真空相变锅炉低排烟温度设计与低温腐蚀

真空相变锅炉是否会明显发生烟气低温腐蚀，一直众说不一。文章从锅炉发生低温腐蚀的机理人手，通过理论分析计算并通过实践检验，提出了真空相变锅炉虽然不能完全避免低温腐蚀问题，但不论排烟温度是否高于烟气露点，低温腐蚀的程度都很弱的观点；给出了真空相变锅炉沿烟气流程金属壁面的腐蚀速度与壁面温度的关系曲线，和烟气温度低于酸露点时金属壁面的腐蚀速度与壁面温度的关系曲线；同时，文章推荐真空相变锅炉的设计排烟温度取130℃左右的低排烟温度。根据上述观点设计的数百台产品已经过多年实际运行，未发现明显     

蓄热式均热炉生产中存在问题的分析及解决方案

介绍了高温空气燃烧技术在均热炉上的应用情况，对应用中出现的问题进行了分析，并提出了解决方案。     

水对食品相变的影响

水是食品材料中最重要的成分。本文介绍了食品中水的性质以及水对食品相变的影响，并从水活性、水的吸附性以及水的增塑性三方面描述了水在食品相变中所起的作用。另外，还着重分析了水对食品冻结温度的影响。     

Response of Vietnam coastal upwelling to the 1997-1998 ENSO event observed by multisensor data

In this paper, we examine the behavior of the Vietnam coastal upwelling during the 1997-1998 El Niño-Southern Oscillation (ENSO) event. The baseline is 4 years of National Oceanic and Atmospheric Administration (NOAA) satellite Advanced Very High Resolution Radiometer (AVHRR) sea surface temperature (SST) data taken from 1997 to 2000. Comparison of upwelling images to simultaneous ERS-2 (European Remote Sensing Satellite) wind fields indicates that the summer monsoon winds constitute a major generation forcing. During the 1997 El Niño, the monsoon winds enhanced the upwelling and induced the upwelling center to move southward. During the 1998 La Niña, the monsoon winds weakened the upwelling. In contrast with the tropical Pacific, in the study area, La Niña implies a warm event and El Niño a cold event. We use empirical orthogonal function (EOF) methods to analyze the spatial and temporal variance of the upwelling. The three principal modes account for 37%, 15%, and 8% of the total variance, respectively. The first EOF modes reveal that the SST variance in the north and south subregions underwent a positive-negative sign switch in summer 1997. The second EOF modes represent the monthly evolution in normal years. The third modes seem to be sensitive to the 1998 La Niña event. Simultaneous TOPEX/POSEIDON and ERS-2 altimeter data provide further evidence for our analysis. Comparison with California coastal upwelling and mid-Atlantic Bight (MAB) coastal upwelling indicates that the Vietnam coastal upwelling is the most intensive one.     

烧结处理小矿山精矿的应用研究

研究小矿山精矿的性质，分析小矿山精矿对烧结过程的影响，提出了增加小矿山精矿配入量的途径及方法．     

低温电解的节能实验研究

本文以中国铝业河南分公司电解厂85kA中间点式下料预焙槽为研究对象，通过6个月的低温电解实验，改善“四低一高”(低电解温度、低分子比、低氧化铝浓度、低效应系数和高极距)技术条件，优化工艺技术条件配置，降低分子比和电解温度，维护炉膛的规整，维护电解槽工作电压的稳定，规范员工作业标准，达到提高电流效率、降低电耗的节能效果。     

Measurement of the coolant flow rate using correlation of temperature fluctuations

The transit time of the coolant, and thus its velocity, has been measured using the temperature fluctuation at the outlet of a reactor core. An impulse response function estimation is introduced, which substitutes the widely used cross-correlation measurement technique. It is shown in theory and practice that the time delay estimation is improved when using the impulse response function instead of the cross-correlation function in parameter estimation. Extremely low velocities (down to 2 cm/sec) have been measured in a natural circulation regime in a research reactor.     

Low temperature synthesis of aluminium titanate by an aqueous sol-gel route

Formation of aluminium titanate (AT) has been achieved at low temperature through sol-gel process using boehmite and titanium hydroxide as precursors by controlling the particle size at nanoscale followed by in-situ peptisation. The formations of AT phase, particle size distributions, sintering and thermal expansion characteristics, and microstructural features have been reported. DTA and XRD analysis have been performed to confirm the formation of AT. A 94% relative density was obtained for aluminium titanate sintered at 1550 °C with controlled grain size in the range of 2-3 μm.     

The Effect of Structural Defects on the Thermal Conductivity of ZnS, ZnSe, and CdTe Polycrystals

ZnS, ZnSe, and CdTe polycrystals are experimentally investigated. Mechanisms are treated which restrict the thermal conductivity in samples prepared by recrystallization pressing and by deposition from the vapor phase and subjected to additional strain. Anomalies are observed on the temperature dependences of the thermal resistance of investigated samples, which are due to the special features of their phonon spectra and to the variation of the contribution made by longitudinal and transverse phonon branches to the heat transfer in the Debye temperature region and higher.     

Wettability of Lithium by Liquid Sodium, Potassium and Rubidium

The wettability of the lithium surface by liquid alkali metals Na, K and Rb is investigated for the first time by the sessile drop method in an all-soldered instrument under conditions of a high vacuum. The presence of the temperature threshold of wetting is found in Li–Na and Li–K systems at temperatures of 325°C and 160°C, respectively. A conclusion is drawn that an abrupt decrease in wetting angles in the investigated systems is associated with a marked decrease in the interfacial tension at lithium-lithium, lithium-potassium, and lithium--rubidium interfaces owing to the beginning of a noticeable mutual solubility of the components at relatively high temperatures.