光催化降解废气过程中紫外辐射照度模拟和优化

为在光催化设计中合理布置紫外灯,减少光在传输过程中的损失,概括总结径向辐射模型、多点源叠加近似辐射模型和离散坐标辐射模型等3种经典的紫外辐射物理模型;基于离散坐标辐射模型模拟某公司生产的光催化氧化废气处理装置的紫外辐射照度;通过调整灯管布置距离改变光强分布,并拟合光催化单元和光催化网表面的平均紫外辐射照度随灯管布置距离变化曲线.结果表明,距离参数在55～65 mm时,该光催化反应装置的光能利用率较好;紫外灯的合理布置可有效提高光能利用率.     

Effects of the International Temperature Scale of 1990 (ITS-90) on CIE Documentary Standards for Radiometry,Photometry, and Colorimetry

The differences between ITS-90 and IPTS-68 above 1235 K are described. It is shown that none of the following CIE definitions or recommendations require revision because of the introduction of the ITS-90: International Lighting Vocabulary definitions; CIE Standard Illuminants A, D₆₅, other illuminants; and sources for realizing CIE Illuminants. The effect of the ITS-90 on previously calibrated sources for realizing CIE illuminants is negligibly small.²     

Bayesian network based general correspondence retrieval method for depth sensing with single-shot structured light

This study reinvestigated one of the most fundamental problems in structure light depth sensing field: correspondence retrieval of features between patterns and images. We formulate the global optimum correspondence retrieval by maximizing a conditional probability of correspondence given observed features, which is depicted by a Bayesian network. Different from traditional “code-only” based correspondence retrieval methods, the proposed Bayesian network based method exploits the positional correlations of correspondences of neighboring features, namely, the correspondences of poorly detected features are estimated with the aid of the correspondences of well detected features. The method performs especially well on challenging scenes with rich depth variations, abrupt depth changes, edges, etc. Experiments show that the proposed method increase the correspondence accuracy by about 40% on challenging scenes, compared with traditional “code-only” based correspondence retrieval methods.     

基于FPGA的开关量输入模块设计

在测控系统中,经常需要对各种现场信号进行采集;该模块主要实现对开关量状态信号进行实时监控,记录状态信息,为故障诊断提供依据;在设计中,采用了光耦隔离器件对输入信号进行了隔离和抗干扰处理,使用了FPGA实现了数据实时采集和中断处理,最后经PCI总线与主机进行数据交互;在故障诊断系统中,该信号采集板工作稳定、可靠,能够满足系统的实时性要求。     

Roll‐to‐roll UV embossing process applied for light bar‐based sub‐wavelength gratings for backlight

This study proposes a roll‐to‐roll process‐based sub‐wavelength grating, which is attached on a light bar to turn the side‐lit red/green/blue (620, 520, and 450 nm) incident rays into a uniformly and normally output white light with high illuminance from the light bar's surface. On the basis of the rigorous coupling wave analysis, the relationship between the first‐order transmission/reflection efficiency and the pitch of the gratings with different shapes was analyzed. The optimal design can effectively reduce the coupling length and enhance the white color balance for display applications.     

Thermal diffusivity of fluids in a broad region around the critical point

Dynamic light scattering is a suitable method for the investigation of transport properties such as the thermal diffusivity of optically transparent fluids. The main advantages of the method are its quickness, the fact of the thermodynamic state of equilibrium of the sample (gradients are not required), and the relatively simple evaluation of data without the necessity of calibration. However, an insufficient production of intensity of scattered light may be a limiting effect. For that reason the vicinity of the gas-liquid critical point represents the classical range of application. In this paper, it is shown that by means of an appropriate choice of experimental apparatus, measurements are also feasible in an extended range of states. Broad regions around critical points of three pure fluids (sulfur hexafluoride, SF₆; ethane, C₂H₆; nitrous oxide, N₂O) over temperature ranges ¦T-T _c¦ of 0.02 to 50 K and density ranges (/_c) of 0.2 to 2 were investigated. In this region the thermal diffusivity shows great variations with temperature and density and cannot be described by means of ideal-gas behavior or relations for liquids. The measurements were carried out along the coexistence curve for both phases, along the critical isochore and along some isotherms with TT _c. The measured or calculated density, pressure, and thermal diffusivity data as well as some correlations are presented.     

一种联合采样的神经网络光场

相比传统的光场绘制技术,神经网络光场(NeRF)方法可使用神经网络拟合场景的光线采样,将隐式编码输入图片的光场,合成新视图. 针对NeRF方法训练时间长,绘制视图慢的问题,提出了一种基于联合采样的NeRF方法,通过使粗糙网络和细腻网络共享均匀采样结果的方法,减少了不必要的光线采样,从而加快了网络训练和视图合成的速度. 实验结果表明,在取得近似视图合成质量的情况下,与NeRF方法相比,所提方法的训练时间减少了20%,视图合成的效率提高了25%.     

Photocatalytic syngas synthesis from CO2 and H2O using ultrafine CeO2-decorated layered double hydroxide nanosheets under visible-light up to 600 nm

The rational design of photocatalyst that can effectively reduce CO₂ under visible light(l>400 nm),and simultaneously precise control of the products syngas(CO/H2)ratio is highly desirable for the Fischer-Tropsch reaction.In this work,we synthesized a series of CeO₂-decorated layered double hydroxides(LDHs,Ce-x)samples for photocatalytic CO₂ reduction.It was found that the selectivity and productivity of CO and H₂ from photoreduction of CO₂ in conjunction with Ru-complex as photosensitizer performed an obvious“volcano-like”trend,with the highest point at Ce-0.15 and the CO/H₂ ratio can be widely tunable from 1/7.7 to 1/1.3.Furthermore,compared with LDH,Ce-0.15 also drove photocatalytic CO₂ to syngas under 600 nm irradiation.It implied that an optimum amount of CeO₂ modifying LDH promoted the photoreduction of CO₂ to syngas.This report gives the way to fully utilize the rare earth elements and provides a promising route to enhance the photo-response ability and charge injection efficiency of LDH-based photocatalysts in the synthesis of syngas with a tunable ratio under visible light irradiation.     

Efficient photodegradation of phenol assisted by persulfate under visible light irradiation via a nitrogen-doped titanium-carbon composite

To realize the utilization of visible light and improve the photocatalytic efficiency of organic pollutant degradation in wastewater, a nitrogen-doped titanium-carbon composite (N-TiO₂/AC) prepared by sol-gel methods was applied in the photodegradation of phenol assisted by persulfate under visible light irradiation (named N-TiO₂/AC/PS/VIS). The results show that a synergistic effect exists between visible-light photocatalysis and persulfate activation. Compared with TiO₂/PS/VIS, the phenol degradation rate was found to be observably improved by 65% in the N-TiO₂/AC/PS/VIS system. This significant increase in degradation rate was mainly attributed to the following two factors: 1) The N and C doping can change the crystal structure of TiO₂, which extends the TiO₂ absorption wavelength range to the visible light region. 2) As an electron acceptor, PS can not only prevent electrons and holes from recombining with each other but can also generate strong oxidizing radicals such as ∙SO₄^– and ∙OH to accelerate the reaction dynamics. The process of phenol degradation was found to be consistent with the Langmuir pseudo-first-order kinetic model with an apparent rate constant k of 1.73 min^–1. The N-TiO₂/AC/PS/VIS process was proven to be a facile method for pollutant degradation with high pH adaptability, excellent visible-light utilization and good application prospects.