复合果胶酶加工番石榴果汁的工艺优化

采用法国产的复合液态果胶酶加工番石榴果汁。研究结果表明,最佳工艺条件为:每千克番石榴果浆加入20mL浓度为0.01mL/mL的复合液态果胶酶、pH为3.5、45℃下恒温酶解5￣6h。使用不同的澄清剂对番石榴果汁进行澄清,结果表明,加浓度为0.5%的明胶溶液20mL/kg果汁中的效果最佳。番石榴果汁,保持了原有果实的营养成分和保健功能,有独特的风味。     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

对水厂一期滤池技术改造后的经济评价

本文主要从经济角度分析净水厂实际生产情况及经济技术指标等方面的数据。阐述福州西区水厂一期滤池由原先双阀滤池改造成V型滤池的经济性。     

A New Algorithm for the Elimination of Common Subexpressions in Hardware Implementation of Digital Filters by Using Genetic Programming

A new algorithm based on Genetic Programming (GP) for the problem of optimization of Multiple constant Multiplication (MCM) by Common Subexpression Elimination(CSE) is developed. This method is used for hardware optimization for DSP systems. A solution based on Genetic Programming is shown in this paper. The performance of the technique is demonstrated in one- and multi-dimensional digital filters with constant coefficients.     

指状椭圆函数滤波器的研究与设计

阐述了指状椭圆函数滤波器的特点、适用范围，基本理论以及设计方法。用本文导出的公式进行设计有工程应用价值，介绍了一个L波段滤波器的例子。     

DT型粉状炸药专用蜡的研制

以多种含蜡馏分为基础原料，添加适量DT复合添加剂研制的DT型粉状炸药专用蜡具有优异的分散性和抗水性，可满足各种低梯粉状炸药要求，简化炸药配方，方便操作及其质量控制，以其生产的炸药爆速高，贮存期长，各项性能满足GB12437－2000标准要求。     

内外齿复合冷挤压成型实验研究

通过对轿车转向盘毂件内外齿进行的复合挤压实验研究 ,得到了新式复动式复合挤压模具结构 ,并确定了一种合理的成型工艺方案     

Centrifugal Casting of High Speed Steel/Nodular Cast Iron Compound Roll Collar

Ｈｉｇｈ ｓｐｅｅｄｓｔｅｅｌ (ＨＳＳ) ,ｉｓｃｈａｒａｃｔｅｒｉｚｅｄｂｙｅｘ ｃｅｌｌｅｎｔｈａｒｄｎｅｓｓ ,ｗｅａｒｒｅｓｉｓｔａｎｃｅ ,ａｎｄ ｇｏｏｄｒｅｄｈａｒｄｎｅｓｓ .Ｒｅｃｅｎｔｌｙ ,ＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｈｏｔｒｏｌｌｉｎｇｒｏｌｌｓｔｏｐｒｏｄｕｃｅｓｔｒｉｐｓｏｆｇｏｏｄｓｈａｐｅａｎｄｓｍａｌｌｃｒｏｗｎｗｉｔｈｅｘｔｅｎｄｅｄｒｏｌｌｓｅｒｖｉｃｅｌｉｆｅ[1,2 ] .ＴｈｅＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｒｏｌｌｃｏｌｌａｒｆｏｒ…     

一种适用于有限长度混合相位未知脉冲的最小平方反褶积新方法

普通的最小平方反褶积只有在子波为最小相位脉冲和反射序列为白噪声的假设下才是成立的,而对于混合相位未知脉冲来说,这种最小平方反褶积就不再适用了。本文提出一种适合于有限长度混合相位未知脉冲的最小平方反褶积方法。运用此法只需预先估计一个混合相位子波的长度。合成数据的试验结果表明,该方法有较好的效果,且对预先估计出的子波长度不敏感。文中还证明混合相位未知脉冲最小平方反褶积等效于一种有间隙的平滑误差滤波器的作用,而这种有间隙的平滑误差滤波又可分解为一个前向多步预测误差滤波与一个后向多步预测误差滤波之和。可以预计这种新的反滤积方法将在地震数据处理中得到有效的应用。     

一种有机硫类絮凝剂DTC的合成及性能评价

讨论了由有机伯胺或仲胺和CS2合成二硫代氨基甲酸盐DTC的反应及副反应,简介了合成工艺。根据红外光谱确认了由三乙烯四胺合成的二硫代氨基甲酸盐（以下简称DTC）的结构。以含原油350 mg/L、含悬浮固体55.1 mg/L,含Fe^2＋10.0 mg/L的模拟污水为实验水样,考察了该DTC的絮凝性能,在40℃、pH=6-7、沉降时间30分钟条件下DTC的适宜加量为20 mg/L,此时污水含油量为9.0 mg/L;使用DTC的适宜pH范围在4-8,pH=6为最佳值,适宜温度范围为10-45℃,温度高于45℃时DTC可发生热分解;DTC的除油效果随污水中Fe^2＋浓度增大而改善。在含油89.1 mg/L、含悬浮固体55.1 mg/L、含Fe^2＋13.2 mg/L的油田污水中,DTC的除油率最高,远高于常用絮凝剂PFS,PAC,CPAM,HPAM和PAM。当污水中不含Fe^2＋时,DTC无絮凝除油效果。讨论了DTC在Fe^2＋参与下的絮凝过程。图5表1参8。