定向凝固空心叶片制壳工艺的改进

分析了在先进发动机定向凝固空心叶片熔模精密铸造生产中出现两种缺陷的性质和产生原因，从壳型制造工艺方面提出了改进措施，提高了叶片合格率。     

Prevention of Lipid Oxidation in Precooked Turkey Meat Patties with Hot Packaging and Antioxidant Combinations

The effects of antioxidants or hot packaging and their combination on lipid oxidation were quite variable depending on the additives in turkey meat. The TBARS values of cooked patties were greatly affected by the degree of oxidation in the raw meat, and the effectiveness of antioxidants varied with added prooxidants. Ascorbate and free radical terminators had stronger antioxidant effects than iron chelators, and chelating iron alone could not eliminate lipid oxidation in either raw or cooked meat with added NaCl. The combination of hot packaging and antioxidants provided cooked patties with better protection from lipid oxidation than either treatment alone.     

Buckling optimization of hybrid-fiber multilayer-sandwich cylindrical shells under external lateral pressure

This paper describes a method of analyzing the maximum buckling strength of hybrid-fiber multilayer-sandwich cylindrical shells under external lateral pressure with respect to fiber orientations and weighting factors. Formulae for optimizing these parameters are presented and conditions for the application of these formulae are discussed. A discriminant is derived for assessing whether the hybrid sandwich cylindrical shells for given different unidirectional composites should reach the extreme value of critical pressure.     

X荧光光谱法测定不锈钢的研究

本文论述了Ｘ荧光光谱测定高铬钢和不锈钢的分析方法，用理论α系数校正基体效应和用谱线干扰系数Ｌ校正谱线重叠影响。方法准确度和精度令人满意，操作十分简便、快速。     

大面积硅锂漂移探测器制备及其性能

制备了大面积硅锂漂移探测器,其性能为:探测器的灵敏面积123.6 cm~2;灵敏层深度2 mm;在室温和300 V反向偏压的工作条件下漏电流小于20 μA;对~(241)Am 5.486 MeV α粒子的能量分辨(FWHM)为77.67 keV。     

单液晶光阀彩色大屏幕投影显示

设计一电路,将彩色图象信息编码到黑白CRT的亮度之中,并将其写入液晶光阀,用白光读出,当编码合适时,读出的象颜色可与原图像一致。本文讨论了这一技术原理并进行了单液晶光阀彩色大屏幕投影的实验验证。     

Influence of the surface conditions on permeation in the deuterium–MANET system

The condition of the surfaces is of crucial importance for the deuterium permeation through materials. In this work a study of the surface constants for the adsorption (σk₁) and release (σk₂) of deuterium under different surface conditions on the martensitic steel DIN 1.4914 (MANET) has been carried out. The growth of an oxide surface layer (Cr₂O₃) of about 25–30 nm in a MANET sample, heat treated in an oxidizing environment, compared to the bare MANET that have a ‘natural' oxide of about 5 nm has provoked a reduction of both the permeation rate and the recombination coefficient (about 3 orders of magnitude). In addition, the permeation governing process has changed from diffusion-limited to surface-limited. The measurements of the permeation rate of deuterium were performed by a gas-phase permeation technique over the temperature range 574–746 K and for deuterium driving pressures in the range from 3 to 10⁵ Pa.     

50kg／m钢轨轨底缺陷的检验和分析

钢轨轨底缺陷有三种：底伤、结疤和底裂缺陷。取２０根有底缺陷５０ｋｇ／ｍＵ７１Ｍｎ钢轨做试样，通过低倍、断口、金相检验和扫描电能谱分析，详细描述了轨底缺陷的宏观和微观特征，研究出钢轨轨底缺陷出现的规律臁其产生的原因。通过对比试验，发现淄博１号保护渣有利于改善钢锭表面质量，提高钢轨一级品率。     

碳钢与不锈钢表面高浓度渗铬法

在氩气气氛下，应用固体渗铬填料法对碳钢、不锈钢作了表面高铬浓度的渗铬处理，探讨了渗铬温度、时间和渗铬组分对渗层表面铬含量、厚度，试样增重和物相组分影响，碳钢、不锈钢的表面渗铬浓度分别达８０－９４ｗｔ％和７０－８２ｗｔ％。     

高炉煤气干法除尘技术发展现状及宝钢应用前景

在对高炉煤气干法除尘技术应用现状进行综合分析的基础上结合宝钢实际，提出宝钢应用此技术的相关建议。