室式分离机转鼓结构的改进与液流分析

介绍了室式分离机的转鼓结构及工作过程．为提高这种机器的分离效率,重点对室式分离机的转鼓结构做了改进．通过对室式分离机改进型转鼓中悬浮液的流动速度进行分析,为实现不停机自动排渣提供理论基础．     

Rotordynamic forces generated by discharge-to-suction leakage flows in centrifugal pumps

In order to investigate the flow-induced vibration in the shroud passage of centrifugal pump and predict rotordynamic forces of centrifugal pump rotor system,an analysis of rotordynamic forces arising from shrouded centrifugal pump is presented. CFD techniques were utilized to analyze the full three-dimensional viscous,primary/secondary flow field in a centrifugal pump impeller to determine rotordynamic forces. Multiple quasi-steady solutions of an eccentric three-dimensional model at different whirl frequency ratios yielded the rotordynamic forces. The skew-symmetric stiffness,damping,and mass matrices were obtained by second-order least-squares analysis. Simulation of the coupled primary/secondary flow field was conducted,and the complex flow characteristics in the flow field of a shroud passage were achieved including the mean velocity and pressure,as well as the eddy in a large scale of flow field due to viscosity. The rotordynamic force coefficients were calculated,and the results were in good agreement with those of experiment except for the direct inertial coefficient without the consideration of whirling forces from the impeller primary flow passage.     

混合溶剂法脱除软沥青的喹啉不溶物

煤沥青中含有较多的喹啉不溶物会影响炭材料的性能。以软沥青为原料,采用混合溶剂离心法对其进行脱除喹啉不溶物试验研究。考察了芳烷比、溶剂比、离心时间、离心温度对精制沥青的喹啉不溶物含量和收率的影响。结果表明：当芳烷比一定时,精制沥青喹啉不溶物含量和收率随溶剂比的增大而减小;当溶剂比一定时,精制沥青喹啉不溶物含量和收率均随芳烷比的增大而增加;离心时间越长,所得精制沥青喹啉不溶物含量越低,收率也越低;离心温度升高,有利于喹啉不溶物脱除,离心温度的较优选择为80℃。通过调整混合溶剂的比例,可以方便地控制净化过程的收率和喹啉不溶物含量。     

涡轮桨变速搅拌槽内湍流混合的实验研究

以NaCl颗粒在水中的溶解为例,对湍流状态下周期性变速旋转的（改变桨叶转向或速度大小,分别称为周期性换向搅拌和周期性依时搅拌）Rushton桨搅拌槽内的混合特性进行了实验研究,并与稳速搅拌进行了对比。实验过程中测量了不同搅拌模式、不同桨叶安装高度时颗粒的溶解时间,结果证明,搅拌槽底部的流型对NaCl的溶解有重要影响;桨叶安装高度对溶解速度的影响不大,周期性依时搅拌时的溶解时间比稳速搅拌时稍短,而周期性换向搅拌则能明显加快溶解速度,提高混合效率。     

基于有限体积法的G4-73型离心风机三维流场数值模拟

基于有限体积法,利用Fluent软件对G4-73型离心风机内部流场进行了全三维数值模拟。结果表明:蜗壳内的低能流体区沿轴向朝流动方向推进;叶轮内的静压和动压在叶片吸力面靠近叶轮进口处最低,叶轮流道中动压等值线呈"凸"型分布,在叶片压力面靠近叶轮出口处静压和动压达到最大值,且叶轮出口相对总压损失集中在吸力面和前盘侧。     

