Influence of the Preheat Treatment on the Microstructure and Properties of X37CrMoV5-1 Steel

The technological properties of the hot-work tool steels depend on their microstructural quality induced by the production process and the heat treatment. One of the frequently applied methods to improve microstructure is preheat treatment. The treatment of carbonitriding X37CrMoV5-1 steel has been investigated in fluidized bed furnaces. Thickness and phase composition have been conducted using optical microscopy Neophot 32 and scanning microscopy, JEOL 5400, after etching in nital.     

节能降耗提高矿山效益

节能降耗是每一个矿山提高经济效益的有效途径。我们采取提高球磨机处理能力，降低单耗；利用“分时计价”政策，采用“避峰作业”；使用新设备等措施节能降耗，提高矿山经济效益。     

论普通型胶辊表面不处理的合理工艺参数

论述了普通胶辊表面不处理的性能特点和存在问题，技术措施和合理工艺参数，提高了成纱条干水平，减少缠绕和磨损。     

化学成分和固溶温度对1Cr17Mn9Ni4N不锈钢组织和性能的影响

为提高1Crl7Mn9Ni4N钢固溶处理后的力学性能(特别是钢的强度)，研究了化学成分及固溶处理温度对其组织和性能的影响。结果表明，1000—1125℃固溶处理后，该钢的组织为单相奥氏体。在标准成分范围内，随着镍、锰含量的增加，该钢的强度降低，塑性有所改善。氮明显提高该钢的强度。根据试验结果，每增加0．01％的氮钢的室温强度可提高大约5MPa，且塑性基本上不受影响。当合金成分(质量分数，％)控制在C0．08—0．12、Crl6．5—17．5、Ni3．5—4．2、Mn8．0—9．0、N0．22—0．28时，1Crl7Mn9Ni4N钢经1050—1100℃固溶处理后强度较高、塑性好，室温强度σ0．2和σb可分别达到400MPa和800MPa。     

Intensive filial therapy with child witnesses of domestic violence: A comparison with individual and sibling group play therapy.

The rationale for utilizing filial therapy as a treatment intervention with child witnesses of domestic violence while residing with their mothers in a shelter facility is explored and the effectiveness of an intensive 12-session filial therapy parent training group, conducted within 2-3 weeks, is described (n=11; aged 4-10 yrs). Results of analysis of covariance revealed that child witnesses in the experimental group significantly reduced behavior problems prevalent in child witnesses and significantly increased their self-concept as compared to child witnesses in the non-treatment comparison group. In addition, t-test results showed that mothers who facilitated treatment of the experimental group scored significantly higher after training on both their attitudes of acceptance and their empathic behavior. Comparative analysis revealed that intensive filial therapy as facilitated by the children's mothers was as effective in reducing behavior problems as was intensive individual play therapy and intensive sibling group play therapy as facilitated by professionally trained therapists. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Austenitizing treatment influence on the electrochemical corrosion behavior of 0.3C-14Cr-3Mo martensitic stainless steel

Effects of austenitizing treatment temperatures on aqueous corrosion properties of martensitic stainless steels were investigated by electrochemical tests (potentiodynamic test, potentiostatic test and electrochemical impedance spectroscopy), and surface analyses (optical microscopy and XRD). The results of potentiodynamic test revealed that the breakdown potential increased with the increased austenitizing temperature, indicating increased relative resistance to initiation of localized corrosion. EIS measurements showed that MSS3 (1030 °C) exhibits larger polarization resistance value than MSS1 (970 °C) and MSS2 (1000 °C) at passive and breakdown states. This was caused by decreasing the amount of Cr-rich M₂₃C₆ carbide which acts as preferential sites for pitting corrosion.     

换填法建筑地基处理的工程实录

结合某工程的地基处理，对换填法的应用作了较详细的阐述。     

Corrosion Condition Evaluation at Muddy Creek Bridge

Corrosion rates were measured at the exposed spots of rebars near three corners of Muddy Creek Bridge located in northern West Virginia using a 3LP device. Also, chloride contents of the concrete samples taken from the vicinity of the spots were analyzed using a wet chemical method that had been developed in this study. The average corrosion rate over the three spots was 4.66 mA/m2, which is in the range of corrosion damage possible in 10–15 years. The average chloride content of the concrete over the three spots was 703 parts per million (ppm), which is well above the threshold limit value of 260 ppm. Although the corrosion rate measurement method using a 3LP device is by manual operation, it is found to be reliable and effective, and, thus, recommended for future studies of this kind of research. The wet chemical method developed in this study is found to be effective.     

模拟焊后热处理对锅炉用钢板SA-299力学性能的影响

对新日铁供货的SA-299钢板取样进行了供货状态及610～650℃/8h炉冷的模拟焊后热处理,以进行力学性能对比试验。试验结果表明,经过630℃/8h炉冷的模拟焊后热处理后σs降低25～40MPa、σb降低55～65MPa,但力学性能符合ASMESA-299标准和采购规程C1F19-98的要求。     

Investigating the acceptability of behavioral interventions in applied conjoint behavioral consultation: Moving from analog conditions to naturalistic settings.

Whereas there exists a vast literature investigating consumer satisfaction ratings of various behavioral interventions, the majority of these studies have been limited to analogue conditions, which may compromise utility and generalization. Additionally, most research has failed to explore multiple-source, multiple-setting data in the investigation of treatment acceptability. This study investigated parent, teacher, and child treatment acceptability ratings derived from field-based conjoint behavioral consultation cases. Data indicate that overall, 67 parents (aged 23-54 yrs), 67 teachers (aged 22-57 yrs), and 67 children (aged 5-15 yrs) rated conjoint behavioral consultation-based behavioral interventions as very to highly acceptable. For parents, interventions with a reductive component were rated as more acceptable than interventions using both positive and negative components; no significant differences were found among teacher and child group ratings. For teachers, there was a positive relationship between (a) intervention complexity and treatment acceptability ratings and (b) problem severity ratings and treatment acceptability ratings... (PsycINFO Database Record (c) 2011 APA, all rights reserved)