Deorthogonalization of ODS-CDMA QPSK by AM/PM Nonlinearity

When using a conventional demodulator, a sufficient condition to maintain ODS-CDMA codeword orthogonality is constant relative channel amplitude over the codeword duration. When transmitted over a memoryless, AM/PM nonlinearity channel, the chip-to-chip fluctuating amplitude of a composite ODS-CDMA QPSK waveform produces a chip-to-chip fluctuating phase that deorthogonalizes the ODS-CDMA codewords, resulting in an additional multiple access self-interference similar to that found in asynchronous DS-CDMA. For ODS-CDMA QPSK in an AM/PM nonlinearity channel, we utilize the Central Limit Theorem, derive, and evaluate: (i) an expression for the signal-to-distortion ratio at the demodulator output, (ii) an expression for the uncoded bit error probability, and (iii) an upper bound on the convolutionally-coded bit error probability. We find that the degradation to BER depends on both the AM/PM nonlinearity slope and the ODS-CDMA channel loading.     

Performance of in-call buffer/window allocation schemes for short intermittent file transfers over broadband packet networks

While static open loop rate controls may be adequate for handling continuous bit rate (CBR) traffic, relatively smooth data traffic, and relatively low speed bursty data traffic over broadband integrated networks, high speed bursty data sources need more dynamic controls. Burst level resource allocation is one such dynamic control. Potential benefits and other issues for burst level resource parameter negotiations for bursty data traffic over high speed wide area packet networks have been discussed earlier.^1–6 A detailed analysis of an adaptive buffer/window negotiation scheme for long file transfers using these concepts is presented in Reference 1. In this paper we discuss two burst level buffer/window negotiation schemes for short intermittent file transfers, focusing on the specific needs of such traffic streams. We develop closed network of queues models to reflect the behaviour of the proposed schemes. These models, while being simple, capture essential details of the control schemes. Under fairly general assumptions, the resulting network of queues is of product form and can be analysed using the mean value analysis. We use such an analysis to compare the proposed schemes and to determine appropriate sizes of trunk buffers to achieve the desired balance between bandwidth utilization and file transfer delay. The effects of other parameters on the performance of these schemes as well as on the buffer sizing rules are also discussed. Burst level (in-call) parameter negotiation may be carried out by the end system with the network elements or by an interface system (access controller) with the broadband network elements. We discuss implications of this location as well as the needed protocol features. Finally, the service discrimination capabilities desired at the trunk controllers in switching nodes are briefly discussed.     

FEATURE SOLID MODELING TOOL SYSTEM:FSMTS

In conformity with the principle of Design for Manufacture,feature-based design strate-(?)es have been developed.As the“feature”is relevant to the“macro process plan”and“macro NCprograms”,obviously,“feature”is beyond the power of conventional solid modellers.Neverthe-less,substantial breakthrough has not been made in the solid modeling field,except“feature at-taching”or“feature recognizing”methods have been taken on.In this paper,the theory,concepts,system architecture,and algorithm principles of solid modeling tool system have beenrepresented.The practice of Feature Solid Modeling Tool System (FSMTS) developed atHuazhong University has proved that the tool may be a new foundation of Feature-Based Design.     

基于B／S的国贸商务信息管理系统开发研究

阐述了B/S模式的基本原理及特点,实现了基于B/S模式的国贸商务信息系统,并对实现中采用的技术作了简要的讨论。此系统是一个跨区域、跨平台的商务信息管理系统,能够实现国贸公司内部信息,如外销、采购、库存等信息的实时交互,使信息得到及时的传递。     

Analysis of the detectivity for triple-layer heterojunction GaSb/GaInAsSb infrared detectors

In this paper, the detectivity is calculated and analyzed with the front-or backside illuminated case for both N-GaSb/p₂-Ga_0.8In_0.2As_0.19Sb_0.81/p₁-Ga_0.9In_0.1As_0.09Sb_0.91 and N₁-GaSb/n₂-Ga_0.9In_0.1As_0.09Sb_0.91/p-Ga_0.8In_0.2As_0.19Sb_0.81 infrared photovoltaic detectors, respectively. The analysis results show that the main absorption appears in the p-type Ga_0.8In_0.2As_0.19Sb_0.81 material with either front- or backside illuminated case for above two structures. In each structure, the carrier concentration obviously affects the detectivity. The carrier concentration in the wide-bandgap material for the isotype heterojunction should be reduced as low as possible to reduce the tunneling rate at the isotype heterointerface. Moreover, the change of the detectivity with the p-side surface recombination velocity for the N₁-n₂-p structure is more sensitive than that with the p₁-side surface recombination velocity for the N-p₂-p₁ structure. In the N-p₂-p₁ structure with the incident light from the p₁-side surface, two-color detection is achieved.     

