接触网绝缘子泄漏电流在线监测装置设计

为有效地预测接触网绝缘子污秽水平,提高接触网运行安全可靠性,设计了一种基于ARM的接触网绝缘子泄露电流在线监测装置。通过传感器采集泄露电流和环境湿度预测绝缘子污秽水平,从而判断绝缘子是否应该进行清洗。选取了FQBJ—25/8—760P复合绝缘子为研究对象,在饱和空气湿度下,利用在线监测装置进行人工污秽实验。利用实验数据拟合污秽水平与泄漏电流的关系曲线,为确定接触网绝缘子泄漏电流在线监测装置的预警值提供指导。基于污闪发展三区段思想,提出接触网绝缘子安全运行区、污秽清理区及危险区。     

机车车载漏电流数字传感器研究与应用

介绍一种机车车载漏电流数字传感器的研究与应用,在模拟漏电流传感器的基础上,经数字化改进而实现.硬件设计采用ARM平台,在分析系统原理的基础上,完成了硬件系统和软件架构的设计,完成了单线和双线的模拟实验.经模拟实验验证检测准确、反应快速,通信采用CAN总线安全可靠.在实际测量中,验证了模拟实验的正确性,设计可行.     

基于STM32平台的CAN总线车载式漏电流数字传感器

介绍一种基于STM32平台的CAN总线车载式漏电流数字传感器的设计。在高精度模拟漏电流传感器的基础上,采用CAN总线进行数据通信,在目前高端的、低功耗、小系统设计处理器Cortex—M3(STM32)上经数字化改进而实现。该漏电流数字传感器经实验验证检测准确、响应快速、数据通信安全可靠,是目前一种先进的车载式漏电流数字传感器。实际使用时,由多个漏电流数字传感器与一台计算机互接,构成一个多点的漏电检测网络,最终实现漏电检测的综合处理。     

冷却器盘管失效分析及防范措施

本文介绍了冷却器盘管破裂泄漏的情况，分析了失效破坏的原因，并提出防止冷却器盘管破裂泄漏的措施。     

基于机器视觉的转辙机缺口检测方法研究

针对现有转辙机缺口检测方法所存在的问题,本文介绍了一种基于机器视觉技术的转辙机缺口检测基本方法及其原理和步骤。文章详细论述了LSD算法的工作原理,同时本文作者对该算法做出了改进。最后将改进的LSD算法应用在转辙机缺口检测当中,结果表明该检测算法具有良好的稳定性和快速性,并且能够很好的解决转辙机缺口检测的问题。     

核电厂小型承压容器泄漏率直读的可行性分析

对比气体泄漏率的精确计算值与直读值的差异,分析误差的成因并找出切实可行的缩小误差的方法,使得直读法在小型承压容器的大批量泄漏率检测中发挥了重要的作用。     

Nitrogen incorporated diamond-like carbon films by microwave surface wave plasma CVD

Nitrogen incorporated diamond like carbon films have been deposited by microwave surface wave plasma chemical vapor deposition (MW-SWP-CVD), using methane (CH₄) as the source of carbon and with different nitrogen flow rates (N₂ / CH₄ flow ratios between 0 and 3). The influence of the nitrogen incorporation on the optical, structural properties and surface morphology of the carbon films were investigated using different spectroscopic techniques. The nitrogen has been incorporated into DLC:N films which was confirmed by the X-ray photoelectron spectroscopy (XPS) measurement. Moreover, the nitrogen incorporation was accompanied by a variation in the optical gap, which was attributed to the removal or creation of band tail states.     

Diamond-like carbon thin films by microwave surface-wave plasma CVD aimed for the application of photovoltaic solar cells

The nitrogen doped diamond-like carbon (DLC) thin films were deposited on quartz and silicon substrates by a newly developed microwave surface-wave plasma chemical vapor deposition, aiming the application of the films for photovoltaic solar cells. For film deposition, we used argon as carrier gas, nitrogen as dopant and hydrocarbon source gases, such as camphor (C₁₀H₁₆O) dissolved with ethyl alcohol (C₂H₅OH), methane (CH₄), ethylene (C₂H₄) and acetylene (C₂H₂). The optical and electrical properties of the films were studied using X-ray photoelectron spectroscopy, Nanopics 2100/NPX200 surface profiler, UV/VIS/NIR spectroscopy, atomic force microscope, electrical conductivity and solar simulator measurements. The optical band gap of the films has been lowered from 3.1 to 2.4 eV by nitrogen doping, and from 2.65 to 1.9 eV by experimenting with different hydrocarbon source gases. The nitrogen doped (flow rate: 5 sccm; atomic fraction: 5.16%) film shows semiconducting properties in dark (i.e. 8.1 × 10^{− 4} Ω^{− 1} cm^{− 1}) and under the light illumination (i.e. 9.9 × 10^{− 4} Ω^{− 1} cm^{− 1}). The surface morphology of the both undoped and nitrogen doped films are found to be very smooth (RMS roughness ≤ 0.5 nm). The preliminary investigation on photovoltaic properties of DLC (nitrogen doped)/p-Si structure show that open-circuit voltage of 223 mV and short-circuit current density of 8.3 × 10^{− 3} mA/cm². The power conversion efficiency and fill factor of this structure were found to be 3.6 × 10^{− 4}% and 17.9%, respectively. The use of DLC in photovoltaic solar cells is still in its infancy due to the complicated microstructure of carbon bondings, high defect density, low photoconductivity and difficulties in controlling conduction type. Our research work is in progress to realize cheap, reasonably high efficiency and environmental friendly DLC-based photovoltaic solar cells in the future.     

无汞碱性锌锰电池贮存期漏液原因探讨

介绍了无汞锌粉中的杂质、析气量、锌粉形貌以及电池密封圈对无汞碱性电池高温贮存性能的影响，探讨了电池漏液的原因，提出了防止漏液的措施。     

Numerical study of the transfer of shock-wave loading to a screened flat wall through a layer of a powdered medium and a subsequent air gap

The two-velocity, two-temperature model with two stresses in a mixture of a gas and solid particles contacting each other is used to numerically study the dynamic effect of an air shock wave incoming onto a solid wall with a screening layer of a porous powdered medium at some distance from the wall. The process is described for the case of one-dimensional planar motion of the gaseous and disperse phases under the assumption of a viscoelastic behavior of the powder skeleton. The effect of stepwise shock waves onto the porous powdered screen is considered. The influence of parameters of the screening layer and the air gap on the dynamics of loading of the screened solid wall is analyzed. __________ Translated from Fizika Goreniya i Vzryva, Vol. 43, No. 1, pp. 132–142, January–February, 2007.