SiCp/2024复合材料的氢脆敏感性研究

在浸泡、阴极极化、阴极极化同时迭加拉伸变形、添加As₂O₃毒化剂等常见致氢条件下,通过慢应变速率拉伸试验研究了SiC_p/2024复合材料的力学性能,考察了断口形貌.测定了该材料在按几种常用充氢条件充氢后的氢含量.发现虽然强烈阴极极化使材料力学性能下降,但其原因在于阴极极化引起的碱性腐蚀,与氢脆无关.获得了不同于前人研究的新结论:在本文试验条件下SiC_p/2024材料不发生氢脆,也不发生不可逆氢损伤,其原因与该材料难以充入氢有关.     

ERD facility for analysis of hydrogen and deuterium in solids

Hydrogen is the lightest element in nature, and so, its detection and quantitative analysis is difficult by the conventional methods utilized for other elements. In the recent years the technique of elastic recoil detection analysis (ERD) using 1–2 MeV He⁺ beam has been developed to quantitatively and simultaneously analyze hydrogen and its isotopes in solids. Such a facility has been set up using the 2 MeV Van-de-Graaff accelerator at IIT Kanpur. It facilitates H and D analysis in a material up to a depth of ∼ 1μm with a detection sensitivity of 0·1 at.% and depth resolution of about 300 ?. The application potential of this setup is illustrated by presenting the results of measurements performed on Al:H:D systems prepared by plasma source ion implantation and highT _c YBCO pellets exposed to humid atmosphere.     

采用混合物作工质的J—T节流制冷机

报告了国内外采用混合物作工质的Ｊ一Ｔ节流制冷机的实验研究情况。理论计算的两个重要参数（等温节流效应和正常沸点）与这些实验的结果作了对比。另外，给出了工作在不同压力下的一种混合工质及纯氮的焓温图。从理论计算和实验的结果可以看出混合工质Ｊ一Ｔ节流制冷机比单纯工质的Ｊ一Ｔ节流制冷机有更大的制冷量和更高的热效率。     

Plasma immersion ion implantation for SOI synthesis: SIMOX and ion-cut

We have demonstrated feasibility to form silicon-on-insulator (SOI) substrates using plasma immersion ion implantation (PIII) for both separation by implantation of oxygen and ion-cut. This high throughput technique can substantially lower the high cost of SOI substrates due to the simpler implanter design as well as ease of maintenance. For separation by plasma implantation of oxygen wafers, secondary ion mass spectrometry analysis and cross-sectional transmission electron micrographs show continuous buried oxide formation under a single-crystal silicon overlayer with sharp Si/SiO₂ interfaces after oxygen plasma implantation and high-temperature (1300°C) annealing. Ion-cut SOI wafer fabrication technique is implemented for the first time using PIII. The hydrogen plasma can be optimized so that only one ion species is dominant in concentration and there are minimal effects by other residual ions on the ion-cut process. The physical mechanism of hydrogen induced silicon surface layer cleavage has been investigated. An ideal gas law model of the microcavity internal pressure combined with a two-dimensional finite element fracture mechanics model is used to approximate the fracture driving force which is sufficient to overcome the silicon fracture resistance.     

D-10D磨煤机润滑油系统加装冷却器

针对鄂州发电有限责任公司磨煤机夏季轴瓦温度高，容易诱发烧瓦问题，进行深入分析，提出了多种解决方案，对各方案的可操作性及利弊进行了对比，选出了最佳方案并进行了实验，取得了明显的效果。     

Selective partial oxidation of light paraffins with hydrogen peroxide on thin-layer supported Nafion-H catalysts

Thin-layer carbon supported Nafion-H catalysts were found to be active and highly selective (S>98%) for the partial oxidation of C₁-C₃ alkanes, in a three phase catalytic membrane reactor (3PCMR), under mild conditions and in the presence of H₂O₂. The influences of the catalyst teflon loading and H₂O₂ concentration on the reaction rate have been evaluated. A reaction pathway, based on the electrophilic hydroxylation of the C-H bond of alkanes with protonated hydrogen peroxide (H₃O ₂ ⁺ ), is discussed.     

Hydrogen incorporation in Ni–P films prepared by electroless deposition

Electroless NiP films, with 12 to 16 wt % P, were deposited from a moderately acid solution. Thermogravimetric analysis indicates the presence of occluded hydrogen in the layers, which desorbs upon heating. The amount of incorporated hydrogen decreases when the pH of the solution or the nickel sulfate concentration is increased; by contrast it increases with hypophosphite concentration. Cyclic voltammetry, using an electrochemical quartz crystal microbalance, confirms the existence of parasitic reactions, namely the reduction of protons of the solvent during the cathodic process and oxidation of hydrogen during the dissolution of the layers. This behaviour is in qualitative agreement with the proposed reaction scheme.     

�����������ɺͼӹ��е�һЩ��������

本文简要介绍了国外在开发超酸性气体过程中遇到的材料选择、腐蚀监测、水化物堵塞、超酸性气的处理和加工等问题所采取的措施和办法。     

催柴加氢装置分馏系统空冷改造方案的探讨

对催柴加氢装置分馏系统空冷存在的问题进行了剖析,认为两塔回流温度不能同时满足工艺需要的主要原因是2台空冷共用风机造成的,并对改造方案进行了比较。     

过氧化氢爆炸事故浅析

通过两起过氧化氢(双氧水)爆炸事故，分析了过氧化氢由于本身具有较大的潜能，很不稳定，当受热、泄漏、撞击、摩擦时，易分解放热产生高温，造成火灾爆炸事故，对火灾爆炸反应过程与爆炸机理进行了探讨。