高含酸性气碳酸盐岩气藏流体敏感性实验研究

对川东北雷口坡组、嘉陵江组、飞仙关组、长兴组高含H，S及032的碳酸盐岩储层流体敏感性进行了实验研究，结果表明岩样速敏损害弱～强，水敏和盐敏损害中偏弱～极强，碱敏损害严重。岩石学分析揭示，川东北高含酸性气碳酸盐岩储层发育伊利石、微晶石英、白云石、方解石、硫化钙等潜在损害物质。钻井完井液侵入会破坏储层各物质间的原始动态平衡，诱发储层损害。主要损害机理为：①储层流体pH增加引起黏土矿物以及微晶石英失稳；②碱液与微晶石英、长石、白云石反应生成硅酸盐、高岭石、水镁石等新矿相；③流体矿化度改变可降低伊利石微粒间的连接力；④硫化钙水解产生OH^-，过量的OH-与Ca^2＋结合形成氢氧化钙沉淀；⑤储层含水饱和度和流体离子浓度改变，致使焦沥青脱附并在储层深部沉积；⑥硬石膏水化膨胀、分散运移。针对该气藏损害机理，可采用屏蔽暂堵技术以形成优质滤饼，有效降低储层流体敏感性损害。图5表2参10。     

Growth and characterization of GaAs films deposited on Ge/Si composite substrates by metalorganic chemical vapor deposition

We report the results of studies which have been made on heteroepitaxial layers of GaAs and AlGaAs grown by metalorganic chemical vapor deposition on composite substrates that consist of four different types of heteroepitaxial layered structures of Ge and Ge-Si grown by molecular beam epitaxy on (100)-oriented Si substrates. It is found that of the four structures studied, the preferred composite substrate is a single layer of Ge ∼1 μm thick grown directly on a Si buffer layer. The double-crystal X-ray rocking curves of 2 μm thick GaAs films grown on such substrates have FWHM values as small as 168 arc sec. Transmission electron micrographs of these Ge/Si composite substrates has shown that the number of dislocations in the Ge heteroepitaxial layer can be greatly reduced by an anneal at about 750° C for 30 min which is simultaneously carried out during the growth of the GaAs layer. The quality of the GaAs layers grown on these composite substrates can be greatly improved by the use of a five-period GaAs-GaAsP strained-layer superlattice (SLS). Using the results of these studies, low-threshold optically pumped AlGaAs-GaAs DH laser structures have been grown by MOCVD on MBE Ge/Si composite substrates.     

井下气液分离及回注技术研究现状分析

气井产水量的不断增加对天然气生产构成严重威胁，其影响越来越受到人们的关注和重视。使用井下气液分离及回注技术，可以降低举升和处理费用，增加生产寿命，提高采收率，减少环境污染，简化地面分离设备，提高投资效益。针对井下分离及回注技术研究现状进行了分析，给出了并下气液分离及回注形式、适用条件和技术设计、应用方面的结论。     

Influence of ZnO and P2O5 Content on Modified HZSM-5 on Aromatization of FCC Gasoline

Catalytic properties of different content of ZnO and P₂O₅ supported on HZSM-5 zeolites were studied in the conversion of FCC gasoline (75°C-120°C) into aromatic hydrocarbons with a temperature of 430°C, a liquid hourly space velocity of 1.0 hr^-1, and a pressure of 0.1 MPa. In the reaction, when the contents of ZnO and P₂O₅ are 2% and 4%, respectively, Zn-P/HZSM-5 showed the highest selectivity and activity to aromatic hydrocarbons and conversion of olefins. The content of aromatics in the liquid product and the yield of aromatics reached as high as 94.53%, 68.87%, and 51.74%, respectively.     

A Compositional Framework for Hardware/Software Co-Design

We describe a compositional framework, together with its supporting toolset, for hardware/software co-design. Our framework is an integration of a formal approach within a traditional design flow. The formal approach is based on Interval Temporal Logic and its executable subset, Tempura. Refinement is the key element in our framework because it will derivefrom a single formal specification of the system the software and hardware parts of the implementation, while preserving all properties of the system specification. During refinement simulation is used to choose the appropriate refinement rules, which are applied automatically in the HOL system. The framework is illustrated with two case studies. The work presented is part of a UK collaborative research project between the Software Technology Research Laboratory at the De Montfort University and the Oxford University Computing Laboratory.