通用串行总线原理及其外设接口设计

以通用串行总线(USB)1.1为基础,讨论了USB的体系结构、工作原理、通信协议和相应的核心技术,并介绍了一种基于USB接口的数字摄像系统的设计方案及其软件、固件的设计.     

基于运动的摄像机定标方法的综述

该文从运动方式角度将摄像机定标方式分为非限定运动方式和限定运动方式两大类,分别对摄像机各种运动方式对定标技术的影响进行了系统的研究,在应用中应该根据具体情况选择合适的摄像机的运动方式,以满足实际问题的需要。     

非透视3点问题的解析解

由于在机器人导航等领域新的图像装置不符合透视规则,无法运用传统的透视位置估计方法,采用吴氏零点分解方法,给出非透视3点问题的解析解.利用新图像装置的几何条件,建立了非透视3点方程系统.     

映射半解析边界元法解瞬态弹性动力问题的有关问题

提出了映射半解析边界元法解百轴对称瞬态弹性动力问题时存在解析方向不能正确反映波的传播现象的问题，产生该问题的原因和如何解决该问题的建议。     

Introduction to geothermal exploration on ascension island, South Atlantic Ocean

The exploration for a geothermal resource on Ascension Island utilized a strategy that initially employed geologic mapping. On the basis of this, subsurface faults were mapped using an aeromagnetic survey. The faults were then explored using electrical resistivity surveys to define areas of potential hydrothermal fluid up-welling. The results of all of these techniques were used to site temperature gradient holes. A deep geothermal exploration well was then drilled in the area with highest heat flow adjacent to a rhyolite-to-trachyte volcanic complex.     

A feasibility study of a direct-mapping parallel processing method to solve linear equations in load-flow calculation

With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix.     

热释电红外摄像机斩波调制电路的设计

本文提出了热释电红外摄像机斩波调制的电路模型，并对此电路模型进行了具体的电路设计和分析。     

A frame-based knowledge representation model and its mapping to nested relations

The first part of this paper introduces the basic constructs of a frame representation model and gives a formal definition for them. Subsequently the nested relational model (NF²) is described as an extension of the classical relational model to support relation-valued attributes. In the second part of this paper both models are compared with each other and a mapping of frame representation structures to NF² structures is specified. The structural similarities between frames and NF² relations are made clear and it is shown that their main difference is due to the type polymorphism introduced by the concept hierarchy of the frame model. This causes type collisions to occur in the strictly typed NF² model when frames are directly mapped to NF² structures. Two solutions to this problem are suggested and compared. The paper concludes with a reformulation of query operations of the frame model in terms of NF² algebra operations.     

Satellite SAR Remote Sensing of Great Lakes Ice Cover,Part 2. Ice Classification and Mapping

During the 1997 winter season, shipborne polarimetric backscatter measurements of Great Lakes (freshwater) ice types using the Jet Propulsion Laboratory C-band scatterometer, together with surface-based ice physical characterization measurements and environmental parameters, were acquired concurrently with Earth Resource Satellite 2 (ERS-2) and RADARSAT Synthetic Aperture Radar (SAR) data. This polarimetric data set, composed of over 20 variations of different ice types measured at incident angles from 0° to 60° for all polarizations, was processed to radar cross-section to establish a library of signatures (look-up table) for different ice types. The library is used in the computer classification of calibrated satellite SAR data. Computer analysis of ERS-2 and RADARSAT ScanSAR images of Great Lakes ice cover using a supervised classification technique indicates that different ice types in the ice cover can be identified and mapped, and that wind speed and direction can have an influence on the classification of water as ice based on single frequency, single polarization data. Once satellite SAR data are classified into ice types, the ice map provides important and necessary input for environmental protection and management, ice control and ice breaking operations, and ice forecasting and modeling efforts.     

Determining stress intensity factors of composites using crack opening displacement

The main purpose of this paper is to find the mixed-mode stress intensity factors of composite materials using the crack opening displacement (COD). First, a series solution of the composite material with a crack was used to evaluate COD values. Then, the least-squares method was used to calculate mixed-mode stress intensity factors. This algorithm can be applied to any method that generates or measures COD values. The major advantage of this method is that COD values very near the crack tip are not necessary. Both finite element simulations and laboratory experiments were applied to validate this least-squares method with acceptable accuracy if the even terms of the series solution are removed.