用分数延迟改进基音预测的CELP编码方案

在ＣＥＬＰ编码器中，通常用延迟为抽样间隔整数倍的长项预测器表征浊音语音的准周期性，然而在低比特率，这种限制降低了编码器的性能。本文在介绍了ＣＥＬＰ编码器原理及激励码本构成后，重点研究了一种新型的基音预测方法；分数延迟基音预测，计算机模拟结果表明，这种方法能对浊音进行更准确的表达，尤其对女性讲话者明显改善了语音质量。     

Zero aliasing ROM BIST

Signature analyzers are very efficient output response compactors for BIST design. The only limitation of signature analysis is the fault coverage reduction (aliasing) due to the information loss inherent to any data compaction. In this article, in order to increase the effectiveness of ROM BIST, we take advantage from the simplicity of the error patterns generated by ROMs and we show that aliasing free signature analysis can be achieved in ROM BIST.This work was performed when the author was on leave from Minsk Radio Engineering Institute, Computer Department, Belorus.     

采用信息融合技术的IR／MMW复合导引头的目标跟踪

从误差测量环节入手，基于IR／MMW双模结构，采用信息融合处理技术提高其估计跟踪精度，最终达到降低制导误差，提高武器性能的目的，仿真结果验证了该方法的有效性。     

汉白玉废料制备球形纳米碳酸钙的研究

将汉白玉废料通过高温煅烧分解得到氧化钙,再用氯化铵循环液溶解氧化钙制得碱性氯化钙溶液,除去其中的Mg、Fe等杂质得到氯化钙精制溶液,利用化学方法合成得到碳酸钙粉体.用X射线衍射(XRD)、扫描电镜(SEM)及激光粒度分析仪、白度仪对碳酸钙产品的晶相组成、形貌、粒度分布、白度及化学组成进行了分析,所得产品为纯度达98.5%以上、白度达97%以上、平均粒度为80nm左右的球形纳米级碳酸钙.并对碳化反应速率及合成球形纳米碳酸钙的影响因素进行了分析.实验中循环使用NH4Cl,氨的排放量小,减少了环境污染.     

Stress Concentration Factors for a Circular Hole in Curved Beams Under Bending Loads

Abstract: As a contribution to the field of stress concentration studies, the case of circular hole in curved bar elements under bending is hereby studied. Trend values of stress concentration factors (SCF) are presented based on selected variables of the problem for two critical hole locations. The results will help to identify an SCF law for practical use by applying the statistical method of regression analysis. Two approximations obtained by means of computational methods are compared with those obtained by photoelastic experimental method.     

An adaptive non‐conforming finite‐element method for Reissner–Mindlin plates

Adaptive algorithms are important tools for efficient finite‐element mesh design. In this paper, an error controlled adaptive mesh‐refining algorithm is proposed for a non‐conforming low‐order finite‐element method for the Reissner–Mindlin plate model. The algorithm is controlled by a reliable and efficient residual‐based a posteriori error estimate, which is robust with respect to the plate's thickness. Numerical evidence for this and the efficiency of the new algorithm is provided in the sense that non‐optimal convergence rates are optimally improved in our numerical experiments. Copyright © 2003 John Wiley & Sons, Ltd.     

分布系统中多米诺效应的分析与消除

分布系统中发生故障后,错误信息在进程间的传播,以及由此引起的系统恢复过程中的多米诺效应是分布系统容错恢复技术所面临的最重要与最困难的问题.目前各种研究工作偏重于具体的系统动态恢复技术.本文的研究重点在于首次揭示多米诺效应本身固有的数量特征及其与分布系统技术参数间的联系,给出多米诺效应动态消除技术,引入系统额外开销的下限,并针对动态技术的缺点,探讨多米诺效应的静态消除技术,为解决困难开辟新途径.     

非均相成核中间相炭微球的形成过程及其结构演变

以含有喹啉不溶物的煤焦油沥青为原料，在410℃、不同反应时间下获得一系列中间相炭微球(MCMB)和小于0．5μm的碳质颗粒(SCP)。通过对中间相沥青的软化点、族组成和MCMB、SCP的形貌及MCMB断面结构的分析，认为非均相成核MCMB的形成和生长过程不同于均相成核的融并生长过程，而是SCP碳质颗粒的构筑过程，我们称之为“球形基本单元构筑”过程。在MCMB生长过程中，体系的黏度对SCP的形成和MCMB的生长起着重要的作用。非均相成核MCMB的内部结构不是三种模型结构(“地球仪”型、“洋葱”型和“同心圆”型)中的任一种，而是炭层具有收缩点的复杂结构，并且球体的结构不具有“继承性”，即随着反应时间的延长而不断发生变化和调整。MCMB内部分子在球体生长过程中的主要变化趋势是分子的不断缩合长大，而不是分子片层的平行趋向。     

Multi-User MIMO Mobile CDMA Uplink System Employing Turbo Coding and Joint Detection Through a Multipath Rayleigh Fading Channel

In this paper, a generalized multiple-input multiple-output (MIMO) antenna system that can be fitted to the uplink of a wireless communication system is considered for the general case of multi-user. At the transmitter, the information bits are Turbo coded, then interleaved and passed through a serial-to-parallel converter. The channel is assumed bad urban suffering from multipath Rayleigh fading resulting in inter-symbol and multiple access interferences (ISI and MAI). At the front-end of the receiver, a number of receiving antennas are used followed by a joint multi-user estimator based on the Minimum Mean Square Error Block Linear Equalizer (MMSE-BLE).Computer simulations demonstrate a significant performance improvement in both single user and multi-user cases.This paper depends in parts on that presented at the 11th European Wireless Conference, Cyprus, Nicosia, pp. 187–192, April 2005. Yasmine A. Fahmy was born in Guiza, Egypt, on June 4, 1976. She received the B.Sc., M.Sc. and Ph.D. degrees in Communication and Electronics engineering from Cairo University, Egypt on 1999, 2001 and 2005 respectively. She is presently an assistant professor at Cairo University, Egypt. Her current field of interest is wireless communication and channel estimation. Hebat-Allah M. Mourad received her B.Sc., M. Sc. and Ph.D. degrees in electrical communication engineering from Cairo University, Egypt, in 1983, 1987 and 1994 respectively. Since 1983, she has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently associate professor there. Her research interests include optical fiber communications, mobile and satellite communications. Emad K. Al-Hussaini received his B.Sc degree in Electrical Communication Engineering from Ain-Shams University, Cairo, Egypt, in 1964 and his M.Sc and Ph.D. degrees from Cairo University, Giza, Egypt, in 1974 and 1977, respectively. From 1964 to 1970, he was with the General Egyptian Aeroorganization. Since 1970, he has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently professor there. He was a research fellow at Imperial College, London, UK, and at the Moore School of Electrical Engineering, University of Pennsylvania, Philadelphia, PA, USA, in the academic years 1976/1977 and 1981/1982, respectively. In 1990, he received the Egyptian national encouragement award for outstanding engineering research. He has written several papers for technical international journals and conferences. His research interests include signal processing, fading channel communication, modulation, and cellular mobile radio systems. Dr Al-Hussaini is a senior member of IEEE. He is listed in Marquis Whos Who in the World and in the IBC (International Biographical Center, Cambridge) for outstanding people of the 20th century.     

金属材料性能试验数据的统计处理

详细阐述了试验数据的表示方法以及数据统计的方法，分析了测量数据的不确定性产生的原因及其确定和测量误差产生的原因及其传递。