MC^2电缆介质结构及阻抗分析

本文将用数学和实验两种方法证实MC～2电缆不仅能保证特性阻抗变化不超出电缆技术规范。而且能保证在设计频率范围内电缆结构反射损耗最小。     

一种抑制SDH网中指针调整抖动的平滑相位泄漏技术

指针调整会在ＳＤＨ网中引入非常大的低频抖动。通常，在解同步器中需要采用指针泄漏技术来抑制这种抖动以使设备满足ＩＴＵ－Ｔ建议Ｇ．７８３的要求。本文给出了一种新颖的抑制指针调整抖动的方法，这种方法通过一个数字锁相环对指针抖动进行平滑并将平滑相位调相到一个参考信号上，从而避免了１比特或１／Ｎ比特泄中存在的较大的相位量化阶跃。这种方法对指针抖动的泄漏可以近似为一个平滑的过程。对一个ＡＵ－４／Ｅ４实验系统的     

Evaluation of Serum Volume Losses During Long-Term Storage

Aliquots of serum collected in a large case-control study of cervical cancer were stored at −70°C for up to 4 years during implementation of the study. When 500 μL serum aliquots were thawed in preparation for carotenoid and vitamin A assays, volumes were noticeably variable and fell below 500 μL in the majority of the samples. We were concerned about evaporation/sublimation during storage of the samples because loss of water would concentrate the analytes of interest. We evaluated the use of density and sodium ion concentration measurements to confirm its occurrence. We found that serum density was an unreliable indicator of extent of volume loss since the anticipated increases in density due to evaporation were of the same magnitude as inter-individual variation in serum density. In contrast, Na⁺ concentration is tightly regulated and would rise if water had been lost from the samples. In a representative sample of serum aliquots from the case-control study, 24 of 25 vials contained less than 500 μL of serum. The mean sodium ion concentration (138.1 ± 3.6 mmol/L) was within the normal range for human serum of 136–145 mmol/L, and no correlation was observed between serum volume and Na⁺ concentration. These results strongly suggest that the observed low volumes were not due to evaporative losses. Instead, the variably low volumes of serum aliquots were probably due to pipetting errors in the initial aliquotting resulting from the use of air-displacement pipettes.     

Artificial Neural Network Modeling of Osmotic Dehydration Mass Transfer Kinetics of Fruits

Artificial neural network (ANN) models were developed for the prediction of transient moisture loss (ML) and solid gain (SG) in osmotic dehydration of fruits using process kinetics data from the literature. ANN models for ML and SG were developed based on data over a broad range of operating conditions and ten common processing variables: temperature and concentration of osmotic solution, immersion time, initial water and solid content of the fruit, porosity, surface area, characteristic length, solution-to-fruit mass ratio, and agitation level. The trained models were able to accurately predict the outputs with associated regression coefficients (r) of 0.96 and 0.93, respectively, for ML and SG. These ANN models performed much better than those obtained from linear multivariate regression analysis. The large number of process variables and their wide ranges considered along with their easy implementation in a spreadsheet make them very useful and practical for process design and control.     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

济钢第一炼钢厂降低钢铁料消耗实践

济钢第一炼钢厂通过优化入炉原料结构,改进冶炼工艺,实施少渣炼钢,有效减少了转炉吹损,降低了钢铁料消耗成本,2002年增加炼钢综合经济效益3100多万元。     

Engset multi‐rate state‐dependent loss models with QoS guarantee

We consider a single link loss system of quasi‐random input, described by the Engset multirate loss model (EnMLM). Blocked calls may once reattempt to be connected to the system requiring less bandwidth; then the system is described by the single retry model for finite sources (f‐SRM). The EnMLM and the f‐SRM are extended with the single threshold finite source model (f‐STM), where calls may attempt to be connected to the system with less bandwidth requirements, according to the link occupancy, before blocking occurs. We focus on CBP equalization in the EnMLM, f‐SRM and f‐STM, under the bandwidth reservation (BR) policy. For this analysis, we apply two approximate methods, the Roberts' method and the method of reverse transition rates (RTR), which lead to a recursive CBP calculation. We evaluate the accuracy of the above models under the BR policy by comparing the analytical with simulation CBP results, based on the relative approximation errors (RAE). The results are highly satisfactory because they show that the proposed models (formulas) lead to small RAE. Copyright © 2005 John Wiley & Sons, Ltd.     

Electric and dielectric properties of solution-gas interface-grown PbS films

Dielectric properties andI–V characteristics of solution-gas interface-formed PbS thin-film capacitors (Al/PbS/Al) of various thicknesses have been studied in the frequency range 10-10⁶ Hz at various temperatures (300–443 K). Current-voltage (I–V) characteristics show space-charge-limited conduction. Dielectric constant (ε) increases with increasing film thickness and temperature and decreases with increase of frequency. The loss factor (tanδ) peaks observed in tanδ vs frequency and tanδ vs temperature reveal relaxation effect from dipolar orientation. These maxima shift to higher-temperature region with increasing frequency. The large increase in capacitance (C) and dielectric constant (ε) towards low-frequency (f) region indicates the possibility of an interfacial polarization mechanism in this region.     

半导体激光器到单模光纤耦合技术的现状及发展趋势

简要阐述了半导体激光器到单模光纤的耦合损耗来源，详细介绍和分析了耦合技术的发展和现状，并探讨了耦合技术的发展趋势。     

Heat loss and thermoelectric generator design

With the object of evaluating its importance to thermoelectric generator design, heat loss is introduced into the standard thermoelectric generator design theory. The theory for both the constant hot and cold junction temperatures model and the constant heat input model are so modified. The modification is first order and, therefore, is limited to small leg heat-transfer coefficients. Numerical results using representative properties show that significant differences can exist between the optimum geometry and performance of a generator idealized as lossless and those of a generator designed by the modified theory. The largest differences occur with the constant heat input model.