简化形式的系统EMC预测分析技术概述

本文探讨了系统级简化形式的电磁兼容性预测分析方法，该方法对于只有几对发-收干扰对的系统EMI的预测分析简洁有效，它避免了大系统间繁复的建模与大量的数据采集及其计算工作，从而对于只考虑其结果的系统间的EMC预测分析提高了效率。     

马钢二烧结配料计算机控制系统

阐明了马钢二烧结配科计算机控制系统的目的、控制形式、控制原理；根据烧结配料控制对象的特点对信号采样和控制算法进行了探讨；提供了系统的主要硬件结构，软件功能和程序框图。     

Handover and Uplink Power Control Performance in the 3.84 Mcps TDD mode of UTRA Network

In this article we consider the performance of the 3.84 Mcpstime-division duplex (TDD) mode of UTRA (Universal TerrestrialRadio Access) network. We emphasize two of the radio resourcemanagement algorithms, handover and uplink power control, whoserole in the overall system performance is studied extensively.First, a handover algorithm used in WCDMA (Wideband Code DivisionMultiple Access) standard is considered in a TDD-mode operation.This gives rise to a careful setting of different handoverparameters, and the evaluation of the effects to the systemperformance. Secondly, the specified uplink power controlalgorithm is considered. Since it is based on several user-mademeasurements which may involve both random and systematic errors acareful study about the suitability of the power control scheme iscarried out.     

Study on Hydrocracking of VGO Derived from Kazakhstan-Russian Mixed Crude

1 Introduction With the successful completion of the construction of the China-Kazakhstan oil pipeline the refinery at Dushanzi Pet- rochemical Company will process the Kazakhstan-Russian mixed crude at full steam starting 2007. The high sulfur, nitro- gen and heavy metals contents in the Kazakhstan-Russian mixed crude would have a serious impact on the secondary processing units of the Dushanzi refinery, in particular on the distillate hydrocracking unit, which mainly operates on vacuum g…     

Fast handoff with reducing waste rate approach for wireless resources management in UMTS mobile networks

3G Wideband CDMA systems adopt the Orthogonal Variable Spreading Factor code tree as the channelization codes management for achieving high data rate transmission in personal multimedia communications. It assigns a single channelization code for each accepted connection. Nevertheless, it wastes the system capacity when the required rate is not powers of two of the basic rate. One good solution is to assign multiple codes for each accepted connection but it causes two inevitable drawbacks: long handoff delay and new call setup delay due to high complexity of processing with multiple channelization codes, and high cost of using more number of rake combiners. Especially, long handoff delay may result in more call dropping probability and higher Grade of Service, which will degrade significantly the utilization and revenue of the 3G cellular systems. Therefore, we propose herein an adaptive efficient codes determination algorithm based on the Markov Decision Process analysis approach to reduce the waste rate and reassignments significantly while providing fast handoff. Numerical results demonstrate that the proposed approach yields several advantages, including the lowest GOS, the least waste rate, and the least number of reassignments. Meanwhile, the optimal number of rake combiners is also analyzed in this paper. This research was supported in part by the National Science Council of Taiwan, ROC, under contract NSC-93-2213-E-324-018.     

移动通信系统中功率控制研究

在阐述功率控制在移动通信系统中的发展过程的基础上，着重研究了WCDMA系统的功率控制，最后对功率控制未来的研究方向做了简要的分析。     

用于制备膨体颗粒调剖剂的含油污泥除油技术研究

利用含油污泥制备膨体颗粒调剖剂用于调剖堵水是一种新的污泥资源化技术，研究了含油污泥的预处理方法，尤其是除油技术。分别使用热水酸洗、热水酸洗／除油剂对污泥进行了除油试验，并以干泥含油率为指标考察了pH值、水与泥质量比、除油剂用量对除油效果的影响。试验结果表明，在水与泥质量比为2．0、pH值为6．0、45℃条件下，用矿化水热水酸洗可使干泥含油率从31．5％降至19．4％。同样条件下，除油剂用量为40．0mg／L时，热水酸洗／除油剂处理能使干泥含油率进一步降至11．2％。聚合试验结果表明，经热水酸洗／除油剂处理后的污泥能够聚合得到胶块强度高、膨胀倍数高的膨体颗粒调剖剂。     

基于中压加氢改质方案的炼油流程协同优化

中国石化北京燕山分公司(简称燕山分公司）为增产高附加值产品、提升效益，对炼油系统进行了流程协同优化。中压加氢裂化装置掺炼催化裂化柴油，由加氢裂化方案改为加氢改质方案运行，将改质柴油送入三号催化裂化装置（简称三催化装置）的提升管进行回炼；同时，将焦化蜡油改入加氢裂化装置进行加工，而蜡油加氢装置不再加工焦化蜡油以改善催化裂化原料。协同优化后，中压加氢改质装置的柴油产品十六烷值提高7个单位；三催化装置的液化气收率提高1.96百分点，汽油收率增加0.88百分点，总液体收率增加2.28百分点；高压加氢裂化装置喷气燃料产品的密度（20 ℃）降低至806 kg/m3，烟点为23.8 mm，尾油BMCI由11.8降低至10.8；蜡油加氢装置精制蜡油的饱和分质量分数提高4.68百分点，芳香分质量分数降低5.96百分点，氮质量分数降低0.06百分点，使催化裂化原料性质得以改善。通过将中压加氢改质装置的喷气燃料馏分抽出送催化裂化装置回炼，与回炼改质柴油相比，催化裂化汽油的研究法辛烷值（RON）增加1.0个单位，改质柴油十六烷值提高4.8个单位。通过全炼油板块系统性优化，燕山分公司车用柴油产品的十六烷值由53.5降低至51.5，解决了质量过剩问题。     

改进型UDP组播的性能分析及其在实时电源控制系统中的应用

文章通过采用带连接的UDP、I/O复用技术、关闭UDP校验和功能、负载均衡等技术对普通的UDP组播技术进行改进,使之在每个控制周期(1ms)内满足了分布式实时控制系统的实时性和可靠性要求。在将改进型的UDP组播技术应用于实际控制系统之前,文中构建了一个模拟局域网进行测试,对比结果表明改进后的组播技术无论在数据包延迟、丢包率等方面较改进前的UDP组播性能有较大幅度的提高。     

催化裂解多产丙烯新技术

介绍了国内外利用蜡油或常压渣油等重质原料的增产丙烯技术CPP,ARGG FDFCC和TSRMP;还介绍了利用富含烯烃的混合碳四和催化裂化汽油等轻质原料的增产丙烯技术OCP,Propylur,Superflex,OCT,Meta-4和BASF公司的丁烯歧化工艺技术.