Use of electrodialysis to remove silver ions frommodel solutions and wastewater

The feasibility of the removal of Ag⁺ ions in a model solution and a sample of rinse water provided from an industrial plating plantwas investigated in a batch electrodialysis system. The experiments were carried out using two different types of ion-exchange membranes. The effects of applied potential, pH value and initial silver concentration on the duration of electrodialysis and energy consumption were examined. Full removal of Ag+ ions was achieved from model solutions and the sample of rinse water. The most convenient applied voltage and energy consumption values to remove silver ions are reported. These results will be useful for designing and operating different capacities of electrodialysis plants for recovering Ag⁺ ions.     

Synthesis of fluorine-graphite intercalation compounds by elemental fluorine and high oxidation-state transition-metal fluorides

Fluorine-graphite intercalation compounds have been synthesized using high purity fluorine gas and high oxidation-state transition-metal fluorides, AgF₃ and NiF₃, at room temperature and at −78 °C. At room temperature, a mixture of stage 1 + 2 − 4 compounds with compositions, C_4.2F to C_14.6F were obtained. On the other hand, stage 2–4 compounds with compositions C_5.6F to C_14.2F were synthesized at −78 °C. The fluorinating ability of AgF₃ and NiF₃ has been shown more clearly at room temperature because a small amount of fluorine was intercalated/absorbed into graphite at −78 °C without catalysts. XPS spectra show that ionic, nearly ionic, semi-covalent and covalent fluorines coexist in the C_xF samples, and that the covalency of CF bonding increases with decreasing stage number.     

含氯离子废水化学需氧量分析方法比较

含氯离子废水化学需氧量的分析方法的研究是当前环境监测研究的热点之一，各种文献报道也较多，但各自使用的效果不一。采用试验的方法对含氯离子废水中CODCr的分析进行了初步研究，比较了硫酸汞加入法、稀释法、硝酸银滴定法、氯气校正法、氯离子校正法等方法在不同化学需氧量不同氯离子浓度下的分析结果，利用分析结果与配置的标准溶液浓度相比较，分析了各种方法的优缺点，结果表明硝酸银滴定法是比较理想的适应范围较广的方法。     

粗TiCl4除钒工艺探讨

研究了粗TiCl4除钒的工艺过程，通过试验比较了各种有机物除钒的效果，结果表明矿物油除钒性能优异。1t粗TiCl4加矿物油2～4kg，反应温度135～138℃，反应时间60min，收率大于95％，质量达到企业产品标准要求。     

Sorption of Cr(III)‐containing cations on strongly basic anion exchangers

It is shown that strongly basic anion exchangers AV‐17 and Varion‐AD in definite conditions are able to retain Cr(III)‐containing ions from Cr(III) sulfate solution. It is found that the sorption of Cr(III)‐containing ions on the polymers is essentially dependent on the pH, temperature, and Cr(III) sulfate concentration. The maximum temperature dependence of sorption was found to be about 60°C. The sorption isotherms are well described by Langmuir's equations. The sorption kinetics is determined by the diffusion of Cr(III)‐containing ions into polymer's phase. It is assumed that the Cr(III)‐containing ions are retained through formation, in polymer's phase, of the jarosite‐type mineral compounds: R₄N[Cr₃(OH)₆(SO₄)₂], H₃O[Cr₃(OH)₆(SO₄)₂], and K[Cr₃(OH)₆(SO₄)₂]. For comparison of sorptional capacities, the sorption of Cr(III)‐containing ions was determined on different cation and anion exchangers. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 3978–3985, 2006     

氮三甲撑膦酸中氯离子含量测定方法的研究

在酸性条件下,用Ag~ 沉淀氮三甲撑膦酸溶液中的Cl~-,然后以淀粉和KIO_3为指示剂,用标准I~-溶液滴定过量的Ag~ 。测定准确,方法灵敏,可靠和方便。克服了莫尔法和佛尔哈德法不适用于该测定体系的困难。     

非金属电镀用导电漆的研制

介绍了导电漆、作为导电填料的片状镀银铜粉的制备工艺流程。分别研究了漆膜表面单位电阻与镀银铜粉的含量及其粒径以及钛酸酯偶联剂的含量之间的关系。结果表明,当镀银铜粉的粒径为400目、质量分数在57%~65%之间,钛酸酯偶联剂的质量分数为10%时,所得涂膜的导电性能最佳。加入含C-18的油酸可以使导电漆长期贮存而电阻值不变。经检测,所得涂膜具有良好的性能:附着力1级,硬度1 H,柔韧性1 mm,冲击强度50 kg/cm2,膜厚10~15μm,漆膜表面每厘米电阻0.15Ω,每分米电阻0.47Ω。指出了导电漆应用过程中的注意事项。     

高锰高砷硫化银精矿湿法提银扩大试验

以广西凤凰高锰高砷硫化银精矿为原料,进行了全湿法提银扩大试验,结果表明银的直收率和总回收率达到91 59%和95 67%;锰和铅回收率分别为99 18%和87 41%;粗银粉和铅精矿品位分别为32 565%和72 43%。同时该工艺防止了硫、砷、铅等有毒元素对环境的污染,脱锰产生的H2S经两级碱吸收即全部以Na2S·9H2O的形式回收。     

碳酸钙粉体无钯活化化学镀银研究

采用无钯活化粉体化学镀技术制备了银包碳酸钙导电粉体.探讨了表面处理和PH值对沉积效果的影响,以及复合粒子的结合强度.通过扫描电镜(SEM),X射线能量色散谱仪(EDS)和X射线衍射(XRD)对复合粉体进行表面形貌分析和成分测试.结果表明:碳酸钙粉体经WD-50表面处理后,生成的银粒子粒径较小,对碳酸钙粒子的包覆均匀致密.随着镀液pH值的升高,银的析出量增大,粉体表观颜色变浅.调节镀液pH至13.0,得到了镀层结合强度高的银包碳酸钙复合粉体.