Putting it all together – Formal verification of the VAMP

In the verified architecture microprocessor (VAMP) project we have designed, functionally verified, and synthesized a processor with full DLX instruction set, delayed branch, Tomasulo scheduler, maskable nested precise interrupts, pipelined fully IEEE compatible dual precision floating point unit with variable latency, and separate instruction and data caches. The verification has been carried out in the theorem proving system PVS. The processor has been implemented on a Xilinx FPGA. A shorter version of this article with the title “Instantiating uninterpreted functional units and memory system: functional verification of the VAMP” appeared in [8]. The work reported here was done while all the authors were with Saarland University.     

水浴法加温液氧泵

1　故障现象一次 ,我们用KL -1 5型制氧制氮车开机制氮 ,给一只容积为 40升、最高工作压力为1 4 7MPa的气瓶灌充氮气 ,当气瓶充气压力升高到一定值时不再上升。反复开泵 ,压力基本不变。液氧泵停止时 ,出口压力无明显下降。经分析判断导致气瓶压力升高到一定值时不再上升的原因是由于液氧泵被冻结所致。2　排除方法首先关闭液氧泵。拧开制冷机氢气放气阀 ,使压力下降到 1 0MPa。开大放气阀 ,使二级压力保持在 0 3 5MPa左右。调整正流空气调节阀 ,调节好中部温度。关闭液氮进液氧泵阀和气氮出液氧泵阀。戴棉布手套 ,拆开液氮进口接头、…     

大型居住区设计探索——“深圳市新亚洲花园”设计回顾

通过对大型住宅区“深圳市新亚洲花园”工程规划及建筑方案创作构思的分析,实现住宅提升人们生活品质的设计思想,同时,在规划设计上对住宅开发在经济市场上如何提升竞争力做了有益探索。     

Proactive resource allocation for asynchronous real-time distributed systems in the presence of processor failures

We present two proactive resource allocation algorithms, RBA^*-FT and OBA-FT, for fault-tolerant asynchronous real-time distributed systems. The algorithms consider an application model where task timeliness is specified by Jensen's benefit functions and the anticipated application workload during future time intervals is described by adaptation functions. In addition, we assume that reliability functions of processors are available a priori. Given these models, our objective is to maximize aggregate task benefit and minimize aggregate missed deadline ratio in the presence of processor failures. Since determining the optimal solution is computationally intractable, the algorithms heuristically compute sub-optimal resource allocations, but in polynomial time. Experimental results reveal that RBA^*-FT and OBA-FT outperform their non-fault-tolerant counterparts in the presence of processor failures. Furthermore, RBA^*-FT performs better than OBA-FT, although OBA-FT incurs better worst-case and amortized computational costs. Finally, we observe that both algorithms robustly withstand errors in the estimation of anticipated failures.     

聚合反应器制造质量控制要点探讨

聚合反应器是无法检修设备,不允许打开,所以聚合反应器的制造质量必须严格控制,在设备制造过程中,严格按照设计图纸、技术要求及国家现行标准,进行控制设备制造、检验和验收,使制造质量达到规定要求。     

Delamination Analysis for Laminated Composites. II: Numerical Verification

A validation of the delamination analysis models developed in a companion paper is provided through comparisons of predictions with finite‐element and elasticity solutions. The models are applied to the analysis of composite compression specimens reinforced with end tabs. An elasticity solution for the gage section of the specimens is developed. A comparison of the characteristic roots shows that the predictions of the models include the material and geometric parameters that control the behavior, and the roots corresponding to the basic stretching and bending modes are accurately predicted. The stress distribution at the interface between tabs and specimen is in good agreement with a finite‐element simulation. The interlaminar shear and peel stresses show an exponential increase with a maximum intensity at the free edges of the tabs. The behavior of previously tested specimens is explained; and practical guidelines for specimen design are provided to avoid unwanted extraneous modes of failure. The influence of the deformation modes associated with each model is investigated. An assessment of the accuracy and level of complexity is presented.     

代数应力模式的分析解及其在充分发展旋转管流中的应用

本文通过求解雷诺应力在代数应力模式中与平均速度梯度之间的分析关系，研究了代数应力模式在涡旋流动特别是在充分发展旋转管流中存在的内在缺陷，这些缺陷的主要表现为：（１）在不考虑固壁对湍流影响的代数应力模式中，分析解给出Ｗ∝ｒ和ｖｗ＝０的错误结论；（２）若在代数应力模式中考虑固壁对湍流影响，在对称轴上会有ｖ＾２不等于ｗ＾２的非物理解。与诺应力输运模式相比，代数应力模式的缺陷归限结底在于该模式的基本假设不     

计算机控制的SEESR实验系统的研制

SEESR(Simultaneous Electrochemical ESR)是研究电极过程中的自由基中间体行为的理想和方便的手段。在以前研制的ESR仪数据系统的基础上,我们应用IBM-PC/XT微机与JES-FE1XG型(JEOL产)ESR谱仪及HDV-7型恒电位仪研制了一套由计算机控制的SEESR实验装置。该系统可以完成包括循环伏安法、电流阶跃、电位阶跃及电位反转等多种电化学方法的SEESR实验。系统还具有包括数据平滑、曲线拟合等功能的多种数据处理软件,使用方便。我们应用模型化合物对该系统进行了实际测量,所得结果与文献报道一致。