Limestone filler cement in low w/c concrete: A rational use of energy

The effect of limestone filler (up to 20%) on the degree of hydration, the volume of hydration products, and the optimal replacement of limestone filler in cement pastes at different w/cm ratios (0.25-0.50) were investigated by using a quadratic statistical model. The results show an increase in the degree of hydration in very low w/cm ratio paste when the limestone filler content is increased. However, the largest volume of hydration products occurs for high w/cm ratio pastes, for which the available space also increases with the limestone filler content. Finally, for a given cement, the optimum limestone filler content for different w/cm ratios can be obtained by using the gel-space ratio concept.In addition, concrete mixtures (w/cm=0.30 and 0.34) were made to determine the compressive strength. The results have shown that concretes containing limestone filler cements present a small reduction of strength at 28 days improving the hydration of clinker particles in the system. The strength of concrete depends on the gel-space ratio, which takes into account all of the effects produced by limestone filler addition: the increase of the degree of hydration, the dilution, and the increase of the effective w/c ratio.     

压力流化床燃烧煤水混合燃料泵送给料技术在国外的研究进展

压力流化床燃烧技术近二十年来在世界上得到很大发展。煤的湿法给料系统具有比干法输送系统更简单，运行调节更可靠等优点。煤水混合物可泵送的水分在２５％左右，煤的粒度一般为０～６ｍｍ，表现为非牛顿的假塑性流体特性，通过级配来达到一定的稳定性和良好输送性能，且流动阻力低，不用添加剂即可实现泵送，它的应用使压力流化床的燃烧制备和输送系统成本大大降低。     

羟丙基糯米粉糊的特性及应用初探

研究了羟丙基糯米粉糊的性质，以及流变特性和温度影响流变特性的规律，并对其在蚝油食品中作为增稠稳定剂的应用做了初步研究。结果表明，糯米粉经羟丙基化后，凝沉性更弱，受热易于成糊和分散，糊的粘度提高，冻融稳定性极佳，透明度大为提高，但是抗剪切稳定性反而降低。在实验测定的温度下，羟丙基糯米粉糊呈现假塑性流体的特征且假塑性随醚化程度的提高而增强。应用试验表明其增稠效果好、稳定性高，可用做增稠稳定剂。     

Cement-based materials for stress sensing by dielectric measurement

The self-sensing of stress by measurement of the relative dielectric constant (κ) has been shown in cement pastes containing steel fibers of 8 μm diameter and carbon filaments of 0.1 μm diameter. The κ value increases nonlinearly and quite reversibly with compressive stress up to 6.4 MPa, although the reversibility is not complete. Inferior sensing performance was observed in cement paste with carbon fibers of 15 μm diameter, although the performance was still better than cement paste without admixture.     

利用广西气刀土原料研制高档卫生陶瓷

在对广西气刀土原料性能研究的基础上,进行了在卫生陶瓷坯料、釉料中的应用研究。坯料中加入4%～7%的广西气刀土原料替代等量的2#苏州土,在釉料中引入4～6%的气刀土原料替代1#苏州土,可以生产出理化性能和外观质量达到了美国ASMEA112.19.2M-1998标准要求的高档卫生陶瓷产品。引入广西气刀土原料使泥浆性能增强、厚化系数降低、湿坯硬度特别是内硬度明显提高、干坯抗折强度增大;制品体积密度增加、气孔率和吸水率降低;增强釉面乳浊效果、提高釉面白度,保证和提高产品的热稳定性能。     

汽车修补涂料色母用分散剂的选用

通过对树脂、颜料、分散剂和混合溶剂的选择和定量,合成了通用色母。用指研法检验色母的分散稳定性,用倾流法或指擦法检验颜料的流动性,介绍了影响色母分散稳定性和颜料流动性的因素和原理,着重讨论了汽车修补涂料色母的单色浆微脂技术中分散剂的复配分散。     

Marsh筒法和净浆流动度法用于水泥与减水剂适应性测试的比较

通过Marsh筒法和净浆流动度法用于水泥与减水剂适应性测试比较发现,采用Marsh筒法无论在测定减水剂饱和掺量点、对经时损失的敏感性上,还是与水泥标准稠度用水量和胶砂流动度的相关性上都优于净浆流动度法。     

建筑陶瓷生产用印膏的研制

利用羧甲基纤维素钠（Na—CMC）、甘油、乙二醇和纯净水等为主要原料制备建筑陶瓷生产装饰用印膏，实验研究了工艺因素对印膏粘度和印刷性能的影响，优化出适合生产使用的印膏配方。结果表明：当Na-CMC的加入量在1．75g～2．25g之间，甘油15g，乙二醇20g，纯净水65g所制备的印膏具合适粘度和良好的印刷性能。     

丁苯橡胶对水泥水化过程及水泥石微观结构的影响

用多种实验手段研究了在普通硅酸盐水泥中掺入丁苯橡胶乳液对水泥水化过程的影响，并用扫描电镜分析了掺入丁苯橡胶后水泥石微观结构形态的改变，从而探讨了丁苯橡胶改善水泥石物理力学性能的机理。     

煤矸石对硬化水泥浆体结构形成的影响

通过对硬化水泥浆体物理力学性能的检测,结合XRD和SEM分析,研究了不同掺量的煤矸石对硬化水泥浆体水化性能的影响。结果表明:随着煤矸石掺量的增加,水泥的标准稠度用水量增加,凝结时间缩短,抗压强度降低,熟料矿物的水化速率提高,水泥-煤矸石体系的水化速率降低。煤矸石掺量不同,水化模式亦不同。