Fabrication of a gradient refractive index preform using laminar shear mixing

A gradient refractive index rod was successfully prepared by a new fabrication method using laminar shear mixing, and a graded index polymer optical fiber that satisfied IEEE1394b was obtained from the method. To fabricate the gradient refractive index rod, a liquid monomer mixture with a relatively low refractive index was placed in a prepared cylindrical glass reactor and a transparent polymer rod with a higher refractive index was introduced at the center of the reactor. The reactor and the polymer rod were then rotated concurrently with a small rotating speed difference to generate a Couette flow in the liquid phase. The centrifugal force generated by rotation and the polymer diffusion into the liquid monomer mixture developed a graded concentration profile in a radial direction. The Couette flow could reduce the concentration fluctuation in a tangential direction. In addition, the graded index profile could be controlled by the copolymer composition of the rod and its diameter. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 95: 1100–1104, 2005     

气液两相机械搅拌釜中翼型组合桨持气特性

研究了机械搅拌釜中翼型组合桨的组合方式、桨间距、通气位置及翼型桨的排出流方向对气含率的影响。在单位体积功率消耗相同的情况下,采用以翼型k5桨为下层桨、较低的通气位置及较大的桨间距为搅拌釜的几何结构,并采用翼型桨的排出流方向向上的搅拌方式,可以提高搅拌釜的气含率。给出了气含率与单位体积功耗和表面气速的关联式。     

Investigations of fluid dynamics in mechanically stirred aerated slurry reactors

The fluid dynamics of stirred aerated slurry reactors with A-310® propeller, 4-blade 45° pitch turbine and 6-blade Rushton disc turbine were studied over a wide range of gas flow rates. With respect to power consumption, gas hold-up, and fluid dynamically limiting cases, viz., suspension and flooding, the Rushton disc turbine was found to be the best in stirred aerated slurry reactors. The influence of particle density, shape and mass fraction and of liquid properties on gassed critical stirrer speed, N_jsg, and of gassed power input per unit volume, P_jsg, on particle suspension and gas dispersion, were investigated. Empircal correlations in combination with that of Zwietering were established for scale-up design in three-phase slurry reactors.     

湿法磷酸固-液体系混沌混合与浸出强化行为

湿法磷酸浸出过程中，传统刚性搅拌桨的作用方式主要是剪切作用，容易形成对称性流场结构，降低搅拌效率。实验考察了桨叶类型、离底高度、搅拌速度、柔性钢丝绳长度、柔性钢丝直径对磷矿浸出率及最大Lyapunov指数(LLE)的影响。实验结果表明：刚柔组合桨通过刚-柔-流的耦合作用，改善流场的结构，提高了流体混沌混合效果。当搅拌转速225 r/min，浸出时间120 min，离底高度h=T/4，柔性钢丝绳直径d= 0.42r，柔性钢丝绳长度L=1.3T时，刚柔组合桨的最大Lyapunov指数达到0.09071，磷矿浸出率提高了10.8%。另外，在相同的功耗(P _v=9890 W/m³)条件下，刚柔组合桨使反应器内的悬浮均匀度和渣中磷含量分别降低了40.8%和17.67%，有效地改善了晶体的形貌，提高了磷石膏的过滤性能，强化了颗粒的混合与浸出。     

堰塞体溃决离心模型试验供水系统关键技术研究

堰塞体溃决洪水洪峰流量及洪水时程曲线特征的预测是堰塞湖应急抢险及下游风险控制方案制订的重要依据。堰塞体溃决的离心模型试验,在研究堰塞体溃决机理、溃决过程及溃决洪水的历时曲线特征方面独具优势,但离心模型试验供水系统的设计,涉及到从外部静止状态到高速旋转状态的模型中连续供水,同时还要保证堰塞体溃决过程中上游水位为设定的常水头,是堰塞体溃决离心模型试验中的关键性的一大难题。本文围绕以上难题,设计了一种环形水箱以解决从静态到动态模型的连续供水问题,通过理论分析,确定了环形水箱中可提前注入的最大水量。另外在试验箱设置了竖井式溢流口,可以排出高出设定常水头的水体,保证了上游水位的稳定。通过以上设计有效地解决了供水系统中的关键难题,并在后续堰塞体溃决离心模型试验中得到了验证。