高分子金属配合物发光材料的制备技术进展

高分子金属配合物发光材料是一类很有价值的功能材料,评述了有关它的各种合成方法。以金属离子与含配位基团的聚合物进行反应,容易在高聚物之间形成交联,难以获得发光强度高的高分子配合物;使金属离子与高分子配体和小分子配体同时作用,可以得到荧光强度比较理想的产物,但反应难以定量控制;以小分子金属配合物单体与某些单体之间进行共聚合反应,也可获得荧光强度较高的高分子配合物,但聚合反应的空间位阻较大;通过两端都含有配位基团的刚性链的有机小分子配体直接与金属离子配合形成高分子金属配合物;以小分子金属配合物单体进行均聚或者将小分子金属配合物接枝到高聚物上也可以形成高分子金属配合物。     

氮掺杂纳米TiO_2改性涂料及其抗菌性能

将自制的氮掺杂锐钛矿型纳米二氧化钛光催化剂作为功能性组分,加入耐光催化氧化的硅丙乳胶涂料中,制备出一种新型光催化功能性建筑涂料,实现了可见光光催化效应。使用紫外-可见光吸收光谱研究该功能性涂料对紫外线的吸收能力;采用菌落计数法研究该涂料在可见光照射下对金黄色葡萄球菌的杀灭性能。同时分析了纳米粉体种类、引入量及方式对涂料紫外线的吸收性能和抗菌性能的影响。     

Interpretation of quasi-elastic light scattering data for flexible chains: model dependence

The autocorrelation functions and corresponding relaxation times obtained from the forward depolarized quasi-elastic light scattering experiment are exhibited for two quite similar models of flexible polymer chains in solution. A very small change in the chain dynamics is found to be sufficient to change the relaxation time from a relatively short time independent of chain length, with an autocorrelation function suggestive of an unweighted sum of contributions from all the relaxation times in the spectrum of chain motion, to a long time with an autocorrelation function identical with that for the end-to-end vector, strongly dependent upon chain length and dominated by the longest relaxation time in the spectrum. These results raise the question whether widely-used models in which information about short-range chain structure and motion is deliberately omitted can be expected to be appropriate for the interpretation of depolarized scattering experiments.     

新型光化学反应器及二氧化碳光解反应研究

研究设计了可产生波长小于200 nm真空紫外光的光化学反应器,首次利用该波段的光在该反应器中进行了CO2光解反应的研究。用氮气为发光介质对其进行光强标定,实验表明主要产生120、149、174 nm波长的光(N原子谱线);实验条件下CO2光解后生成产物CO,结果表明光源电流一定时产生CO的量与光源工作气体的压力有关,在CO2和N2反应物系中,光源内发光介质N2的压力在2 500 Pa左右时CO的产率最大,而在该反应物系中加入甲烷后,CO的产率明显增大。     

Evaporative light scattering mass detection for high-performance liquid chromatographic analysis of sucrose polyester blends in cooking oils

A high-performance liquid chromatographic method is described to determine the sucrose polyester (SPE) content in seven blends of cooking oils. Four gel-permeation chromatography (GPC) columns were used in series with an evaporative light scattering mass detector to separate the SPE from the acylglycerols in the final chromatogram. The SPE fraction was collected off the GPC column and injected onto a reverse-phase C-18 column for quantitation with sucrose octaacetate as an internal standard and a gradient of nonaqueous solvents as mobile phase. The chromatograms were interference-free, with only two sharp peaks appearing. The standards were linear from 500 to 5000 μg/mL with a correlation coefficient of r=0.999. The mean percent recovery (n=9) and standard deviation were 102±6.7. The detector could detect amounts as low as 5 μg SPE.     

Chemical properties of femoral gland secretions in the desert iguana,Dipsosaurus dorsalis

This study investigates the chemistry of femoral gland secretions in the desert iguana,Dipsosaurus dorsalis (Lacertilia: Iguanidae), and discusses their possible functional significance. Electrophoretic and proton NMR studies indicated that the secretions are composed of approximately 80 % protein and 20% lipid material. Individual differences in polyacrylamide gel banding patterns of femoral gland proteins were found. Reflectance spectroscopy revealed that the secretions strongly absorb longwave ultraviolet light, a feature that may be important in the localization of secretion deposits in the environment.     

聚偏氟乙烯/聚丙烯酸酯复合乳液的合成与性能

在含氟表面活性剂存在下，将聚偏氟乙烯超声分散于甲基丙烯酸甲酯和丙烯酸丁酯的混合单体中进行乳液聚合，制备了聚偏氟乙烯／聚丙烯酸酯复合乳液。采用动态光散射DLS、透射电镜TEM和红外光谱FT—IR对乳液组成及乳胶粒子的形态进行了表征，并对聚合物胶膜的性能进行了测试分析。结果表明：聚偏氟乙烯的加入，使复合乳液膜的拉伸强度显著增大，吸水率减小。     

原子磁强计检测光闭环稳定系统设计

SERF态原子磁强计已实现人类历史上最高的0.16fT/Hz1/2的灵敏度。其检测方法主要是法拉第调制法。但法拉第调制法中光电流摄动或环境温度变化等干扰导致的检测光强的起伏会造成检测结果的不准确。为抑制检测光强起伏,设计了闭环原子磁强计检测光稳定系统。在法拉第调制法的基础上,增加了光路子系统和控制子系统对检测光强进行闭环稳定控制。通过对随机干扰进行闭环控制仿真与实验,验证本系统可以有效抑制各种干扰引起的光强起伏,使系统抗干扰能力提高1.2%,从而提高原子磁强计的检测精度。     

基于STM32的多相LED穹形光源控制系统设计

针对工业视觉检测中对光源的照射角度、光源亮度、颜色等调节要求,设计了一种基于STM32的多相LED穹形光源控制系统,给出了系统实现方案及各模块具体实现,实现了光源参数的连续可调控制。     

A comparison of atomic force microscope friction and phase imaging for the characterization of an immiscible polystyrene/poly(methyl methacrylate) blend film

Three different forms of atomic force microscope (AFM) measurement, topography, friction force and phase imaging, have been used to investigate the surface morphology and local composition of an immiscible polystyrene (PS)/poly(methyl methacrylate) (PMMA) blend film. This sample forms discrete, micron-size domains in a continuous matrix, which is attributed to the segregation of PMMA in PS. When the samples were imaged in air, contrast in friction and phase images was caused by variations in sample topography only. When the samples were imaged under water, however, both friction and phase imaging yielded non-topographic contrast between domains. We ascribe the contrast in both of these imaging modes to preferential softening of the hydrophilic, PMMA-rich domains and to stronger tip-sample adhesive forces, highlighting the AFM's utility for probing local elastic properties and for compositional mapping of soft polymer samples.