二次盐水及离子膜电解工序常见问题简析

介绍了二次盐水及离子膜电解工序的主要设备和流程,对二次盐水及离子膜电解工序运行中出现的问题进行了分析,并提出了解决措施。     

水浴法加温液氧泵

1　故障现象一次 ,我们用KL -1 5型制氧制氮车开机制氮 ,给一只容积为 40升、最高工作压力为1 4 7MPa的气瓶灌充氮气 ,当气瓶充气压力升高到一定值时不再上升。反复开泵 ,压力基本不变。液氧泵停止时 ,出口压力无明显下降。经分析判断导致气瓶压力升高到一定值时不再上升的原因是由于液氧泵被冻结所致。2　排除方法首先关闭液氧泵。拧开制冷机氢气放气阀 ,使压力下降到 1 0MPa。开大放气阀 ,使二级压力保持在 0 3 5MPa左右。调整正流空气调节阀 ,调节好中部温度。关闭液氮进液氧泵阀和气氮出液氧泵阀。戴棉布手套 ,拆开液氮进口接头、…     

不同粒度松散煤体的氧扩散特性实验研究

以自行研制的煤对氧扩散特性测试装置为实验手段,在常温环境条件下测试了不同粒度松散煤体对氧的自由扩散特性.实验结果表明:煤样粒度的变化对取气腔氧浓度流出曲线的影响表现出2个极限值,煤样粒度在20～100目之间时,取气腔氧气浓度梯度随煤样粒度的增大而增大;当煤样粒度<20目或>100目时,煤样粒度的再变化对氧浓度流出曲线的影响则微乎其微;取气腔氧浓度曲线流形基本符合指数曲线的变化规律.     

武钢 10000 m3/h制氧机主冷泄漏故障处理及应急保产方式

氧气生产单位保用户用气一旦出现较为紧张的局面时，如何正确处理保安全生产运行、保用户生产、安排抢修时间三者之间的关系，值得关注与研究。     

氧量分析仪在加热炉上的应用

介绍了仕富梅700B型氧量分析仪在加热炉的成功应用，阐述了设备型号的选择。检测设备的安装位置，环境选择及设备维护均是设备能充分发挥效能的重要环节。     

LaNiO3薄膜热稳定性的研究

LaNiO3导电金属氧化物薄膜在现代应用科学研究中作为电极和过渡阻挡层倍受青睐，它具有很好的导电特性和稳定性。该文采用射频溅射法制备了具有(100)择优取向的赝立方结构LaNiO3-x薄膜，并进行了原位热处理。实验结果表明，在265℃的处理条件下，LaNiO3薄膜表现出不稳定性，晶格中的氧在2h内失去了2.7％。氧的损失对品格结构没有明显影响，但薄膜的导电性能明显下降，折射率和消光系数也具有相同幅度的下降。对薄膜的应用具有一定的影响。该文从LaNiO3薄膜的导电机理方面对实验现象给出了分析和解释。     

Effects of Light, Oxygen, and pH on the Absorbance of 2,2-Diphenyl-1-picrylhydrazyl

ABSTRACT: The absorbance of 2,2-diphenyl-1-picrylhydrazyl (DPPH) at 517 nm in methanol and acetone decreased by 20 and 35% for 120 min at 25 °C under light, respectively; in the dark it did not change significantly for 150 min. Decomposition of DPPH under 21% oxygen after 90 min under light was significantly higher than that under 1% oxygen. Absorbance of DPPH in pH 4 buffer solution in methanol, and in pH 10 buffer solution in acetone, decreased by 55 and 80%, respectively, under light for 120 min. The evaluation of antioxidant activity by the changes of DPPH absorbance should be carefully interpreted since the absorbance of DPPH at 517 nm is decreased by light, oxygen, pH, and type of solvent in addition to the antioxidant.     

焚烧炉控制系统

化工废气、废液焚烧炉是一种常用的环保处理装置，就其工艺详细介绍焚烧炉燃烧过程的控制及其安全联锁措施。     

An analysis of the electrical conductivity in BaSO4-added Ag2SO4 solid electrolyte system

The compositions (1 −x)Ag₂SO₄−(x)BaSO₄, wherex=0·01 to 0·6, were prepared by slow cooling of the melt. The extent of the solid solubility of Ba²⁺ in Ag₂SO₄ was determined by X-ray powder diffraction and scanning electron microscopy. The bulk conductivity of each sample was obtained using a detailed impedance analysis. The partial substitution of Ba²⁺ results in the enhancement of conductivity in compliance with the classical aliovalent doping theory. A simplistic model based on lattice distortion (expansion) due to partial substitution of Ag⁺ by the bigger Ba²⁺ has been considered to explain enhanced conductivity. Beyond solid-solubility limit (5·27 mole%) the BaSO₄-dispersed Ag₂SO₄ conductivity follows the usual trend seen in binary systems. An increase in conductivity in this case is discussed in the light of interfacial reactions and surface defect chemistry. The maximum conductivity in 20 mole% BaSO₄ dispersed Ag₂SO₄ is due to percolation threshold.     

Micellar polymerisation of ionic surfactants studied by conductimetry

The micellar polymerisation of ionic surfactants such as allyldodecyl-dimethylammonium bromide and 3-dodecyl-1-vinyl imidazolium iodide has been studied by conductimetry in aqueous solution. The polymerisation was carried out using two different sources of γ rays directed into solutions of surfactant above the critical micellar concentration. Conductimetry is shown to be a very good physicochemical method for analysis of these solutions. The results showed different behaviour for the two surfactants, which has highlighted a change in the structure of their aggregates which led to the assumption of an interaction between the polymers of high mass and different products of the polymerisation (oligomers, products of degradation, monomers etc.). Ultrafiltration experiments coupled with ¹H-NMR and conductivity analysis confirm these assumptions.