甲酸甲酯合成与转化的催化技术

本文评述了甲酸甲酯(MF)合成与转化的催化技术,展示了从MF出发发展C_1化学的可能途径,在MF的合成方面详细地分析了从甲醇出发的羰化法、脱氢法和氧化法催化技术,简介了我们的有关研究工作。     

Exploring single electrode reactions in polymer electrolyte fuel cells

Utilising a pseudo-reference electrode in polymer electrolyte fuel cells allows for the separation of anodic and cathodic contributions to the entire cell impedance. Modelling the impedance responses by using equivalent circuits inhibits the investigation of kinetic parameters of the basic electrochemical reactions, which take place at single electrode-electrolyte interfaces. Therefore, we evaluate single electrode impedance measurements by a kinetic model, which is based on specific reaction pathways, either for the oxygen reduction reaction (ORR) or the hydrogen oxidation reaction (HOR). As a consequence, it is possible to obtain kinetic parameters for the specific reaction of interest. Furthermore, the information gained from the single electrode impedance measurements and the kinetic model can give insight into single reactions steps. In particular, the ORR has to include a chemical step in the reaction pathway.     

喷动床反应模型的研究进展

喷动床是一种可实现热量重复循环的高效反应器 .介绍了目前喷动床研究中出现的各种反应模型 ,从等温和非等温两个方面讨论了一维轴向、流管、半分割和流动反应耦合等各类模型的基本思想和理论及各自的特点 ,并提出了进一步发展的方向 .     

Reaction pathways of ethane oxidative and non-oxidative dehydrogenation on γ-Al2O3 studied by temperature-programmed reaction (TP-reaction)

In this work, the reactions of ethane and ethene in an oxidizing and non-oxidizing atmosphere over γ-alumina were investigated under temperature-programmed conditions, in an attempt to estimate the possible contribution and functionality of the support in the reaction pathway of ethane ODH over MoO₃/Al₂O₃ catalysts. The results indicate that alumina contributes to the primary deep oxidation and dehydrogenation routes of ethane to CO_x and coke respectively, which proceed effectively over the acidic OH groups and the Al³⁺–O²⁻ acidic centers. On the contrary, the formation of ethylene seems to be coupled to the presence of redox sites on the catalytic surface and requires the presence of the molybdena phase. Moreover, the redox sites of the MoO_x species were found to unselectively activate the further overoxidation of the olefin to carbon oxides. Therefore, Al₂O₃ catalyzes the unselective primary oxidation of ethane to carbon oxides, whereas the molybdena phase is involved in the selective oxidative dehydrogenation (ODH) of ethane to ethene and the secondary overoxidation of ethene to CO_x.     

Prediction model of compressive strength development of fly-ash concrete

Based on experimental results concerning the compressive strength development of concrete containing fly ash, the authors derived an estimation equation for compressive strength development. The equation can express coefficient , which indicates the activity of fly ash as a binder, in the form of a function of age, fly-ash content, and Blaine specific surface area of fly ash.

This equation is capable of explaining the increases in the early strength due to fly ash in place of part of fine aggregate, the decreases in the early strength due to fly ash in place of part of cement, the increases in the long-term strength due to pozzolanic reaction, the relationship between the fly-ash replacement ratio and the ratio of strength increase/decrease, and the effect of fly ash's Blaine specific surface area on the strength.     

循环式活性污泥法处理炼油污水

研究为在炼油污水的CAST工艺的主反应区中 ,通过恰当控制pH值和DO(污水中溶解氧含量 )值 ,可以使硝化与反硝化反应同步进行 ,在去除COD ,BOD的同时 ,也可提高其脱氮效果 ,从而得出DO的最佳值为 0 .8mg/L ,pH为 7.3～ 7.7之间。     

Modelling the effects of human papillomavirus in cervical cells

Worldwide, cervical cancer is the second most common cancer in women, after breast cancer. The prevalence of this malignant disease is estimated at 1.4 million cases worldwide, causing about 290,000 deaths and 500,000 new cases per year, of which 80% correspond to women living in developing countries. In this work we propose a family of ordered models for basal cells of the cervix corresponding to different stages ranging from normal cells to the formation of precancerous lesions. We analyse the first member of the family analytically and for the second member we developed a non-standard numerical method in order to extract some biological information.     

碰撞式混合器的设计和使用

从反应注射成型过程对混合器的结构设计、操作条件等的要求出发，对碰撞式混合器的设计和使用应注意的问题进行了分析探讨，并提出了相应的解决办法和处理措施。     

Propagation of the Chain Explosive‐Decomposition Reaction in Silver Azide Crystals

The velocity of the chain explosivedecomposition reaction in silver azide whiskes has been measured (1500 m/sec). The measured velocity is identified as the propagation velocity of the diffusion front of holes generated in the course of explosive decomposition.     

Critical evaluation of coupling particle size distribution with the shrinking core model

The shrinking core model (SCM) is widely used to model fluid-solid reactions such as the leaching of metals from minerals. In most cases, however, the particle size distribution (PSD) of the solid material was disregarded. In this paper the erroneous shift in the control regime when neglecting PSD was quantified and the dependence of the shift on the coefficients of variation (CV) and the type of PSD was analysed. By coupling the SCM with a Gamma PSD, it was found that neglecting the PSD would shift the control regime from chemical reaction to inert/ash layer diffusion, when the CV was between 0.7 and 1.2. For a system controlled by liquid film diffusion, neglect of the PSD, would shift the control regime to chemical reaction when CV is between 0.3 and 0.7 or to inert/ash layer diffusion when CV is greater (0.9-1.5). It was therefore postulated that some researchers had unknowingly made invalid conclusions about the control regime due to the neglect of PSD. However, an inert/ash layer diffusion-controlled process was insensitive to the neglect of PSD. When CV<0.3, neglect of the PSD would not cause any erroneous shifts, irrespective of the control regime. Experimental data confirmed the observation. For a given CV, the deviation in the fraction reacted from the mono-PSD increases with CV and decreases with time. The maximum deviation, which occurs at the beginning, is about 10% with a gamma PSD of CV=0.3. The percent deviation is dependent of the type of PSDs. Gamma PSD gives the lowest deviation while Gaudin-Schuhmann results in the largest deviation (maxi. ∼19%, with CV=0.3) in the first half of dissolution process. Log-normal distribution gives a larger deviation than gamma but quickly approaches the latter with time. The deviation for Rosin-Rammler is between log-normal and Gaudin-Schuhmann. For systems with CV less than 0.3, the SCM can be fairly used without considering PSD. When CV is greater than 0.3, particularly in the early stage of a dissolution process with a PSD other than gamma, PSD should be included to avoid substantial errors.