Growth,characterization and electrical anisotropy in GaTe—a natural semiconducting superlattice

GaTe is a III–VI semiconductor which has layered structure with large anisotropy in electrical properties. Growth of single crystals by the Bridgman technique permitted the measurement of thermoelectric power in orthogonal directions from which the anisotropy of hole effective masses were determined for the first time. From resistivity and Hall effect measurements the carrier activation energies and scattering mechanisms between 10–300°K were found. Study of the temperature dependence of conductivity revealed a variety of conduction mechanisms including weak localization below 20°K, hopping conduction between 20–50 K and band conduction in and across the layer planes atT>70 K. Weak localization was confirmed through observation of negative magnetoresistance. TheI–V characteristics showed quantized behaviour due to tunneling across potential barriers, which may be due to stacking faults between layer planes as observed by TEM studies.     

Application of SiC-Si functionally gradient material to thermoelectric energy conversion device

Because of its high–temperature chemical stability, SiC ceramic is a promising material for high-temperature device applications such as thermoelectric energy converters. However, the electrical conductivity of SiC ceramic is too low for it to be used as a thermoelectric energy converter at the cold junction. Therefore, we propose a SiC-Si functionally gradient material (FGM) in order to improve the electrical conductivity of the SiC ceramic at the cold junction. An SiC rod was fired in a temperature gradient furnace. One end of the SiC rod was maintained at 2473 K and the other end was maintained at 1973 K for 30 min. After firing, the porous SiC edge fired at 1973 K was dipped into molten Si in order to infiltrate molten Si into the porous SiC. The microstructure of the FGM is classified into three regions: the SiC-Si composite material; the porous SiC ceramic; and the densified SiC ceramic. The electrical conductivity, the Seebeck coefficient and the thermal conductivity for each region of SiC-Si FGM was measured at 300 K; a figure of merit was calculated. The figure of merit of the SiC-Si FGM at the cold junction, at room temperature, was 10⁸ times higher than that of a nongradient SiC ceramic.     

绿豆纤维功能饮料的工艺研究

探讨了新型保健绿豆纤维功能饮料的生产工艺,对影响产品品质的几个主要因素进行了较为深入的探讨,提出了生产绿豆纤维功能饮料的最佳工艺条件。     

高炉鼓风机电气控制技术改造

对高炉鼓风机事故原因分析发现，低电压保护动作、二次控制电源断电、电网电压突降是造成风机自动跳闸的主要原因。对风机电气控制技术进行改进，采取了去掉低电压跳闸保护、增设专用二次控制电源、设置瞬时断电延时自启动控制线路等措施，有效地避免了风机故障的发生，年减少经济损失66．13万元。     

基于B点磁探针膛内电枢电弧长度与速度分布测量的计算机控制系统的研究

基于B点磁探针的测量原理，建立了电磁轨道炮膛内三维等离子体电枢电弧长度和电弧运动速度测量的数学模型，通过对该模型的分析给出了用于测量膛内电枢电弧长度和运动速度分布的相应推论。开发了用于测量膛内等离子体电枢电弧长度和速度的多通道计算机控制诊断系统，并进行了相应的试验研究。     

Electrical conductivity in iodine-doped ethyl cellulose

The electrical conductivity of solution-grown ethyl cellulose (EC) films, 5–30 μm thick, has been studied in the sandwich configuration (metal–EC–metal) as a function of iodine concentration from 0.5 to 5.0 wt% ratio. The studies were conducted in the temperature range 333–383 K, while the field was varied over the range (3.0–5.5) × 10⁴V/cm. Aluminium was used as the lower electrode, while the upper electrode was of Al, Ag, Cu, Au or Sn. Certain transient effects such as a large burst of current immediately after the application of field were observed. An attempt was made to identify the nature of the current by comparing the observed dependence on electric field, electrode material and temperature with the respective characteristic features of the existing theories of electrical conduction. The results show that the electrical conduction follows Ohm's law at lower fields, while at higher fields, space-charge limited current (SCLC) was observed. It was also found that Richardson–Schottky emission was responsible, to some extent, for the transport of charge carriers in the polymer. The conductivity of the films increased on doping with iodine. The dopant molecules are considered to act as additional trapping centes and provide links between the polymer molecules in the amorphous region, thus resulting in the formation of charge transfer complexes.     

Adsorption and decomposition of H2S on Pd(1 1 1) surface: a first-principles study

Gradient-corrected density functional theory was used to investigate the adsorption of H₂S on Pd(1 1 1) surface. Molecular adsorption was found to be stable with H₂S binding preferentially at top sites. In addition, the adsorption of other S moieties (SH and S) was investigated. SH and S were found to be preferentially bind at the bridge and fcc sites, respectively. The reaction pathways and energy profiles for H₂S decomposition giving rise to adsorbed S and H were determined. Both H₂S_(ad) → SH_(ad) + H_(ad) and SH_(ad) → S_(ad) + H_(ad) reactions were found to have low barriers and high exothermicities. This reveals that the decomposition of H₂S on Pd(1 1 1) surface is a facile process.     

Important features of Iris OSQL

OSQL is the object-oriented database language developed for the Iris object-oriented database management system at Hewlett-Packard Laboratories. Its three fundamental constructs are objects, types, and functions. This paper provides an overview of the underlying concepts and some important features of OSQL.     

Procedures for analysis of strain transfer in the acetabular region in vitro

The failure of acetabular cups via loosening, migration or fracture is partially related to the stress distribution existing in the acetabular region. The complexity of the investigation of these stresses demands the application of a variety of model testing techniques involving combined embedded strain gauging, finite element analysis, transmission and reflective photoelasticity and crack propagation studies. The application of these procedures are described and the difficulties of obtaining representative loadings and restraints are commented upon.