JOINING MECHANISMS OF β''''-Al2O3 CERAMIC AND PYREX GLASS TO Al MATRIX COMPOSITE

The bonding of β'-Al2O3 and pyrex glass to Al matrix composites by anodic bonding process is achieved. The microstructure of the bonded interface and the joining mechanisms are analyzed with scanning electron microscope (SEM), energy dispersive X-ray fluorescence spectrometer (EDX). It is observed that the bonding region across the interface consists of the metal layer, oxide transitional layer and the ceramic layer, with the transitional layer composed of surface region and sub-surface region. The bonding process can mainly be categorized into anodic bonding process and solid state diffusing process. The pile-up of the ions and its drift in the interface area are the main reasons for anode oxidation and joining of the interface. The temperature, voltage and the drift ions in the ceramic or glass during the bonding process are the essential conditions to solid state diffusing and oxide bonding at the interface. The voltages, temperature, pressure as well as the surface state are the main factors that influence the anodic bonding.     

太钢不锈冷轧工程防腐蚀施工技术

防腐蚀施工工艺掌握的好坏，直接影响到工程投入生产后的使用寿命，为保证工程质量，以太钢不锈冷轧改造工程冷线防腐为例，对其常发生的质量通病进行认真分析，总结出一套行之有效的施工技术。     

石英玻璃结构调整和二阶非线性光学效应产生机制的理论研究

从非谐振动理论观点出发．考虑到玻璃在外场及加热条件下结构取向调整和弛豫，对外部静电场和加热的温度及加热时间对其信频光产生的影响进行了探讨性理论研究，结果较好地解释了有关实验现象。     

A simple modification to the LKB 7800 series Knifemaker and a balanced-break method to prepare glass knives for cryosectioning

A novel method of using the LKB 7800 series Knifemaker to produce glass knives using a balanced break is described. The method produces knives of sufficient quality to section aldehyde-fixed, sucrose-cryoprotected, frozen biological material in a cooled cryochamber of an ultramicrotome. The modifications to the Knifemaker are minimal and, if required, the machine can be returned easily to its normal state after use.     

Entropy,Free Volume,and Cooperative Relaxation

The high frequency end of the relaxation spectrum for polymer molecules involves the rotation of the segmental bonds. This fast relaxation process, however, cannot take place easily in the condensed state crowded by the densely packed conformers, necessitating the slower cooperatively synchronous relaxation. As the temperature is lowered, the domain of cooperativity grows towards the infinite size at the Kauzmann zero entropy temperature, though actually the system deviates from the equilibrium as the glass transition intervenes typically at 50 K above that temperature. The excess enthalpy and entropy drop faster than predicted by the rotational isomeric states which would reach zero only at 0 K. The real ΔC_P is greater than that of the RIS value. The actual volume in excess of the crystalline lattice volume, however, points towards zero at 0 K. Thus, a polymer with higher T_g typically exhibits a lower density and modulus in the glassy state. Since the configurational entropy associated with the free volume is proportional to the logarithm of the latter, the Kauzmann temperature can be scaled by ln M, where M is the algebraic average of the conformer molecular weight. The temperature dependence of the most dominant, i.e., the largest equilibrium domain size will result in the Adam-Gibbs and Vogel equations for the characteristic relaxation time. The cooperative domain distribution leads to the relaxation spectrum that follows a power law. The relationship between the characteristic relaxation time and the rate of physical aging is derived.     

彩色PDP用玻璃基板

本文讨论了彩色ＰＤＰ现用钠钙玻璃的热稳定性，指出由于这种玻璃在热处理过程中易变形和收缩，因而不适合作大面积彩色ＰＤＰ基板材料，介绍了彩色ＰＤＰ基板玻璃的制造方法和特点。最后介绍了日本旭硝子公司和美国康宁公司各自为彩色ＰＤＰ新开发的玻璃基板材料ＰＤ２００和ＣＳ２５。     

磷酸盐激光玻璃中铂颗粒密度与氧化还原平衡关系的研究

用吸收光谱法研究了Ｒ２Ｏ—ＢａＯ—Ｐ２Ｏ５系统磷酸盐激光玻璃中铂颗粒密度与铭的氧化还原平衡的关系。结果表明，玻璃中铂颗粒密度随平衡向右移动而减小；玻璃中平衡随熔炼气氛中氧分压增大、熔炼温度升高而向右移动，当足够大时，铂颗粒不能形成。     

低熔封接玻璃组成及其发展

综述了低熔封接玻璃的组成特点，给出了大量低熔玻璃组成实例，批出了低熔封接玻璃的封接低温化和无铅化发展方向，磷酸盐玻璃是首选组成之一。新的制备工艺和新的玻璃形成体系将对封接玻璃发展起着十分重要的作用。     

Preparation of ultra-fine copper powder and its lead-free conductive thick film

In this paper, non-agglomerated monodispersed ultra-fine copper metallic powders have been synthesized with chemical reduction method. Fine lead-free glass powders were also prepared by solid synthesis process. Thick film paste prepared by above-mentioned copper metallic powders and lead-free glass powders was applied as conductive paste of MLCC. Mixture of glass and zinc oxide give the thick film a high adhesion strength which is attributed to the rough interface from interfacial reaction between glass and chip, and a good densification. Diffusion of metal between copper thick film and nickel thick film is clear. Ni-Cu solid solution appears under high temperature firing.     

溶胶-凝胶生物玻璃多孔材料显微结构和生物活性的扫描电镜及红外光谱分析

本文利用溶胶．凝胶法制备了CaO-P2O5-SiO，系统生物活性玻璃，并以其为原料制备了用于骨修复及骨组织工程支架的块状生物活性材料。利用体外实验方法(invitro)结合x射线衍射(XRD)、扫描电子显微镜(SEM)和傅立叶变换红外光谱分析(FTIR)技术对不同烧结工艺制备的材料结构、晶相和生物活性的影响进行了分析研究。研究表明，经800℃和1100℃烧结5min的两种材料均有硅磷酸钙Ca5(PO4)2SjO4微晶相析出。烧结温度越高，析出微晶相的体积比例越大，材料的生物活性则越低。在模拟生理溶液中碳酸羟基磷灰石(HCA)只在烧结体中的玻璃颗粒表面形成，而在其硅磷酸钙Ca5(PO4)2SiO4微晶相表面未发现HCA形成。