海陆交互相三角洲高分辨率层序地层探析——以珠江口盆地惠州凹陷珠海组为例

针对海陆交互地区三角洲沉积体系特征，采用高分辨率层序地层多级次基准面旋回划分方案，通过对地震与测井等资料的综合分析，研究珠江口盆地惠州凹陷珠海组海陆交互相三角洲沉积体系的高分辨率层序地层学特征，在珠海组中识别出短期、中期和长期3个级别的基准面旋回。在此基础上，运用等时对比法则对各级旋回进行对比并建立层序地层格架，归纳了珠海组沉积时期2个长期基准面旋回内的沉积体系演化规律及其特征。     

交变电场结合后处理技术对点蚀破坏电极的修复机理

针对开发的点蚀破坏电极的修复技术——交变电场(AEF)结合后处理技术，应用循环伏安、动电位极化、能谱以及光谱表征技术分别研究了AEF的反应实质与后处理的作用，并结合形貌与光谱表征技术剖析了蚀孔处的修复结果；在此基础上，探讨了该技术的修复机理．     

Continuous electromagnetic separation of inclusion from aluminum melt using alternating current

A novel scheme about the continuous electromagnetic purification of aluminum melt was put forward based on the utilization of a square separation pipe and a 50 Hz alternating current to produce electromagnetic force. It is experimentally found that with electrical current of 400 A/cm^2, it takes only 10 s to remove 95% inclusion from aluminum melt. Comprehensive numerical simulations were carried out to investigate the dynamics mechanisms behind the process. The results show that the removal of inclusion is attributed to the cooperative effects of electromagnetic buoyancy and the secondary flow induced by the rotational electromagnetic force, and the removal efficient increases with the size of inclusion and the electrical current imposed. Theoretical predictions on the distribution and removal efficiency of inclusion were supported by the experiments.     

交流脉冲MIG弧焊电源及弧长控制

AC PMIG的控制模式是一周一脉一滴，脉冲电流设计在电弧EP极性时间里，其余时间均为基值电流。弧焊电源一次逆变控制电流快速动态过程，二次逆变控制电弧极性。控制系统采用双闭环结构，内环模拟控制电弧电流，外环80C196KC单片机控制电弧电压及电弧极性。根据电弧电压偏差信号及电弧状态，设计了四个控制规则及其控制参数的计算方法。正常焊接状态时变频控制交流脉冲频率。采用这种控制方案，获得了稳定性高、熔滴过渡均匀的焊接过程。     

The properties of equimolar copolycarbonates of bisphenol A with bisphenol S and 1,4-bis(hydroxymethyl)cyclohexane

Ranges of both alternating and random 1:1 copolycarbonates of Bisphenol-A (2,2-bis(4-hydroxyphenyl)propane) and Bisphenol-S (4,4′-dihydroxydiphenyl sulphone) and of Bisphenol-A and 1,4-dimethanoylcyclohexane have been synthesized in order to test the hypothesis that, other things being equal, a more random structured polymer should exhibit superior thermal ageing characteristics. Studies on these materials' mechanical and thermal properties establish that within each pair they are extremely similar and hence the original hypothesis is disproved.     

Synthesis of polyethylene oxide end‐capped with perfluoroalkyl groups/polystyrene prototype brushes

Polystyrene (PS)/poly(ethylene oxide) (PEO) prototype brushes were prepared by alternating free‐radical copolymerization of methacryloyl‐terminated PS and α‐vinylbenzyl‐ω‐hydroxy or α‐vinylbenzyl‐ω‐perfluoroalkyl (R_f) PEO macromonomers with the addition of Lewis acid (SnCl₄). It was found from their dilute‐solution properties that PS/PEO end‐capped with R_f (PBR_f), and PS/PEO having OH groups at terminal ends (PBOH) prototype brushes formed a single molecule in benzene and aggregates in chloroform, respectively. However, the brush PBOH formed a single molecule in N,N‐dimethylformamide. Such aggregation behaviors seemed to be caused by the interaction between hydroxy groups of PEO chain ends. The brush PBOH was also converted into PBR_f‐type brush by chemical modification, using corresponding acid chloride. The substitution of R_f groups was ～70% due to slipping of terminal hydroxy groups into PEO internal domains. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 772–778, 2006     

Lewis酸存在下的自由基共聚合——Ⅰ.GeCl_4与BCl_3存在下的乙酸乙烯酯与丙烯酸交替共聚

乙酸乙烯酯(VAc)与丙烯酸(AA)在GeCl_4及BCl_3存在下通过自由基聚合可得到交替共聚物。对GeCl_4体系,聚合反应速率正比于[引发剂]~(0.5)。当VAc/AA=1:1(mol比)时有最大反应速率。CCl_4对本聚合反应无链转移作用。通过紫外光谱分析可证实VAc及AA均与GeC\(?)生成络合物;ESR分析表明,络合AA自由基较未络合AA有较强的阳离子特性,交替共聚的原因可能与络合AA自由基及活化单体络合物二者有关。     

深部互层咸水层二氧化碳分布特征探究

通过构造砂页岩互层结构,并根据渗透率对砂岩层岩性进行分类,建立了多岩相非均质模型,利用多组分多相流数值模拟软件TOUGH2/ECO2N探究二氧化碳注入深部互层咸水层后的分布特征,结果显示二氧化碳聚集在低渗透性的页岩层底部,呈分层结构,砂岩层中优先在渗透率较高的岩相中运移并呈分散分布;超临界二氧化碳不断溶于地层水,含饱和二氧化碳的咸水密度增加并缓慢下沉,无明显分层现象。     

基于弯道二次流修正模型的大辽河潮流界时空变化模拟

基于ELADI算法的平面二维水环境模型WESC2D,定量研究大辽河潮区界与潮流界的时空变化规律。在模拟和验证大辽河潮位变化过程基础上,通过数值试验系统地模拟分析了上游径流量及汇流比、下游潮差和海平面上升对大辽河潮区界与潮流界的影响规律,并以1999年—2009年水文过程为条件定量研究大辽河潮流界的年、月变化及潮流界位置出现频率。结果表明,径流是影响大辽河潮区界与潮流界位置的主要因素,大辽河潮流界远远超过三岔河。     

我国高职教育借鉴德国职业教育模式的问题与改善

德国职业教育模式在我国发展和普及已经近30年了,为我国加快发展现代职业教育提供了借鉴。简析了德国职业教育模式在中国的发展现状,并指出了在实施中遇到的问题,提出了相关的解决方法和改善办法。