Kinetics of TSCD zinc oxide nano-layer growth by modified diffuse-interface model

Deposition of zinc oxide films from aqueous solutions containing complex Zn²⁺ ions on soda-lime substrates were studied by two-stage chemical deposition (TSCD) process. It was shown that the film thickness can be controlled by the number of dipping stages. Nano-layers were produced with less than nine times dipping stages. Greater dipping numbers resulted in film thickness exceeding 100 nm. The growth rate obeyed double-stage zeroth order with respect to the concentration and first order with respect to the temperature. This rate was proportional to the difference between the temperature of the hot water and the substrate. Overall activation energy of 17.20 ± 0.42 kJ mol⁻¹ and frequency factor of 2.81 ± 0.07 μm s⁻¹ was determined for ZnO deposition. These values were attributed to two resistances. One resistance corresponded with film heat transfer mechanism. The other was attributed to species attachment to the solid substrate. A modification to the diffuse-interface kinetic model was devised for explanation of the latter. EDAX (electron dispersive elemental analysis), XRD (X-ray diffraction) and SEM (scanning electron microscopy) were used to characterize the layer formed. These methods showed that the product consisted solely of pure elliptical ZnO grains.     

季胺萃取锌的动力学研究

以恒界面池法研究了氯化物介质中季胺萃锌的动力学。考查了搅拌转速、传质界面积和温度对萃取速率的影响，判定季爱萃锌为界面化学反应的动力学模式。进一步研究了季胺萃取剂浓度和水相Ｚｎ＾２＋浓度对萃取速率的影响，得到了与理论推断相吻合的速率方程。     

脉冲电流对锌酸盐镀锌层的影响

研究了在锌酸盐镀锌体系中采用脉冲电流时，脉冲频率，脉冲的占空比、反向电流对镀层外观，耐蚀性的影响，发现在最佳脉冲条件下得到的镀锌层比直流电镀得到的镀层光亮，结晶细致，耐蚀性能有很大的提高。     

Crystallization and dissolution behavior of l(+) calcium and zinc lactate in ethanol-water solvent

Crystallization and dissolution behavior of L(+) calcium and zinc lactate in 50% ethanol-water solution was studied. The effects of stirring, standing, ultrasonic wave, and temperature on the crystallization of L(+) calcium and zinc lactate were evaluated. It was found that standing had a positive effect on crystallization of L(+) calcium and zinc lactate, while stirring promoted dissolution of crystallized particles and resulted in high residual concentration in mother liquor. The application of ultrasonic wave did not influence much on crystallization process. L(+) calcium and zinc lactate crystallized easily at 5 ‡C; however, complete crystallization took more than 72 hours. These two salts dissolved rapidly and reached equilibrium within 1 hour.     

碱金属和锌对高炉用SiAlON结合刚玉砖的复合侵蚀

将高炉用SiAlON结合刚玉砖制成外部尺寸为50mm×50mm,内孔尺寸为25mm×25mm的坩埚,分别加入由Na2CO3、K2CO3、ZnO和宝钢高炉现场高炉灰配制的炉渣(其w(Na2O+K2O)=2.75%,w(ZnO)=5.1%)和用K2CO3、ZnO、石墨配制的炉渣(其w(Na2O+K2O)=25%,w(ZnO)=25%),然后分别在还原气氛下于1350℃16h和1100℃40h进行侵蚀试验。将侵蚀后的试样纵向对称剖开,观察渣对试样的侵蚀和渗透情况,进行SEM和EDAX分析。结果表明:碱金属和锌含量不同的两种炉渣对SiAlON结合刚玉砖的侵蚀速度都很小;碱金属侵蚀机理主要是SiAlON与碱蒸气反应生成钾霞石,与渣反应生成铁橄榄石,并参与硅酸盐玻璃相的生成;刚玉颗粒与渣中的FeO、Na2O和K2O反应生成铁铝尖晶石和少量针状β-Al2O3;锌对该砖没有产生明显的化学侵蚀。     

Comparative electrochemical studies of zinc chromate and zinc phosphate as corrosion inhibitors for zinc

The anticorrosive performance of two inhibitive pigments, zinc chromate and zinc phosphate, was compared using electrochemical impedance spectroscopy (EIS) and the scanning vibrating electrode technique (SVET) in pigment extracts in 0.1 M NaCl. It was observed that zinc was protected from corrosion in both extracts. In tests using hot dip galvanised steel painted with an epoxy primer incorporating the pigments, the SVET detected the anodic and cathodic distribution along the scribes, although no significant differences were observed among the various primers. On the contrary, EIS was able to distinguish processes occurring on the metal surface exposed by the scribe in different samples. For primers with anticorrosive pigment, a time constant at high frequencies was attributed to a layer of protective nature, probably formed by metal ions from the substrate and inhibitive ions leached from the anticorrosive pigments.     

