季节对2A12-T4棒材力学性能的影响

在实际生产中，我们发现冬季生产的2A12－T4挤压棒材力学性能σb、σ02比在夏季的低40－70MPa，分析了造成这一现象的原因。     

轴类零件形位公差的选用

以轴为例，结合零件的使用要求，技术条件，介绍用类比法和计算法选用形位公差的方法。     

高温预析出对Al-Zn-Mg系铝合金时效硬化和应力腐蚀的影响

研究了高温固溶后降温处理工艺对中强可使预析出LC52和7039铝合金的组织、时效硬化和应力腐蚀的影响。金相观察发现,高温预析出可优先在晶界处产生,并提高随后时效状态下晶界析出相的不连续分布程度,温度降低到一定程度晶内和晶界产生大量析出。合金拉伸性能和应力腐蚀结果表明,预析出在保持强度和塑性的同时,可提高抗应力腐蚀性能。而预析出温度降低,合金强度呈下降趋势。     

飞机用钛合金的加工

近年来，对汽车和飞机零件高强度化和轻量化的要求越来越高。因此，这些零件所使用材料中的钛、镍合金等也在不断增加。这种材料一般称为切削加工性差的“难切削材料”。加工此类材料的切削刀具也必须能够适应难切削材料特有的加工条件和加工方法。     

ZL110合金活塞两级时效工艺

本文提出了用两级时效工艺提高ZL110合金时效强化效果的方法,并探讨了该方法对ZL110合金活塞的机械性能及尺寸稳定性的影响规律。     

Corrosion Inhibition Mechanism with Spilt Cell Technique of Rare Earth Metal on LC4 Al Alloy

A new method of studying the corrosion inhibition mechanism of rare earth metal(REM) on LC4 Al alloy with the spilt cell technique was studied. The principle and experimental method of the spilt cell technique were analyzed. By measuring the change of net-electric current between the two electrodes caused by the change of the amount of oxygen in the solution and the addition of CeCl₃, the influence of corrosive performance of CeCl₃ on LC4 super-power aluminum alloy in the 0.1 mol·L⁻¹ NaCl solution was investigated. Meanwhile, the conditional changes of pH values, CeCl₃ solution, additire and time of performance were also studied. Finally, the features of electrode surface were revealed by using SEM and X-ray energy-dispersive spectrometry (EDS). By combining these with other electric chemical techniques, such as potential-time curve, polarization curve et al.