ALKYD PAINT WASTE CHARACTERIZATION AND DISTILLATION

In the present study the characterization and distillation of alkyd paint waste have been carried out in order to establish the technical viability of organic solvents recovery and to decide upon the best environmental management for the waste stream from a paint spray-booth application in an automotive component factory. The paint is a black primer based on an alkyd resin with toluene and xylene as solvents, black carbon as pigment, fillers, and other minor components.

The paint, paint wastes, and distillation wastes have been characterized by determination of the physicochemical properties of the solid (solvents content and flash point) and determination of ecotoxicity (EC₅₀), total organic carbon (TOC), and metals concentration of the leachates. The highly volatile matter (HVM) content, determined by the weight loss at 200°C, has been used as a parameter to relate with the hazardous wastes regulations based on the characterization parameters EC₅₀, TOC, and flash point.

Distillation experiments have been performed in a simple batch mode with mixtures of paint waste, water, and additives in order to obtain high efficiencies in the recovery of volatile organic compounds and to obtain a final solid with nonhazardous behavior and good manageability qualities. A fractional factorial design (2^3-1) of experiments was carried out in order to study the influence of the distillation variables: water/paint waste ratio (2/1-3/1 (g/g)), temperature (110°-145°C), alkaline additives (Na(OH),CaO, Ca(OH)₂), and amount of other additives (wt.% of bentonite, cement, and Ca(OH)₂) on the solvent recovery, [% VOCs]_Recovery, on the residual volatile organic compounds, [% VOCs]_{Distillation Waste}, and on the total organic content (TOC) of the waste leachates. The present work shows the quantitative results of the alkyd paint waste distillation process under optimum conditions.     

γ-Al2O3载体制备中水洗脱氯工艺的连续化

通过正交实验，研究了γ-Al₂O₃载体制备中拟薄水铝石水洗的连续化。方差分析表明，第一阶段洗水的pH是影响脱氯效果的关键因素，初步得出水洗连续化的优化条件。与国内外传统的间歇式水洗相比，收率从80%提高到99.7%，所需洗水量仅为原来的1/3，而处理500 kg物料的生产周期也从10 h缩短到2～3 h。     

环氧-聚氨酯互穿网络防腐蚀涂料

研制的环氧-聚氨酯互穿网络(IPN)防腐蚀涂料具有优异的防腐蚀性能和附着力。介绍了该涂料的制法。列举了IPN涂层的性能指标。讨论了影响涂层性能的各种因素。     

粗四氯化钛除钒工艺现状及发展趋势

概述了使用铜丝、有机物、硫化氢和铝粉4种物质除去粗四氯化钛中的杂质钒方法的优缺点,通过比较指出有机物除钒法和铝粉除钒法是较理想的粗四氯化钛除钒方法。最后,对有机物除钒法目前存在的问题及解决方案进行了分析。     

工业喷漆的环境污染研究

化工企业对环境的影响较大,其制造的化工产品严重威胁着人们的健康。近年来,随着化工企业的规模越来越大,其带来的环境污染问题也越来越严峻。就工业喷漆对环境污染的状况和治理措施进行了分析、探究。     

粗TiCl4除钒工艺探讨

研究了粗TiCl4除钒的工艺过程，通过试验比较了各种有机物除钒的效果，结果表明矿物油除钒性能优异。1t粗TiCl4加矿物油2～4kg，反应温度135～138℃，反应时间60min，收率大于95％，质量达到企业产品标准要求。     

PET金银镀铝膜专用烘烤漆的配方设计

从金银线专用烘漆的工艺和性能要求出发,探讨了聚酯真空镀铝膜(VMPET)烘漆的配方设计的要素,实验优选出氨基烘漆体系,研究表明氨基树脂和成膜树脂是获得高性能烘漆的重要因素,通过优选氨基烘漆配方各组分,可获得具有较高应用性能的金银线专用烘漆。     

Zinc-rich powder coatings characterisation in artificial sea water: EIS analysis of the galvanic action

Two zinc-rich powder coatings are applied onto phosphatised steel substrate and are studied using electrochemical impedance spectroscopy (EIS). Measurements are performed before (dry experiment) and during immersion in artificial sea water. Before immersion, EIS spectra show that percolation threshold is not attained for coating A, while coating B presents an effective percolation. In this latter case, and in order to account for the distribution of the zinc particles within the coating described as isolated, semi-isolated and percolant grains, a distributed transmission line model is proposed. When panels are immersed, the model is modified due to the electrolyte penetration through the coating, in particular with the introduction of an ionic resistance. However, it is shown that EIS spectra are not significantly modified when this ionic resistance is changed.     

怒江漆油中高级脂肪酸成分

对云南怒江漆油 (漆树籽油 )进行皂化得到了漆油的总脂肪酸 ,将总脂肪酸甲酯化得到总脂肪酸甲酯 ,用GC MS联用仪测定了所含高级脂肪酸的成分 ,结果表明云南怒江漆树油中高级脂肪酸分别为棕榈酸、油酸、硬脂酸、花生酸、二十烷二酸。其中 ,棕榈酸的质量分数高达 76.9%。     

高温抗蚀耐磨涂料在循环流化床锅炉省煤器上的应用

通过对山东恒通化工热电厂的6#锅炉省煤器泄漏进行原因分析,提出了锅炉省煤器抗蚀防磨技术的改造方案,在方案中采用了某高新技术公司研制、生产的KM系列高温抗蚀耐磨涂料,实施后效果良好,此方案在热电厂锅炉省煤器,尤其是在循环流化床锅炉省煤器抗蚀防磨方面,具有推广意义。