碱式碳酸锌生产工艺的研究

本文介绍了碳酸化法新工艺，技术先进、效益明显、产品质量可靠，具有推广应用的价值。     

Removal of Ag(l), Cu(II) and Zn(ll) ions with a supported liquid membrane containing cryptands as carriers

The interface behaviour in the facilitated co-transport of Ag(I), Cu(II) and Zn(II) ions through supported liquid membranes (SLMs) made of a flat-sheet polypropylene membrane support containing cryptands (2.2.2 or 2.2.1) as carriers was studied. The liquid-liquid extraction tests showed a maximum distribution coefficient when the carrier concentration was greaterthan 10⁻⁴M. In transport experiments the transmembrane flux increased with increasing carrier concentration reaching a limiting value at greater than 10⁻³M concentration. The calculation ofthe diffusion coefficients in membranes showed ahigherdiffusivityof2.2.2-metal complexes with respect to 2.2.1-metal complexes for silver ions. A sequence of diffusivity D(Ag+)>D(Cu²⁺)>D(Zn²⁺) was obtained, but carrier 2.2.1 showed a higher selectivity through copper ions. A sequence of diffusivity D(Cu²⁺)>D(Zn²⁺)>D(Ag⁺) was obtained. The diffusivity was significantly higher when using Celgard 2500 support compared to Celgard 2400 or 2402. Variable metal ion concentrations in the feed phase fluxes almost zero, at less than 10⁻² M concentration, were obtained. In the transient state of the transport through the SLM, different molar flow rates at the feed-membrane and membrane-strip interfaces were observed. The selectivity of the interfaces containing 2.2.2 in the separation binary mixtures of ions showed the following separation factors: SF_AgZn = 2.50, SF_AgCu = 1.64, SF_cuZn = 1.42.     

Preparation of zinc ferrite in the presence of carbon material and its application to hot-gas cleaning

In order to develop an efficient absorbent of H₂S in coal gasification, zinc ferrite (ZnFe₂O₄) was prepared in the presence of carbon materials such as activated carbon (AC), activated carbon fiber (ACF), and Yallourn coal (YL). The absorption behavior of absorbents for H₂S was examined using a fixed-bed flow type reactor equipped with a quadrupole mass spectrometer.Carbon material-supported ZnFe₂O₄ exhibited larger desulfurization capacity for H₂S than unsupported ferrites. They could efficiently remove H₂S from 4000 ppm levels in a simulated coal gasification gas to less than 1 ppm at 500 °C. The absorption capacity of H₂S with ZnFe₂O₄/AC, ZnFe₂O₄/ACF, and ZnFe₂O₄/YL exhibited nearly 100% of stoichiometric amount of loaded metal species. They could be regenerated by an air oxidation in O₂-Ar (50 vol%) at 450 °C for 30 min. The regenerated ferrite can be used for repeated absorption of H₂S with a very slight decrease in the absorption capacity.     

Unsteady radiative heat transfer within a suspension of ZnO particles undergoing thermal dissociation

An emitting, absorbing, and anisotropically scattering plain medium containing a suspension of ZnO particles is considered, in which the particles are directly exposed to high-flux irradiation and undergo shrinkage during their endothermic dissociation into Zn(g) and O₂ at above 2100 K. The unsteady energy equation that links the rate of radiative heat transfer to the rate of the chemical reaction is formulated and solved numerically by the finite volume technique and the explicit Euler time-integration scheme. The path-length Monte Carlo method is applied for modeling the radiative transfer within the suspension using the absorption/scattering coefficients and the scattering phase function obtained from the Mie theory. It is found that the particle suspension can be heated rapidly from its initial 300 K to over 1800 K in less than 0.1 s, resulting in a more uniform temperature profile as the reaction progresses, particles shrink, and the suspension becomes optically thinner. The chemical conversion increases with decreasing initial particle diameter and volume fraction due to the efficient radiative absorption.