Evaluation of a system of wind tunnels for field studies of ammonia loss from grassland through volatilisation

Rates of ammonia (NH₃) loss from a ryegrass sward measured using a system of small wind tunnels were compared with concurrent measurements made using a micrometeorological mass balance method. Measurements were made during two experiments within a circular plot (radius 10m) treated with urea at a rate of 200kgNha^?1. In the first experiment, air speed through the tunnels was adjusted as necessary to maintain a value of approximately 1ms^?1. This value differed on most occasions from the mean ambient wind speed which was measured at a height of 250mm and which ranged from 0.61 to 2.95ms^?1. Rates of loss measured using the wind tunnels differed by a factor of between two and five from those measured using the mass balance method; there was no consistent pattern in the differences between the rates of loss. The total losses of NH₃ measured during 15 days were equivalent to 49.1 and 30.2kg Nha^?1 for the mass balance and wind tunnel methods, respectively. In the second experiment, air speed through the tunnels was adjusted as necessary to maintain a value as close as possible to the mean ambient wind speed measured at a height of 250mm. Rates of NH₃ loss measured using the two methods did not differ significantly; total losses of NH₃ during 17 days were equivalent to 96.9 and 101kg Nha^?1 for the mass balance and wind tunnel methods, respectively. The difference between the findings of the two experiments could be attributed to the direct effect of air speed through the tunnels rather than to differences between ambient temperatures and those inside the tunnels. During and following periods of rain the rates of loss measured using the tunnels were up to six times greater than those observed with the mass balance method. Rates of loss measured by the two methods became similar again when the tunnels were moved following rain. The study demonstrates that enclosures can be designed and operated to provide reliable measurements of the rate of NH₃ loss from grassland. Potential applications of the two methods are discussed.     

龙开口水电站溢流坝段动力模型破坏试验研究

采用仿真混凝土材料研究了龙开口水电站溢流坝段在不同因素影响下的动力破坏特征,并通过对6个模型试验结果的分析探讨了溢流坝段的动力破坏机理。试验中考虑了坝体-库水的动力相互作用以及横河向地震动对大坝破坏的影响,采用规范谱波和场地谱波两种地震动激励进行模型超载破坏分析。试验结果为工程设计和评价溢流坝段的抗震性能提供依据。     

塔河油田特殊钻井条件下的录井技术

该文阐述了定向井、水平井和欠平衡钻井技术对传统录井方法的影响:钻时偏大、失真,岩屑细、代表性差,荧光常达12级、无意义,全烃值一般在5%以上,难以有效划分油气层;指出在特殊钻井条件下掌握设计指导思想,卡准重要层位是录井工作的关键,重点要参考组分分析数据、定量荧光分析数据和综合录井其它信息才能准确识别油气层。     

Viscoelasticity of oxidized starch/low methoxy pectin mixtures in the presence of glucose syrup

The structural properties of mixtures of pectin, oxidized starch and glucose syrup were investigated using small deformation dynamic oscillation. In the absence of added calcium, preparations of low methoxy pectin with glucose syrup formed viscous solutions, which remained crystal-free at subzero temperatures. Samples of oxidized starch and glucose syrup, on the other hand, exhibited solid-like behaviour because of the crystalline nature of the amylose-like helices. Mixtures of the two polysaccharides with the co-solute clearly showed phase inversion from liquid to solid-like behaviour with increasing amounts of starch in the formulation. The transformation was reflected in the textural properties of samples, which varied from thick solutions to firm gels. The viscoelasticity of the system was modified further by the introduction of high methoxy pectin. Preparations of high methoxy pectin and glucose syrup formed rubbery gels whose amorphous nature underwent a glass transition during cooling.     

广义物质平衡计算在凝析气藏开采动态预测中的应用

从经济的角度考虑 ,对小型凝析气藏衰竭式开采动态的预测往往不必或不值得进行数值模拟研究。常规物质平衡 (黑油 )计算方法只局限于黑油和干气藏 ,应用于凝析气藏则存在很大的误差。Walsh提出的广义物质平衡计算方法 ,可用于包括黑油、干气藏、挥发油气藏和凝析气藏在内的所有油气藏。文中将一个小型凝析气藏衰竭式开采动态的数值模拟结果与广义物质平衡计算结果进行了对比 ,结果表明 ,Walsh方法简便、应用更广泛 ,可用于规模较小、不适合进行数值模拟研究的凝析气藏的现场开发优化。     

DC-DC变换器突加负载时的动态性能研究

提出了一种能够有效改善DC-DC变换器动态性能的方案。该方案是在全桥电路基础上并联一单端正激变换电路，使变换器负载从10%轻载突加到100%满载时，其暂态过程小于1μs输出电压达到设计要求。文中对具体电路进行了详细分析，并通过仿真进行了验证。     

基于PLC电液比例控制的液力测功装置开发及其应用

本文介绍一种齿轮动态加载试验规范及技术要求，论述了运用电液比例控制技术所设计的液压加载系统原理及其使用效果，并简述由此构造的液力测功装置的原理与应用前景。     

Transient Green’s Tensor for a Layered Solid Half-Space With Different Interface Conditions

Pulsed ultrasonic techniques can be and have been used to examine the interface conditions of a bonded structure. To provide a theoretical basis for such testing techniques we model the structure as a layer on top of a half-space, both of different elastic properties, with various interface bonding conditions. The exact dynamic Green’s tensor for such a structure is explicitly derived from the three-dimensional equations of motion. The final solution is a series. Each term of the series corresponds to a successive arrival of a “generalized ray” and each is a definite line integral along a fixed path which can be easily computed numerically. Willis’ method is used in the derivation. A new scheme of automatic generation of the arrivals and ray paths using combinatorial analysis, along with the summation of the corresponding products of reflection coefficients is presented. A FORTRAN code is developed for computation of the Green’s tensor when both the source and the detector are located on the top surface. The Green’s tensor is then used to simulate displacements due to pulsed ultrasonic point sources of known time waveform. Results show that the interface bonding conditions have a great influence on the transient displacements. For example, when the interface bonding conditions vary, some of the first few head waves and regular reflected rays change polarities and amplitudes. This phenomenon can be used to infer the quality of the interface bond of materials in ultrasonic nondestructive evaluation. In addition the results are useful in the study of acoustic microscopy probes, coatings, and geo-exploration.     

动态光散射法研究海藻酸钠凝胶松弛行为

在前文的基础上，用相关函数轮廓分析的方法剖析了运动模型模式的复杂性。通过海藻酸钠水溶液在０．１ｍｏｌ／ＬＣａＣｌ２水溶液透析凝胶化过程中交联网络的松弛时间谱表明它不是单一的峰，有两上特征运动模式，并随透析向更慢的运动模式发展，这很慢的运动模式估计与区域的结构的生成有关。     

热释电系数的测量方法

描述热释电系数的两种测量方法。其一为电荷积分法，测试系统简单，测量数据准确，且能满足零电场条件下的测量。其二为动态电流法，采用调制热源技术，研究在特定温度条件下热释电材料的动态热释电响应。