱ. UV VIS photospectrometer was employed to check the absorption characteristics and photocatalytic degradation activity. The results show that films synthesized on metal substrates display higher photoactivities than that on absolute substrates such as silicon and glass. It is found that solar light is an alternative to UV-light used for illumination during photodegradation of orange Ⅱ. TiO2 film on stainless steel substrate was regarded as the best one for photocatalysis.     

攀钢1450mm热连轧机层流冷却控制系统的开发及应用

阐述了攀钢1 450 mm热连轧机层流冷却控制新系统的开发与应用。该系统采用α机过程控制系统,通过预设定、在线前馈和自适应三大功能,对层流冷却模式、冷却速率和最终卷取温度进行控制,卷取温度控制精度较原系统有较大提高,±20℃的命中率由原来的88.6%提高到现在的96.4%。     

65Mn热轧窄带钢的试轧

介绍了天津钢铁有限公司带钢厂开发带钢新品种,用65Mn弹簧钢试轧优质碳素结构钢钢带的工艺情况。总结了试轧过程存在的问题,提出了改进措施。     

特高压通道降压运行时安徽500kV西通道建设必要性分析

根据华东1000kV特高压输电通道初期降压运行的统筹安排，结合淮南煤电基地电源、平圩电厂二期及蚌埠电厂等电源的装机进度，通过对各电源接入系统方案的计算分析，最后得出结论：为保证江北地区电力送出，安徽500kV西路过江通道在“十一五”期间建成是有必要的。     

Flume Experiment on Stream Blockage by the Debris Flow From Tributary

Stream blockage by the debris flow from tributary valleys is a common phenomenon in mountainous area,which takes place when large quantities of sediment transported by debris flow reaches a river channel causing its complete or partial blockage.The dam formed by debris flow may causes upstream and downstream flooding,and presents great threat to people and property.Because of the catastrophic influence on people and property,debris-flow dam has attracted many attentions from the researchers and local administration.But,lit- tle attention has been given to the quantitative interrelationships of the potential influential factors.In this pa- per,the interrelationships of important influential factors caused the stream blockage by debris flow were ana- lyzed through flume experiment,and a model to predict the blockage was presented.